Philips-DCP-951-Service-Manual 电路图 维修手册.pdf
《Philips-DCP-951-Service-Manual 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Philips-DCP-951-Service-Manual 电路图 维修手册.pdf(51页珍藏版)》请在收音机爱好者资料库上搜索。
1、DVD Portable Player DCP951 All version 3141 785 32611 Version 1.1 TABLE OF CONTENTS Chapter Technical Specification & Service Tips. 1 Safety Instructions. 2 Instruction for Use 3 Mechanical Instructions. 4 Troubleshooting 5 Overall Block Diagram. 6 Electrical Diagram 7 Service Part List. 8 Revision
2、List. 9 Copyright 2005 Philips Consumer Electronics B.V. Eindhoven, The Netherlands All rights reserved. No part of this publication may by reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronics, mechanical, photocopying, or otherwise without the prior perm
3、ission of Philips Service Manual RadioFans.CN 收音机爱 好者资料库 1.0 TECHNICAL SPECIFICATION General Dimensions (W x H x D): 210 x 39 x 178 mm Bear Unit Weight: 1.1 kg +/- 5% Power supply: Supply voltage Input: 100240V + / - 10% 50/60Hz 0.3A Output: DC 9V 1A Supply Power consumption (AC adaptor 100/240VAC)
4、9W + 10% Operating Temperature -10 50degC Video System NTSC Frequency response 20-20kHz +/-1dB THD 20-20kHz (%): /=80dB Signal/Noise ratio: /=80dB Channel Separation 1kHz =60dB Channel Balance 1kHz 65dB THD (0.2-20kHz): 3% Left-Right Channel Separation: /=50dB Left-Right Channel Balance: 6 - 5 - 3 4
5、. The LCD display showed the existing region code. Press (navigation up) or (navigation down) repeatedly to select the number from 0 to 6. 5. Refer below table for your region code setting Select “0” setting = Region Free (confidential) RadioFans.CN 收音机爱 好者资料库 1.0 TECHNICAL SPECIFICATION Procedure o
6、n how to upgrade the software of the DVD Portable For the best performance of your DVD Portable. Check for latest software upgrades available. A) By CD-ROM 1. Download the “PHILIPS.BIN” file from the Philips support site 2. Unzip the file and then burn it into a CD-ROM to make a disc for upgrade 3.
7、CD-ROM disc name must be “PHILIPS” (otherwise it will not be recognized as a disc for upgrade) 4. Power on the Portable DVD Player with AC/DC adaptor 5. Play CD-ROM for firmware upgrade Warning: Do not unplug the AC adaptor during firmware upgrade to prevent flash corrupt of the set! 6. Once upgrade
8、 is completed, the player will restart automatically and observed PHILIPS LOGO on the screen. 7. Open the DVD door to remove the disc B) By SD Card 1. Download the “PHILIPS.BIN” file from the Philips support site 2. Unzip the file and then copy and paste it into a blank SD card 3. Power on the Porta
9、ble DVD Player with AC/DC adaptor 4. Read the SD card via SD Card slot for firmware upgrade Warning: Do not unplug the AC adaptor during firmware upgrade to prevent flash corrupt of the set! 5. Once upgrade is completed, the player will restart automatically and observed PHILIPS LOGO on the screen.
