Yaesu_FTH-2006_programming.pdf

PROGRAMMING YAESU FTH-2006 Programming this rig needs only a small screwdriver and some skill, no computer or interface cords are needed. Normally this rig display only a channel number CH 0 to CH 9 if all memories where programmed. You cant modify the frequency with the 4 keyboards keys. But there are some (4) hidden keys somewhere to achieve this. A) Right of the display, remove the keyboard plastic cover with a small screwdriver or a knife (its glued) and you will see 4 additional keys on the keyboard just under the originals. B) Those keys are like this: 1) Power on the rig 2) Change display from channel to frequency by pressing once the hidden Channel/Frequency key. 3) Adjust to the desired frequency using the big upper right knob or Scan + or Scan keys (You can obtain a 1 MHz step depressing the Function key before turning the knob or Scan + or Scan keys. 4) From the frequency display, press the Function key (a small F is displayed) and quickly press the Channel/Frequency key, a small blinking memory number will appear in the upper left corner of the display, change the memory number using the big upper right knob or Scan + or Scan keys and press again the Channel/Frequency key to store the memory. 5) Back to channel display mode using the Channel/Frequency key, the desired frequency is stored in the chosen memory. To use a shift (repeater operation), press the Channel/Frequency key and power on the rig, the display shows .000, rotate the big upper right knob to change to the desired value, then the Function key (small F in display) and the Priority key to display a + or - CTCSS Under the Light key there is the key for the CTCSS First press will enable CTCSS at transmit (enc displayed). Second press of the key will enable CTCSS at receive (dec displayed) Third press of the key will disable both. Pressing the Function key and then the CTCSS key you can adjust the CTCSS frequency. In fact, programming this rig is exactly like the well-known FT-23R except for some functions Some other adjustments are inside the box (solder pads) (Do it at your own risks!) Default setup is: Solder pads 1 open 2 shorted 3 open 4 shorted 5 shorted 6 open 7 open 8 open 9 open 10 shorted Frequency step is solder pad #4: open = 5 KHz step, shorted = 12.5 KHz step. (May needs replacing some components) Battery saver is solder pad #6: open = on, shorted = off Channel / frequency display is solder pad #7: open = channel, shorted = frequency Busy channel lock out is solder pad #8: open = off, shorted = on Busy tone lock out is solder pad #9: open = off, shorted = on Behind PTT rubber cover you will find a switch for testing/clone mode Thats all Enjoy F6BXM