TKR-750_TKR-751_TKR-850_TKR-851_function_reference.pdf

《TKR-750_TKR-751_TKR-850_TKR-851_function_reference.pdf》由会员分享，可在线阅读，更多相关《TKR-750_TKR-751_TKR-850_TKR-851_function_reference.pdf（75页珍藏版）》请在收音机爱好者资料库上搜索。

1、Version:1.01 USA Last Updated:Sep, 2005 Language:English Type:K Function Reference (FUNC) For T T T TK KK KR R R R- - - -7 7 7 75 5 5 50 0 0 0/ / / /8 8 8 85 5 5 50 0 0 0 V V V Ve e e er r r rs s s si i i io o o on n n n2 2 2 2 T T T TK KK KR R R R- - - -7 7 7 75 5 5 51 1 1 1/ / / /8 8 8 85 5 5 51 1

2、 1 1 About Copyright All copyrights and other intellectual property rights for this technical document and relevant in-depth manuals as well as the software described in this technical document, relevant in-depth manuals, and help texts and manuals attached to the software are owned by Kenwood Corpo

3、ration. A right to use the software described in this technical document and relevant in-depth manuals is granted to a licensee by Kenwood Corporation; however, the title to and ownership of the software shall be owned by Kenwood Corporation. Refer to the help texts attached to this software for det

4、ails. Kenwood Corporation does not warrant quality and performance of the software described in this technical document and relevant in-depth manuals to conform to the applicability of any use, and Kenwood Corporation shall be free from liability for any defects, damage or loss, or from any warranty

5、 to anything other than expressly described in this technical document and relevant in-depth manuals. Revision history DateDescription Sep. 2005K-USA R&D modify Version: 1.01 USA Function Reference (FUNC) I CONTENTS 1 BASIC OPERATION .1 1.1Functions and Panel Layout . 1 1.2TX/RX Frequency . 2 1.3Tra

6、nsmit output power . 3 1.4Bandwidth . 3 1.5Mode . 3 1.6Display . 4 1.6.17-segment LED . 4 1.6.2TX LED . 5 1.6.3BUSY LED . 5 1.6.4POWER LED . 5 1.6.5PF1 to PF6 keys LED . 5 1.7Operation . 6 1.7.1Turning ON/OFF . 6 1.7.2Adjusting Volume Level . 6 1.7.3PF keys . 6 1.8Squelch Level . 6 2 PASSWORD .7 2.1

7、Data Password . 7 3 EMBEDDED MESSAGE .8 3.1Embedded Message . 8 3.2Embedded Message w/Password . 8 4 CHANNEL INFORMATION .9 4.1Reception Frequency . 9 4.2Transmission Frequency . 9 4.3QT/DQT Decode . 9 4.4QT/DQT Encode . 9 4.5Channel Name . 10 4.6Wide/ Narrow . 10 4.7Encode Tone in Multiple . 10 4.8

8、Operation Mode . 12 4.9Beat Shift . 12 4.10 TX High Power . 12 4.11 QT Reverse Burst . 12 4.12 Scan Add . 13 4.13 Compander . 13 4.14 Voice Scrambler . 13 4.14.1Scrambler Code . 13 4.14.2Scrambler Backup . 14 4.15 CW ID . 14 5 QT/DQT .15 5.1QT/DQT . 15 5.2DQT Turn-off Code . 15 5.3QT Reverse Burst .

9、 15 5.4QT Decode Delay . 15 5.5Off-hook Decode . 16 6 PTT OPERATION .17 6.1Time-out Timer (TOT) . 17 6.2TOT Pre-alert . 17 6.3TOT Rekey Time . 17 6.4TOT Reset Time . 18 6.5Repeat Hold Time . 18 6.6Busy Channel Lockout . 18 6.7PTT Priority . 18 7 TOT (TIME OUT TIMER) .19 7.1Repeater PTT or the Extern

10、al PTT . 19 7.2Using the Local Mic PTT . 19 8 BUSY CHANNEL LOCKOUT .21 9 TONE .22 9.1Beep Tone . 22 9.1.1Power-on Tone . 22 9.1.2Control Tone . 22 9.1.3Warning Tone . 22 9.2Information Tone . 23 9.2.1Courtesy Tone . 23 9.2.2Backup Battery Tone . 23 10 POWER CONTROL .24 10.1 Backup Battery System . 2

11、5 10.2 Power Supply Lower Level . 26 10.3 RX Signal Detect (Below) . 26 10.4 DC Power Save . 26 10.4.1Save Delay Timer A . 26 10.4.2Save Delay Timer B . 26 10.4.3Save Mode Duration . 26 10.4.4Save On . 27 10.4.5Save Off . 27 10.5 Start Up . 27 10.6 Backup Power . 27 10.7 Main Power . 27 11 EXTERNAL

12、MONITOR .28 12 FAN ACTION .29 13 TX STANDBY ON FREQUENCY .30 CONTENTS II Function Reference (FUNC) Version: 1.01 USA 14 FIRMWARE PROGRAMMING MODE SETTING .31 15 KEY ASSIGNMENT .32 15.1 Available Functions .32 16 SCAN .34 16.1 Priority Scan .34 16.2 Priority Channel .34 16.3 Look Back Time A .34 16.4

13、 Look Back Time B .35 16.5 Revert Channel .35 16.6 Dropout Delay Time .36 16.7 Dwell Time .36 16.8 Off-hook Scan .36 17 DTMF .37 17.1 DTMF Speed .37 17.2 First Digit Delay Time .37 17.3 First Digit Time .37 17.4 * and # Digit .37 17.5 Encode .37 17.6 Decode .38 17.7 Frequency .38 17.8 Period .38 17.

14、9 Side Tone .38 18 REMOTE CONTROL .39 18.1 Control PF keys .39 18.1.1PF Key Activation .39 18.1.2PF Key Deactivation .39 18.1.3PF Key Transponder .40 18.1.4Single Tone for the PF Key Transponder .40 18.2 Control the Auxiliary Ports .40 18.2.1Aux Input Activation .40 18.2.2Aux Input Deactivation .40

15、18.2.3Aux Output Activation .41 18.2.4Aux Output Deactivation .41 18.2.5Aux In/Out Transpond .41 18.2.6Single Tone for the Aux Transponder function . 41 18.3 Remote Access with QT/DQT .42 18.4 Clear to Transpond .42 19 TRANSPOND .43 19.1 Remote Controlled .43 20 FUNCTION PORT .44 20.1 AUX I/O Functi

16、on .45 20.2 AUXI Function .46 20.2.1Trigger Detection for Auxiliary Input Ports .50 20.3 Assigning Functions to the Auxiliary Output Ports 50 20.3.1Logic Type .51 21 MULTI-TABLE .52 22 CW ID/CW MESSAGE .53 22.1 CW ID .53 22.1.1CW ID .53 22.1.2TX Interval Time .53 22.1.3TX Delay Time .54 22.1.4CW Spe

17、ed (CW ID) .54 22.1.5CW Mod. Delay Time (CW ID) .54 22.1.6Audio Frequency (CW ID) .54 22.1.7TX Required in Interval .54 22.1.8CW ID Override .54 22.1.9Send CW ID to RA .54 22.1.10 CW ID on Channel change .54 22.1.11 Encode with QT/DQT (CW ID) .55 22.2 CW Message .55 22.2.1CW Message .55 22.2.2CW Spe

18、ed (CW Message) .56 22.2.3CW Mod. Delay Time (CW Message) .56 22.2.4Audio Frequency (CW Message) .56 22.2.5Send CW Message to RA .56 22.2.6Encode with QT/DQT (CW Message) .56 23 TEST TONE .57 24 PC MODE .58 24.1 PC Programming Mode .58 24.2 PC Test Mode .58 24.2.1Test Signalling .58 24.2.2Test Frequ

19、ency .59 24.2.3PC Tuning Mode .60 25 PROGRAM .62 26 BACKUP .63 Version: 1.01 USA Function Reference (FUNC)I About this manual This manual describes the functions of the TKR-750/850 version2 and TKR-751/851 and how to configure these functions. How to read this manual This manual has the following se

20、ctions. In each section, each function has the reference data in order to find the cross-referenced information. As for the functions that you can configure using KPG-91D, you can see the refer- ence data since it is described as ( Configuration on the KPG-91D). The abbreviation of sections are used

21、 to specify the docu- ments. Function Reference (FUNC) This section describes every function. Field Programming Reference (FPRG) This section describes how to configure using KPG-91D. Modification Information (MOD) This section describes how to modify the hardware. About notations Following are nota

22、tions used in this manual. The characters in parentheses indicate the name of the operating portion of the TKR-750/850 version2 and the key of the PC. “ The characters in these marks indicate the name of the functions, buttons, and menus displayed on the display of KPG-91D. About trademark IBM is a

23、trademark or a registered trademark of Interna- tional Business Machines Corporation. Microsoft and Windows are trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries. Other company names and product names are trade- marks or registered trademarks of

24、 the companies. Description of the TKR-50 Series ! ! About the TKR-50 Series The TKR-750/850/751/851 is the rack-mounted repeater operating with the UHF/VHF band and it can be controlled by external devices and the Air Remote. You can build the most advanced communications system by using the monito

25、ring function and the remote control function. ! ! Features of the TKR-750/850 version 2 and 751/851 Field Programing by KPG-91D. 16 channel capability. Firmware update into flash memory through the exter- nal source. QT/DQT signalling on each channel and decode up to 16 QT/DQT tones. DSP is process

26、ing audio frequency response. Time Out Timer limiting duration to make a continuous transmission. The Priority Scan allows you to configure the channels to be periodically scanned. CW ID function, you can configure the speed, trans- mission interval, and the frequency on each channel. Remote control

27、 by connecting the Remote Controller. Detect the malfunctions and report the status from the AUX terminal. External terminal for connecting the external controller to make Trunking systems. TKR-750/850 version2 has DTMF Air Remote func- tion. Courtesy Tone notifying that is transmitted at end of the

28、 transmission. Multi-mode. TKR-750/751 Wide:30/25 kHz Narrow:15/12.5 kHz TKR-850/851 Wide:25 Narrow:12.5 kHz You can configure following items through the PC using the KPG-91D. CW ID Deviation DQT Deviation Maximum Deviation QT Deviation Repeat Gain Level TX Power RX Audio Signal Output (RA) RX Detector Signal Output (RD) Test Tone Deviation TX Audio Input (TA) DTMF Deviation Battery Operation Tone II Function Reference (FUNC) Version: 1.01 USA Battery Warning Tone Courtesy Tone Squelch Frequency DQT Balance Power Down Detect ! ! About the TKR-*50 Series Programming Softwar