RCA-Victor-Co-Inc-1RH10 电路原理图.pdf
《RCA-Victor-Co-Inc-1RH10 电路原理图.pdf》由会员分享,可在线阅读,更多相关《RCA-Victor-Co-Inc-1RH10 电路原理图.pdf(1页珍藏版)》请在收音机爱好者资料库上搜索。
1、VOLUME R-22, MOST-OFTEN-NEEDED 1962 RADIO SERVICING INFORMATION RCA VICTOR Models l-RH-10, 1-RH-ll, l-RH-12, l-RH-13, 1-TP-1E, HE, JE (Late Prod.) Model l-RJ-19 Chassis No. RC-1199D Q2 2N4I0 1ST I F AMPL 03 2N4IO 2ND I F AMPL CHASSIS REMOVAL 1. Unsolder the battery spring contacts from the circuit b
2、oard. DO NOT ATTEMPT TO REMOVE CONTACTS FROM CASE. The battery contacts are heat sealed to the plastic case front. 2. Pull the dial knob off of tuning condenser shaft. 3. Remove the knurled nut holding the earphone jack to the case. 4. Remove the two screws holding the circuit board to the case and
3、lift chassis from the case. 5. If necessary to separate chassis and speaker, unsolder speaker leads from wiring side of board. AVOID UNSOLDERING LEADS AT SPEAKER TERMINALS SINCE EXCESSIVE HEAT WILL DAMAGE VOICE COIL LEADS. CRITICAL LEAD DRESS 1. Dress lead from diode to volume control between speake
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- RCA-Victor-Co-Inc-1RH10 电路原理图 RCA Victor Co Inc RH10 电路 原理图
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf

