Philips-ACT-500-Service-Manual(1) 电路图 维修手册.pdf

Technical specification .1-1 Features .1-1 Accessories .1-1 Instruction For Use.1-2.1-6 Safety 6 ! off/resume/holdoff/resume/hold 2 1 2 3 4 5 6 7 8 9 10 11 12 13 1 QUICK STARTMISE EN SERVICE RAPIDE englishcontrols supplied accessories 1 x headphones, HJ050 1 x remote control, AY3781 1 x AC/DC adapter, AY3170 2 x rechargeable batteries, AY3363 1 x hand strap / waist pack, AY3293 controls ( see fi gure 1 ) 1 mode.selects the different playing possibilities: shuffl e, shuffl e repeat, repeat and 2 eq.switches the bass enhancement on and off. this button also switches acoustic feedback (the beep) on/off when it is pressed for more than 2 seconds 3 esp .toggle to select between the battery powersave mode and electronic skip protection (esp). esp ensures continuous cd playback regardless of vibrations and shocks 4 p.3.5 mm headphone socket, socket to connect the player to another audio input of an additional appliance, remote control socket 5 +/+/ . adjusts the volume 6 5 .skips and searches cd tracks backwards 7 indicator.lights up : red (battery low / power down) , green (power up), orange (pause mode) 8 2;.switches the player on, starts or pauses cd play 9 9.stops cd play, switches the player off 0 6 .skips and searches cd tracks forwards ! DC.socket for external power supply 2 1 1 2 2 3 3 4 4 5 5 5 5 4 4 6 6 INSTRUCTION FOR UES RadioFans.CN 收音机爱 好者资料库 1-3 controls / accessories controls ( see fi gure 1 ) off.switches resume and hold off resume.stores the last position of a cd track played hold .locks all buttons #.opens the cd lids remote control AY3781 ( see fi gure 2 ) 1 p.3.5 mm headphone plug to connect to headphones socket 2 hold .locks all buttons 3 stop.stops playback and switches the set off 45 / 6.skips and searches forward / backward tracks 5 +/ +/ .adjusts the volume 6 2;.switches the set on, starts playback and interrupts playback connecting the remote control use only the AY 3781 remote control. 1press 9 on the set twice to switch off the set. 2 fi rmly connect the remote control to p on the set. 3 fi rmly connect the headphones to the plug on the remote control. 4on the remote control keep 2; pressed for 1 second to switch on the set and to start playback. 5adjust the volume and sound on the psa and your remote control. clip magnets wear your remote control and secure your headphone cord with these wearable magnets. 1 check the polarity of the 2 button magnets. insert the big button magnet underneath your garment. 2 clip the small button magnet on your outer garment. clip the remote control on top. 3 secure your headphone cord with the butterfl y magnet clip. WARNING: KEEP OUT OF REACH OF SMALL CHILDREN TO AVOID CHOKING HAZARD. KEEP THE MAGNETS AWAY FROM CREDIT CARDS, TAPES AND ANY ITEMS, WHICH MAY BE SENSITIVE TO THE MAGNETS. USERS OF PACEMAKERS OR OTHER IMPLANTED DEVICES SHOULD CONSULT THEIR PHYSICIAN BEFORE USING MAGNETS OR DEVICES THAT MAY GENERATE ELECTRO-MAGNETIC INTERFERENCE. accessories / power supply hand strap / waist pack AY3293 wear your cd player during sport activity by securing it to the supplied hand strap / waist pack. 1 open the strap enclosure on the back of the hand strap / waist pack and slide the cd player inside. make sure the headphone / remote socket is aligned to the socket hole. 2 thread the strap. 3 position your hand and adjust the strap until the fi t is snug and comfortable. batteries (supplied or optionally available) you can use the following batteries with this cd-player: alkaline batteries type AAA (LR03, UM4) or rechargeable ECO-PLUS NiMH battery. notes:old and new or different types of batteries should not be combined. remove batteries if they are empty or if the player is not going to be used for a long time. inserting batteries 1push to open the cd door 2open the cd compartment and insert 2 x AAA batteries. battery indication the approximate power level of your batteries is shown in the display.(on remote control) battery full battery two-thirds full battery one-third full battery dead or empty. when the batteries are dead or empty, the symbol fl ashes, is displayed, and the beep tone sounds repeatedly. indicator lights up orange and beeps briefl y. indicator then turns red before player switches off. average playing time of batteries under normal conditions battery typeesp + power save normal AAA3 hours alkaline AAA12 hours rechargeable ECO-PLUS NiMH battery10 hours batteries contain chemical substances, so they should be disposed of properly. caution use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. this set complies with the radio interference requirements of the European Community. the model and serial numbers are located inside the cd door. INSTRUCTION FOR USE 1-4 power supply / general information ECO-PLUS NiMH battery information (for versions supplied with the rechargeable ECO-PLUS NiMH battery AY 3363) recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3363. recharging the ECO-PLUS NiMH battery on board 1insert the rechargeable ECO-PLUS NiMH battery AY 3363. 