T-599_user.pdf

《T-599_user.pdf》由会员分享，可在线阅读，更多相关《T-599_user.pdf（23页珍藏版）》请在收音机爱好者资料库上搜索。

1、 Kenwood_T-599_bulletin.txt Service bulletin no. 7 (2-11-1977) No ALC - Drive 10 meters: Check for loose contact at oscillator wafer on coil pack. No TX any band: Check the T1 on generator board (X52-0009-00). No TX: Bad driver FET Q1 3SK22(GR) on X47-0004-00). No relay action when TX: Bad Q8 2SA562

2、(Y). When replacing Q8 change resistor R16 to 4.7 ohm. Rubber belt sliping on drive and load: TKC has Chain Modification Kit. No drive when shock: Check for loose output terminals af final rotary switch (S10-1002-05). No output on any band: Check T2 GEN unit (X42-0009-00). No TX: Check final relay f

3、or burned contacts. (S51-4017-15). Bias current too high and blows fuse: Check for bad 6-7001A and shorted cathode resistors 10 ohm. Cannot neutralize: Make sure shield is properly installed on driver 12BY7. No output from generator unit (X52-0009-00): Bad Q4 TA7045. No 9 Volt out at AVR (X43-0010-0

4、0): CHeck Q1 2SA606(L). Low output power: If American 12BY7 is used in driver circuit, this can cause parasitic oscillation. Please use standard Kenwood replacement tubes. Blows fuse: Check for shorted electrlytics at power supply (X43-0011-00). AC hum on SSB transmission: Send for TKC bulletin. 1agina p