McIntosh-MA7200-Connection-Diagram 电路图 维修手册.pdf

《McIntosh-MA7200-Connection-Diagram 电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《McIntosh-MA7200-Connection-Diagram 电路图 维修手册.pdf（1页珍藏版）》请在收音机爱好者资料库上搜索。

1、MA7200 Rear Panel Connections 1A McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 Part No. 04175100 Connect the MA7200 power cord to a live AC outlet. Refer to infor- mation on the back panel of your MA7200 to determine the correct vol

2、tage for your unit POWER CONTROL MAIN OUTPUT sends turn On/Off signals to a McIntosh Component when the MA7200 is switched On/Off DATA PORTS send signals to Source Components to allow control with the MA7200 Remote Control GND terminal accepts a ground wire from a turntable PHONO MM accepts signals

3、from a Mov- ing Magnet Phono Cartridge POWER CONTROL PASSTHRU INPUT receives turn On/Off signals from an Audio/ Video Control Center PHONO MC accepts the low level signals from a Moving Coil Phono Cartridge OUTPUTS 2 send signals to Power Amplifiers and are switched On/Off with the Front Panel Outpu

4、t 2 Push-Button or Remote Control Push-Button DIGITAL AUDIO INPUTS for components with Digital Optical and Coaxial Out- puts sending digital audio signals BALANCED INPUTS accept high level pro- gram source signals USB DIGITAL AUDIO INPUT for connection to a computer RS232 connector1 for connection t

5、o a computer or other control device POWER CONTROL OUTPUTS TRIGger 1 and 2 send turn On/Off signals to assignable components Main Fuse holder, refer to information on the back panel of your MA7200 to determine the correct fuse size and rating PWR AMP INPUTS accept signals from the internal Preamplif

6、ier or a separate external Preamplifier Left OUTPUT connections for a 2, 4 or 8 ohm Loudspeaker JUMPER PLUGS connect the Preamplifier OUT- PUT 1 Jacks to the PWR AMP INPUTS Jacks and are required for normal operation Right OUTPUT connections for a 2, 4 or 8 ohm Loudspeaker 1 Refer to page 3 of the M

7、A7200 Owners Manual for addition cable information. UNBALANCED INPUTS 1 thru 5 accept high level program source signals MCT DIGITAL AUDIO INPUT for streaming high bandwidth digital signals from SACD/CD Transport Components SERVICE PORT for service use only IR INput for signals from a compatible IR Room Sensor RadioFans.CN 收音机爱 好者资料库