2connect the mains adapter to the DC socket of the player and then to the wall socket. yis pulsing. recharging stops after a maximum of 7 hours, or when you start playback. 3when the battery is fully recharged, appears in the display. notes: it is normal for the batteries to become warm during recharging. if the batteries become too warm, recharging will be interrupted for approximately 30 minutes andis displayed. to ensure proper recharging on board, take care that contacts are clean. use only the ECO-PLUS NiMH battery AY 3363. handling instructions recharging already charged or half-charged batteries will shorten their lifetime. we therefore recommend that you let the rechargeable ECO-PLUS NiMH battery run till it is completely empty before you recharge it. to avoid a short circuit, do not let the battery touch any metal object. if the battery becomes empty soon after recharging, then either its contacts are dirty or it has reached the end of its lifetime. mains adapter (supplied or optionally available) use only the AY 3170 power adapter supplied with your product (4.5 V / 300 mA direct current, positive pole to the centre pin). any other product may damage the player. 1make sure the local voltage corresponds to the adapters voltage. 2connect the adapter to the DC socket of the player and to the wall socket. note: always disconnect the adapter when you are not using it. environmental information all redundant packing material has been omitted. we have done our utmost to make the packaging easily separable into two mono materials: cardboard and polyethylene. your set consists of materials which can be recycled if disassembled by a specialized company. please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment. headphones HJ050 connect the supplied headphones to the p socket of the player. note:pcan also be used for connecting this set to your hifi i system to adjust the sound and volume, use the controls on the connected audio equipment and on the cd player. take care when using headphones hearing safety: listen at a moderate volume. using headphones at high volume can impair your hearing. traffi c safety: do not use headphones while driving or cycling as you may cause an accident. general information / cd play cd player and cd handling do not touch the lens A of the cd player. do not expose the unit, batteries or cds to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). you can clean the cd player with a soft, slightly dampened, lint-free cloth. do not use any cleaning agents as they may have a corrosive effect. to clean the cd, wipe it in a straight line from the center toward the edge using a soft, lint-free cloth. a cleaning agent may damage the disc! never write on a cd or attach a sticker to it. the lens may cloud over when the unit is moved suddenly from cold to warm surroundings. playing a cd is not possible then. leave the cd player in a warm environment until the moisture has evaporated. active mobile phones in the vicinity of the cd player may cause malfunctions. avoid dropping the unit as this may cause damage. in-car use (connections supplied or optionally available) only use the AY 3545 or AY 3548 car voltage converter (4.5 V DC, positive pole to the centre pin) and the AY 3501 car cassette adapter. any other product may damage the set. 1put the set on a horizontal, vibration-free and stable surface. make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. 2plug the voltage converter into the cigarette lighter socket (only for 12 V car battery, negative grounding), then connect the wired end with 4.5V DC input socket on the set. 3if necessary, clean the cigarette lighter socket to obtain a good electrical contact. 4turn down the volume and connect the cassette adapter plug to p on the set. 5carefully insert the cassette adapter into the car radios cassette compartment. 6make sure the cord does not hinder your driving. 7decrease the volume on the set if necessary. start playback on the set and adjust the sound with the car radio controls. always remove the voltage converter from the cigarette lighter socket when the set is not in use. notes: if your car radio has a LINE IN socket, it is better to use it for the car radio connection instead of the cassette adapter. connect the signal lead to this LINE IN socket and to p on the set. 4,5 V DC 12 V DC INSTRUCTION FOR USE 1-5 cd play / features playing a cd this cd-player can play all kinds of audio discs such as cd-recordables and cd-rewritables. do not try to play a cd-rom, CDi, VCD, DVD or computer cd. 1push the slider to open the player. 2insert an audio cd, printed side up, by pressing the cd onto the hub. 3close the player by pressing the lid down. 4press 2; to switch the player on and start playback. ythe current track number and elapsed playing time are displayed. indicator lights up green. you can pause playback by pressing 2;. ythe time at which playback was paused starts fl ashing. indicator turns orange and fl ashes. you can continue playback by pressing 2; again. 5press 9 to stop playback. ythe total number of tracks and the total playing time of the cd are displayed. 6press 9 again to switch the player off. indicator lights up red and gradually turns off. to remove the cd, hold it by its edge and press the hub gently while lifting the cd. note: if there is no activity, the set will automatically switch off after a while to save energy. playback information if a cd-recordable (CD-R) or a cd-rewritable (CD-RW) is not recorded properly,is displayed, indicating that the cd has not been fi nalized. in that case, use FINALIZE on your cd recorder to complete the recording. when playing a cd-rewritable (CD-RW), please note that it takes 315 seconds after pressing 2; for sound reproduction to start. playback will stop if you open the cd lid. while the cd is read, 1 -:- fl ashes in the display. volume and bass volume adjustment adjust the volume by using +/ (+/ (vol). bass adjustment press eq (on the set only) to switch the bass enhancement on or off ydbb is shown if the bass enhancement is activated. features selecting a track and searching selecting a track during playback briefl y press 5 or 6 once or several times to skip to the current, previous or next track. yplayback continues with the selected track, and the tracks number is displayed. selecting a track when playback is stopped 1 briefl y press 5 or 6 once or several times to select the desired track. the track number is displayed. 2press 2; to start cd play. yplayback starts with the selected track. searching for a passage during playback 1 keep 5 or 6 pressed to fi nd a particular passage in a backward or forward direction. ysearching starts while playback continues at low volume. after 2 seconds the search speeds up. 2release the button when you reach the desired passage. yplayback continues from this position. notes: if the player is in mode (see mode chapter), searching is not possible. in shuffl e, shuffl e repeat or repeat mode (see mode chapter), searching is only possible within the particular track. selecting different playing possibilities-mode it is possible to play tracks in random order, to repeat a single track or the entire cd, and to play the fi rst few seconds of each track. 1press mode during playback as often as required in order to activate one of the following modes. the active mode is shown in the display. yshuffl e : all tracks of the cd are played in random order until all of them have been played once. yshuffl e repeat: all tracks of the cd are played repeatedly in random order. yrepeat: the entire cd is played repeatedly. y : the fi rst 10 seconds of each of the remaining tracks are played in sequence. 2 playback starts in the chosen mode after 2 seconds. to return to normal playback, press mode repeatedly until the display shows no active modes. INSTRUCTION FOR USE 1-6 resume and hold you can interrupt playback and continue (even after an extended period of time) from the position where playback stopped (resume) and you can lock all buttons of the set so that no action will be executed (hold). use the offresumehold slider for these functions. resume continuing from where you have stopped 1switch the slider to resume during playback to activate resume. yresume is shown. 2press 9 whenever you want to stop playback. 3press 2;whenever you want to resume playback. yresume is shown and playback continues from where you have stopped. to deactivate resume, switch the slider to off. yresume goes off. hold locking all buttons you can lock the buttons of the set by switching the slider to hold. now, when a key is pressed, no action will be executed. this is of use, for example, when transporting the player in a bag. with hold activated, you can avoid accidental activation of other functions. 1switch the slider to hold (or switch hold on the remote control) to activate hold. yall buttons are lockedis shown when you press any button. indicator tu