Alinco_DJ-S45_user.pdf
ALINCO, INC. UHF FM TRANSCEIVER DJ-S45 CQ/T/E Instruction Manual Thank you for purchasing this ALINCO FM transceiver. This instruction manual contains important safety and operating instructions. Please read it carefully before using the transceiver and be sure to keep it for future reference. 1 Contents NOTICE / Compliance Information Statement.3 Before Operating the Transceiver.5 1.Functions and Features.6 1-1Standard Accessories .6 2.Accessories.7 2-1Attaching and Detaching Accessories.7 2-1-1Antenna(only).7 2-1-2Hand Strap.7 2-1-3Belt Clip.7 2-2Setting Batteries.8 2-3Lithium Ion Battery Pack.8 2-4Battery Level Indicator .9 3.Control Functions.10 3-1Names and Operations of the Transceiver Controls .10 3-2Key Operations.12 3-3Display.14 4.Basic Operations.15 4-1Turning the Power ON.15 4-2Adjusting the Audio Volume.15 4-3Operating Modes.16 4-4LPD (VFO) Mode.16 4-4-1Frequency Setting.17 4-5PMR Mode(only).17 4-5-1Frequency Number Setting.17 4-6Memory Mode.18 4-6-1Memory Channel Programming.18 4-6-2Selecting a Memory Channel .19 4-6-3Clearing a Memory Channel Data.19 4-6-4Programmable Items to Memory Channel.20 DJ-S45 CQ DJ-S45 T/E Contents 2 4-7Receiving .20 4-7-1Adjusting Squelch Level .20 4-7-2Monitor Function.21 4-8Transmitting.21 4-8-1Switching of Transmission Output Level (only) .22 5.Parameter Setting Mode .23 5-1Selectable Parameters.23 5-2Selecting the Setting Mode.28 6.Advanced Operations.30 6-1Scanning.30 6-1-1LPD (VFO) Scan.31 6-1-2PMR Scan(only).31 6-1-3Memory Scan.32 6-1-4Skip Channel.32 6-1-5Tone Scan.33 6-2Repeater(only).33 6-3Key Lock.34 6-4Tone Call (Tone Burst).35 6-5Channel Display Mode.35 7.Selective Communicating .36 7-1LPD (VFO) Tone Squelch .36 7-2PMR Tone Squelch(only) .38 8.Cloning / Packet Operation.39 8-1Cloning.39 8-2Packet Operation(only).42 9.Maintenance and Reference.43 9-1Resetting.43 9-2Options.44 10.Specifications.45 DJ-S45 T/E DJ-S45 CQ DJ-S45 T/E DJ-S45 CQ DJ-S45 T/E Contents 3 NOTICE / Compliance Information Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Tested to Comply With FCC Standards FOR HOME OR OFFICE USE Information in this document is subject to change without notice or obligation. All brand names and trademarks are the property of their respective owners. Alinco cannot be liable for pictorial or typographical inaccuracies. Some parts, options and/or accessories are unavailable in certain areas. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. DJ-S45 T NOTICE / Compliance Information Statement 4 UHF FM Transceiver DJ-S45 T This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Manufacturer: ALINCO, Inc Electronics Division Shin-Dai Bldg 9F, 2-6, 1 Chome Dojimahama, Kita-ku, Osaka 530-0004 JAPAN Conformity Information In case the unit you have purchased is marked with a CE symbol, a copy of relative conformity certificate or document can be reviewed at Copyright 2005 All rights reserved. No part of this document may be reproduced, copied, translated or transcribed in any form or by any means without the prior written permission of Alinco. Inc., Osaka, Japan, English Edition Printed in Japan. DJ-S45 CQDJ-S45 E NOTICE / Compliance Information Statement 5 Caution The use of transceiver in the following places is prohibited. Aboard aircraft In airports In ports Within or near the operating area of business wireless stations or their relay stations. Before using the transceiver in any of the above places, obtain any necessary permission from the proper authorities, and be mindful of the local laws that govern radio operation. Points to Note for Using an External Power Supply When the power is supplied from a cigarette socket of a car, use the cigarette lighter cable (EDH-33). Turn the power off when connecting or disconnecting the DC cable. When using a commercial external antenna, install the antenna ground not to become common with the ground of the external power supply. This DC jack supports 3.06.0VDC, 2A or more external power source. Please use an appropriate, reliable power supply, and be mindful to the polarity (+ positive center). Use of non-genuine accessories will void ALINCOs factory warranty. Before Operating the Transceiver 6 1.Functions and Features 39 different Tone Squelch function (CTCSS) TOT (Time Out Timer) function Tone Call function (ALT, 1750, 2100, 1000, 1450Hz) Reception Bell (Beeper) function 3 types of Scan function (VFO, Memory, Tone) 4 types of Scan function (LPD (VFO), Memory, Tone, PMR) Cable Cloning Rain Proof 1-1 Standard Accessories Belt Clip (with a screw) Hand Strap Instruction Manual The accessory status may vary depending on the versions. Please consult with your local dealer for details. DJ-S45 CQ DJ-S45 T/E 1.Functions and Features 1 Caution Insert the rubber covers properly and firmly into the jacks of the external speaker, microphone, and power supply. Connecting optional accessories to the transceiver disables the rainproof function. The is rainproof but NOT water resistant. Therefore, NEVER rinse nor immerse it in water. DJ-S45 CQ/T/E 7 2.Accessories 2-1 Attaching and Detaching Accessories 2-1-1 Antenna(only) 1. Hold the antenna by its base and turn it clockwise until it stops. Check to be sure the antenna is securely connected. 