Rotel-RSX-1056-OM 电路图 维修手册.pdf
《Rotel-RSX-1056-OM 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Rotel-RSX-1056-OM 电路图 维修手册.pdf(46页珍藏版)》请在收音机爱好者资料库上搜索。
1、Owners manual RSX-1056 Surround Sound Receiver 2CH DOLBY PLII/3ST DTS Neo 6DSP MULTI INPUTMUTERECZONE CDTUNERTAPE1 SURROUND SOUND RECEIVER RSX-1056 STANDBY VIDEO1VIDEO2VIDEO3VIDEO5VIDEO4 67890DIRECTMEMORYMONO 12345TUNING VOLUME BAND RadioFans.CN 收音机爱 好者资料库 10 cm 4 in 10 cm 4 in 10 cm 4 in 10 cm 4 in
2、 2CH DOLBY PLII/3ST DTS Neo 6DSP MULTI INPUTMUTERECZONE CDTUNERTAPE1 SURROUND SOUND RECEIVER RSX-1056 STANDBY VIDEO1VIDEO2VIDEO3VIDEO5VIDEO4 67890DIRECTMEMORYMONO 12345TUNING VOLUME BAND RadioFans.CN 收音机爱 好者资料库 Notice The COMPUTER I/O connection should be handled by authorized person only. FCC Infor
3、mation This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
4、radi- ate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communica- tions. However, there is no guarantee that interference will not occur in a particu- lar installation. If this equipment does cause harmful interfere
5、nce to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna.(TV, radio, etc.) Increase the separation between the equi
6、pment and receiver Connect the equipment to an outlet on circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for additional help. Caution This device complies with part 15 of the FCC Rules operation is subject to the following to c
7、onditions: (1) This device may not cause harmful interfer- ence, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna installers attention to Article 820-40 of the NEC. Thi
8、s provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. See installation diagram. NOTE: This equipment has been tested and found to comply with the li
9、m- its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential installation. This equipment generates and can radiate ra- dio frequency energy and, if not installed and used in accordance wit
10、h the instructions, may cause interference to radio or TV communications. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, try
11、to cor- rect the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the unit and the television tuner. Connect the unit to an AC power outlet on a different electrical circuit. Consult your authorized Rotel retailer for
12、assistance. Important Safety Instructions WARNING: There are no user serviceable parts inside. Refer all servic- ing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Do not allow foreign objects to get into the enclo-
13、 sure. If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. Keep
14、this manual so you can refer to these safety instructions. Heed all warnings and safety information in these instructions and on the product itself. Follow all operating instructions. Clean the enclosure only with a dry cloth or a vacuum cleaner. Do not use this unit near water. You must allow a min
15、imum 10 cm or 4 inches of unobstructed clearance around the unit. Do not place the unit on a bed, sofa, rug, or similar surface that could block the ventilation openings. If the unit is placed in a bookcase or cabinet, there must be ventilation of the cabinet to allow proper cooling. Keep the compon
16、ent away from radiators, heat registers, stoves, or any other appliance that produces heat. The unit must be connected to a power supply only of the type and voltage specified on the rear panel. (USA: 115 V/60Hz, EC: 230V/50Hz) Connect the component to the power outlet only with the supplied power s
17、upply cable or an exact equivalent. Do not modify the supplied cable. Do not A polarized plug has two blades, with one wider than the other. A grounding plug has two blades plus a third grounding prong. These are provided for your safety. Do not defeat grounding and/or polarization safety provisions
18、. If the supplied plug does not fit your outlet, please consult an electrician for replacement of the obsolete outlet. Do not use extension cords. The main plug of the power cordset is a disconnect device of the appara- tus. In order to completely disconnect the apparatus from the supply mains, the
19、main plug of the power cordset should be unplugged from the mains (AC) outlet. The stand-by LED indicator will not be lit up to show the power cord is unplugged. Do not route the power cord where it will be crushed, pinched, bent, ex- posed to heat, or damaged in any way. Pay particular attention to
20、 the power cord at the plug and where the cord exits the back of the unit. The power cord should be unplugged from the wall outlet during a light- ning storm or if the unit is to be left unused for a long period of time. Use only accessories specified by the manufacturer. Use only with a cart, stand
21、, rack, bracket or shelf system recommended by Rotel. Use caution when moving the unit in a stand or rack to avoid injury from a tip-over. Immediately stop using the component and have it inspected and/or ser- viced by a qualified service agency if: The power supply cord or plug has been damaged. Ob
22、jects have fallen or liquid has been spilled into the unit. The unit has been exposed to rain. The unit shows signs of improper operation The unit has been dropped or damaged in any way RadioFans.CN 收音机爱 好者资料库 4RSX-1056 Surround Sound Receiver 1: Controls and Connections SPEAKERS FRONT/CB/ZONE RIGHT
23、/2 LEFT/1 ANTENNA OFF ON POWER SURROUNDCENTER RIGHT LEFT 2CH DOLBY PLII/3ST DTS Neo 6DSP MULTI INPUTMUTERECZONE CDTUNERTAPE1 SURROUND SOUND RECEIVER RSX-1056 STANDBY VIDEO1VIDEO2VIDEO3VIDEO5VIDEO4 67890DIRECTMEMORYMONO 12345TUNING VOLUME BAND Manufactured under license from Digital Theater Systems,
24、Inc. US Pat. No. 5,451,942, 5,956674, 5,974,380, 5,978,762, and other world-wide patents issued and pending. DTS and DTS Digital Surround are registered trademarks of Digital Theater Systems, Inc. Copyright 1996, 2000 Digital Theater Systems, Inc. All rights reserved. CAUTION RISK OF ELECTRIC SHOCK
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Rotel-RSX-1056-OM 电路图 维修手册 Rotel RSX 1056 OM 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf

