RCA-Victor-Co-Inc-4VE046 电路原理图.pdf

《RCA-Victor-Co-Inc-4VE046 电路原理图.pdf》由会员分享，可在线阅读，更多相关《RCA-Victor-Co-Inc-4VE046 电路原理图.pdf（1页珍藏版）》请在收音机爱好者资料库上搜索。

1、VOLUME R-24, MOST-OFTEN-NEEDED 1964 RADIO SERVICING INFORMATION RCA VICTOR Chassis RS-202A, Models 3VC64 and similar Chassis RS-202B, ACCESS TO TUBES All tubes are accessible through the small panel on the rear of the instrument. 1. Remove power cord. 2. Remove three (3) plated screws holding small

2、access panel on rear of instrument. 3. Swing panel down and to right on its pivot. DO NOT ATTEMPT TO REMOVE PANEL. CHASSIS REMOVAL The top of the record changer compartment comprises the complete chassis. It rests on and is secured to a ledge at the front and is held by screws at the rear. The recom

3、mended procedure for its removal is as follows: 1. Remove knobs. 2. Open small access panel as described in “Access to Tubes.” 3. Position two (2) holes in access panel over screws holding power cord interlock. 4. Remove two (2) machine screws holding interlock. 3VC82, 4VC64, 4VC69, 4VC82, used in M

4、odels 4VE045, 4VE046. 5- Pull record changer drawer down. If it is not desired to remove chassis completely, omit Steps 6 & 7. 6. Unscrew two (2) bolts securing record changer in access holes in turntable, one at front and one at rear.) drawer. (Lift mat of turntable and reach bolts through access h

5、oles in turntahle, one at front and one at rear.) DO NOT ATTEMPT TO REMOVE RECORD CHANGER DRAWER. 7. Lift up changer and disconnect cables. 8. Remove four (4) plated screws holding front of chassis to horizontal ledge located inside of compart ment at front of top. 9- Remove wires, running down each

6、 back corner of compartment, from holding clips. 10- Remove four (4) painted screws holding rear of chassis to rear of instrumentjust below the access panel. 11. Chassis may then be lowered and removed. 12. Disconnect speaker cables from transformers and lift chassis out of case. 收音机爱 好者资料库 RadioFans.CN