John-Meck-Industries-Inc-RC-5C5 电路原理图.pdf
《John-Meck-Industries-Inc-RC-5C5 电路原理图.pdf》由会员分享,可在线阅读,更多相关《John-Meck-Industries-Inc-RC-5C5 电路原理图.pdf(1页珍藏版)》请在收音机爱好者资料库上搜索。
1、MANUAL OF 1946 MOST POPULAR SERVICE DIAGRAMS JOHN MECK INDUSTRIES, Inc., Plymouth, Indiana I.F. ALIGNMENT: The step-by-step routine given below should be carefully followed after reading the Preceding instructions: |. The modulated oscillator must be tuned to 455 K.C. 2. Connect the high side of the
2、 oscillator output to the lug on the R.F. section of the gang condenser. The low side of the oscillator is connected to the chassis through a .01 condenser. 3. Set the gang condenser of the radio to 1720 on the dial and turn the volume control on full. 4. Adjust the four I.F. trimmers tuning each ca
3、refully to get the maximum de flection of the output meter. Reduce the oscillator output if the output meter goes off scale. 5. Repeat all four adjustments since the adjustment of each I.F. trimmer may ef fect the others to a certain extent. VOLTAGE TABLE - Use high resistance voltmeter of 1000 ohms
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- John-Meck-Industries-Inc-RC-5C5 电路原理图 John Meck Industries Inc RC C5 电路 原理图
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


