Hameg hm8035 电路图.pdf

Instruments HM8035 FRANAIS MANUALHANDBUCHMANUEL RadioFans.CN 收音机爱 好者资料库 General information regarding the CE marking HAMEG instruments fulfill the regulations of the EMC directive. The conformity test made by HAMEG is based on the actual generic- and product standards. In cases where different limit values are applicable, HAMEG applies the severer standard. For emission the limits for residential, commercial and light industry are applied. Regarding the immunity (susceptibility) the limits for industrial environment have been used. The measuring- and data lines of the instrument have much influence on emmission and immunity and therefore on meeting the acceptance limits. For different applications the lines and/or cables used may be different. For measurement operation the following hints and conditions regarding emission and immunity should be observed: 1. Data cables For the connection between instruments resp. their interfaces and external devices, (computer, printer etc.) sufficiently screened cables must be used. Without a special instruction in the manual for a reduced cable length, the maximum cable length of a dataline must be less than 3 meters long. If an interface has several connectors only one connector must have a connection to a cable. Basically interconnections must have a double screening. For IEEE-bus purposes the double screened cables HZ72S and HZ72L from HAMEG are suitable. 2. Signal cables Basically test leads for signal interconnection between test point and instrument should be as short as possible. Without instruction in the manual for a shorter length, signal lines must be less than 3 meters long. Signal lines must screened (coaxial cable - RG58/U). A proper ground connection is required. In combination with signal generators double screened cables (RG223/U, RG214/U) must be used. 3. Influence on measuring instruments. Under the presence of strong high frequency electric or magnetic fields, even with careful setup of the measuring equipment an influence of such signals is unavoidable. This will not cause damage or put the instrument out of operation. Small deviations of the measuring value (reading) exceeding the instruments specifications may result from such conditions in individual cases. December 1995 HAMEG GmbH RadioFans.CN 收音机爱 好者资料库 KONFORMITTSERKLRUNG DECLARATION OF CONFORMITY DECLARATION DE CONFORMITE Name und Adresse des HerstellersHAMEG GmbH Manufacturers name and addressKelsterbacherstrae 15-19 Nom et adresse du fabricantD - 60528 Frankfurt HAMEG S.a.r.l. 5, av de la Rpublique F - 94800 Villejuif Die HAMEG GmbH / HAMEG S.a.r.l bescheinigt die Konformitt fr das Produkt The HAMEG GmbH / HAMEG S.a.r.l herewith declares conformity of the product HAMEG GmbH / HAMEG S.a.r.l dclare la conformite du produit Bezeichnung / Product name / Designation: Typ / Type / Type: mit / with / avec: Optionen / Options / Options: mit den folgenden Bestimmungen / with applicable regulations / avec les directives suivantes EMV Richtlinie 89/336/EWG ergnzt durch 91/263/EWG, 92/31/EWG EMC Directive 89/336/EEC amended by 91/263/EWG, 92/31/EEC Directive EMC 89/336/CEE amende par 91/263/EWG, 92/31/CEE Niederspannungsrichtlinie 73/23/EWG ergnzt durch 93/68/EWG Low-Voltage Equipment Directive 73/23/EEC amended by 93/68/EEC Directive des equipements basse tension 73/23/CEE amende par 93/68/CEE Angewendete harmonisierte Normen / Harmonized standards applied / Normes harmonises utilises Sicherheit / Safety / Scurit EN 61010-1: 1993 / IEC (CEI) 1010-1: 1990 A 1: 1992 / VDE 0411: 1994 berspannungskategorie / Overvoltage category / Catgorie de surtension: II Verschmutzungsgrad / Degree of pollution / Degr de pollution: 2 Elektromagnetische Vertrglichkeit / Electromagnetic compatibility / Compatibilit lectromagntique EN 50082-2: 1995 / VDE 0839 T82-2 ENV 50140: 1993 / IEC (CEI) 1004-4-3: 1995 / VDE 0847 T3 ENV 50141: 1993 / IEC (CEI) 1000-4-6 / VDE 0843 / 6 EN 61000-4-2: 1995 / IEC (CEI) 1000-4-2: 1995 / VDE 0847 T4-2:Prfschrfe / Level / Niveau = 2 EN 61000-4-4: 1995 / IEC (CEI) 1000-4-4: 1995 / VDE 0847 T4-4:Prfschrfe / Level / Niveau = 3 EN 50081-1: 1992 / EN 55011: 1991 / CISPR11: 1991 / VDE0875 T11: 1992 Gruppe / group / groupe = 1, Klasse / Class / Classe = B Datum /Date /DateUnterschrift / Signature /Signatur E. Baumgartner Technical Manager Directeur Technique Instruments HM8035 20.09.1995 HM8001-2 L-C Meter / LC-METRE / Medidor LC - RadioFans.CN 收音机爱 好者资料库 Hongkong HAMEG LTD Flat B, 7/F, Wing Hing Ind. Bldg., 499 Castle Peak Road, Lai Chi Kok, Kowloon Phone(852)2 793 0218 Telefax(852)2 763 5236 E-mail: United States of America HAMEG, Inc. 266 East Meadow Avenue EAST MEADOW, NY 11554 Phone(516)7944080 Toll-free(800)2471241 Telefax(516)7941855 E-mail: Great Britain HAMEG LTD 74-78 Collingdon Street LUTON Bedfordshire LU1 1RX Phone(01582)413174 Telefax(01582)456416 E-mail: saleshameg.co.uk Spain HAMEG S.L. Villarroel 172-174 08036 BARCELONA Telf.(93)4301597 Telefax(93)321220 E-mail: emailhameg.es France HAMEG S.a.r.l 5-9, av. de la Rpublique 94800-VILLEJUIF Tl.(1)4677 8151 Telefax(1)4726 3544 E-mail: hamegcommagic.fr Germany HAMEG Service Kelsterbacher Str. 15-19 60528 FRANKFURT am Main Tel. (069) 67805 - 24 -15 Telefax (069) 67805 - 31 E-mail: servicehameg.de HAMEG GmbH Industriestrae 6 63533 Mainhausen Tel. (06182)8909 - 0 Telefax (06182) 8909 - 30 E-mail: saleshameg.de Instruments Oscilloscopes Multimeters Counters Frequency Synthesizers Generators R- and LC-Meters Spectrum Analyzers Power Supplies Curve Tracers Time Standards Printed in Germany 44 - 8035 - 0040