2. Turn the antenna counter-clockwise to detach it. 2-1-2 Hand Strap 1. Attach the hand strap in the upper slot at the rear of the transceiver as shown in the illustration. 2-1-3 Belt Clip 1. Put the belt clip on the back of the transceiver. 2. Turn the screw clockwise until it stops. Check to be sure the clip is securely installed. 3. Turn the screw counter-clockwise to detach the belt clip. Belt clip Hand strap DJ-S45 T/E 2.Accessories 2 Caution The takes fixed type antenna due to a legal requirement. NEVER try to detach it. DJ-S45 CQ 8 2-2 Setting Batteries 1. Open the cover latch and then open the cover. 2. Set two commercially available AA batteries in the +/- orientation marked at the internal front side. 3. Close the cover and then fix it with the cover latch. 2-3 Lithium Ion Battery Pack EBP-60 (Option) Please refer to the instruction manual that comes with the battery pack for operating and charging procedures. Cover latch Cover 2.Accessories 2 Caution Manganese batteries are not recommended as they may decrease the transmission output level. Be sure to observe proper orientation of the batteries polarity (+/-). Latest generation dry cells such as Oxiride batteries can be used. Ni-MH rechargeable cells are also usable. Please carefully read instructions of its manufacturer to properly use them. Regardless of the type of battery you use, please: 1.Never mix the type, brand, or different status of use. 2.Never remove protective materials around cells. 3.Clean the contacts with a dry cloth once in a while to obtain best performance. 4.Respect all the instructions given by battery manufacturer for safe and proper use. 9 2-4 Battery Level Indicator Battery consumption level may change depending on the surrounding temperature or the frequency of use. Even if the battery icon appears to indicate the necessity of charging the battery, it can be used further if the usage is only for low output transmission or reception. The default setting of the battery pack type is bAt-1 which is for AA type cells. When using Lithium Ion battery pack, select the battery type setting to bAt-2 in the Setting mode (page 26, ITEM No.16) to correctly indicate the battery level icon. Reference : Due to the amplification circuitry used in this unit to obtain high output with only 2 batteries, it may happen that the unit cannot be turned on when the battery voltage is getting low (while the low-battery icon is on the display), but not completely discharged yet. This is not a defect but we recommend that: When the low-battery icon appears, recharge or replace the batteries. When the low-battery icon appears, try not to turn off the radio until fully use up the battery power. When they are completely discharged the display will turn off. *When the battery level becomes low, the battery icon appears. Charge or replace the battery. Battery icon 2.Accessories 2 10 3.Control Functions 3-1 Names and Operations of the Transceiver Controls Top and Front Views No. Name Power/Volume Dial MIC Connector SP Connector RX/TX Lamp Speaker F key Display (LCD) Keypad Microphone Functions Switches power ON/OFF, and also adjusts the audio volume. For connection of the optional external microphone (2k ) with 2.5 stereo plug. For connection of the optional external speaker(8 ) with 3.5 monophonic plug. Illuminates green when the squelch opens and red when transmitting. A thin speaker is built in. Use this key in combination with other keys to access various functions of the transceiver. Holding this key for 2 seconds activates the Setting mode where various settings are possible. Refer to Display in this manual (page 14). Refer to Key Operations (page 12). Speak into microphone from a distance of approx. 5cm at normal tone of voice. 3.Control Functions 3 11 Side Views No. Name SMA Antenna Connector PTT (press to talk) key MONI key DC-IN Functions Undetachable fixed type antenna. Install the included antenna. Choose an antenna which has low SWR (standing Wave Ratio) if you purchase one. While this key is held down, the transceiver transmits. When the key is released, the transceiver returns to the receive mode. When this key is pressed, the squelch opens and you can hear received signals. The squelch also opens when the tone squelch is set. If this key is pressed while F appears, the Key Lock function is activated. Pressing this key, while the PTT key is pressed and held, transmits the tone call signal. Terminal for connecting an external power supply. Connect the optional cigarette lighter cable EDH-33 for mobile operation. Use a stable power supply with 3.06.0VDC, with a capacity of 2A or more. DJ-S45 CQ DJ-S45 T/E Antenna sideDial side 3.Control Functions 3 12 3-2 Key Operations No. Name PTT MONI F/SET /T SQL V/M / MW /RPT Independent operation Transmits or completes the setting in the Setting mode. Activates the monitoring function. Accesses Various functions. Decreases the frequency and memory channels. Switches VFO/Memory modes. Switches LPD (VFO)/PMR/ Memory modes. Increases the frequency and memory channels. DJ-S45 CQ DJ-S45 T/E After pressing F key Switches the key lock ON/OFF (page 3