10、RadioFans.CN 收音机爱 好者资料库 1.0 TECHNICAL SPECIFICATION Service Policy on PCBA of DCP951 Type /05 /12 /79 /98 Main PCBA MLR MLR MLR MLR TFT PCBA MLR MLR MLR MLR KEY PCBA MLR MLR MLR MLR BATTERY PCBA MLR MLR MLR MLR IPOD PCBA MLR MLR MLR MLR MLR = module swap 3.0 INSTRUCTION FOR USE 3.0 INSTRUCTION FOR U
11、SE 4.0 MECHANICAL INSTRUCTION Disassembly Procedure 1. Remove 7pcs of screws on the side of bottom cabinet. 2. Open the bottom cabinet. Carefully unplug the housing which is connected with main board and TFT board. 3. Open the bottom cabinet. First, unplug all the housing which are connected the mai
12、n board with battery board, key board and IPOD board. (include 2pcs housing and the FFC for the DVD louder) Second, unplug all the housing which are connected with main board and TFT board (then you can separate TFT board and main board) Remove all the screws on the main board (4pcs), take out the m
13、ain board from bottom cabinet. 4.0 MECHANICAL INSTRUCTION 4. Unplug the FFC and remove 3pcs screws from DVD louder, then you can take out the DVD louder. 5. From this location (between the buttons and battery) you can take out the key board easily. 6. Remove 2pcs of screws on the battery board. You
14、cant take out the battery together with the battery board yet. Due to the battery was fixed by the IPOD plastic docking cover and the press IPOD-lock metal piece. If you want to take out the battery, you must remove the IPOD plastic docking cover and the press IPOD-lock metal piece first. Remove 4pc
15、s screws from the cover (shown the left photo), after that remove these 2pcs screws (as shown the above photo). Note: the battery was fixed by 2pcs two side adhesive tape! 4.0 MECHANICAL INSTRUCTION After done above, you can take out the IPOD plastic docking cover and IPOD docking. 7. Unplug all the
16、 housing which are connected with main board and TFT board (dont forget to unplug the Panel FFC from TFT board behind the black flannel). 8. Remove 6pcs screws on the TFT board, de- soldering the wire connected between panel and TFT board (dont forget to de-soldering the black ground wire). Then tak
17、e out the TFT board from display frame. Remove 4pcs screws which are to fix the panel on the display frame to take out the panel from display frame. To take out the IPOD board. Remove 2pcs black screws from the bottom of IPOD docking(as the photo shown) 4.0 MECHANICAL INSTRUCTION 5.0 TROUBLESHOOTING
18、 SYMPTOM: BATTERY NO POWER Start Check Battery capacity? BATTERY CANT Power ON Check charging function OK? SET OK? No Defect, return set to Customer Check adaptor power-ON OK? no Check the Power-ON button and cable OK? Replace Main Board Replace Button or Cable yes Yes NO No Yes Yes No 5.0 TROUBLESH
19、OOTING SYMPTOM: NO IMAGE / NO SOUND SYMPTOM: NO IMAGE OUTPUT ( THE PANEL SHOW BLUE PICTURE) Start Check the external AV Cable TYPEnote and connection is OK? Replace DVD DriveCheck DVD Drive work? Replace Main Board Exchange AV cable NOTE: AV Cable TYPE from outside to Inside L-Audio, R-Audio, Video,
20、 Ground no yes no yes SYMPTOM: NO SOUND COMES FROM SPEAKER Start Check the Connection OK?Reinsertion Check speaker OK? Replace Main Board Change the speaker no yes no yes 5.0 TROUBLESHOOTING SYMPTOM: THE DVD DRIVE DOES NOT WORK SYMPTOM: THE DVD DRIVE DOESNT WORK Start Replace DVD- Loader Check the D
21、VD-Loader OK? Replace main board NO Yes Yes Cable ReinsertionNO Check DVD-Loader connection OK? 5.0 TROUBLESHOOTING SYMPTOM: ADAPTOR CANNOT POWER ON Start Check Adaptor OK? Adaptor can not Power ON Change adaptorSET OK? Return set to Customer NO Check the Power-ON button and cable OK? Replace Main B
22、oard Replace Button or Cable Yes NO Yes No YES OK 5.0 TROUBLESHOOTING SYMPTOM: REMOTE CONTROL CANNOT WORK SYMPTOM: THE REMOTE CONTROL CAN NOT WORK Start Check TOP-board OK? Replace main board Yes Yes Cable ReinsertionNO Check CABLE form bottom board to top board connection OK? Replace IR receiver Re
23、turn to custormer OK OK Replace top boardNONO OK 5.0 TROUBLESHOOTING SYMPTOM: NO SOUND FROM HEADPHONE 5.0 TROUBLESHOOTING SYMPTOM: LED DISPLAY FAILURE SYMPTOM: LED Display Fail Start Check TOP-board OK? Replace main board NO Yes Yes Cable ReinsertionNO Check CABLE form Main board to top board connec
24、tion OK? Replace LED Return to custormerOK Replace top boardNO OK OK 5.0 TROUBLESHOOTING SYMPTOM: KEY & BOTTON FAILURE SYMPTOM: Key & Botton Fail Start Check KEY board OK? Replace main board NO Yes Yes Cable ReinsertionNO Check CABLE form board to board connection OK? Return to custormerOK Replace K
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Philips-DCP-951-Service-Manual 电路图 维修手册 Philips DCP 951 Service Manual 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf

