Neve 0440_BA440_class_AB_line_amplifier_doc_4pages电路图.pdf

《Neve 0440_BA440_class_AB_line_amplifier_doc_4pages电路图.pdf》由会员分享，可在线阅读，更多相关《Neve 0440_BA440_class_AB_line_amplifier_doc_4pages电路图.pdf（4页珍藏版）》请在收音机爱好者资料库上搜索。

1、AMPLIFIER BA440/BA440A/BA440B The BA440 is a plug in quasi-operational amplifi er. There are two inputs, a non inverting input at pin 1 and an inverting input at pin 2. The signal is applied to the non-inverting input at pin 1 and then passes from the isolating capacitor C2 to the base of TR1 which

2、has an input impedance of 47K ohm defi ned by R3. The resistor chain Rl and R2 forms a potential divider setting the bias voltage on TR1 base. The signal is applied to the base of TR2 which is in a common emitter confi guration. R5 in parallel with TR2 forms the collector load of TR1. C3 is an rf su

3、ppression capacitor. TR2 drives TR3 with R6 forming the collector load of TR2. TR3 drives TR4 such that the TR3 and TR4 confi guration has a gain of 4 times as defi ned by R7 and R8 feeding the unbalanced output at pin 5. The diode D3 protects TR4 from overloading by removing its base drive just bef

4、ore saturation. Feeding TR4 is a constant current source consisting of TR6, RIO, Rll and R12 which contributes to low overall distortion. TR5 provides base bias for the output pair TR6 and TR7 and being thermally coupled to them, stabilies the quiescent current. TR6 is also thermally compenstated by

5、 Dl. C5 is a decoupling capacitor across the supply line. The gain of the amplifi er may be increased by decreasing the feedback voltage to the emitter of TR1. This voltage is decreased by connecting an external resistor between the inverting input at pin 2 and B- at pin 3, thus forming a potential

6、divider with the internal feedback resistor R4. The output stage consists of a pair of complementary transistors TR7 and TR8 connected as emitter followers. The bias voltage and thus the quiescent current of TR7 and TR8 is derived from TR5 and is set by the adjust on test,resistor R16. - The inverti

7、ng input at pin 2 presents a very low input impedance, but is not d.c isolated. Consequently an external isolating capacitor must be used This input may be used for mixing different signal sources via suitable resistors in series with the input capacitor. RadioFans.CN 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库