RCA-Victor-Co-Inc-94BP 电路原理图.pdf
《RCA-Victor-Co-Inc-94BP 电路原理图.pdf》由会员分享,可在线阅读,更多相关《RCA-Victor-Co-Inc-94BP 电路原理图.pdf(3页珍藏版)》请在收音机爱好者资料库上搜索。
1、582 MODEL 94BP SERIES Chassis No. RC -407 RC -407B Four -Tube, Single -Band, Battery -Operated, Superheterodyne Receiver The following models comprise the 9411P1 Series- all contain the No, RC -407 chassis. 94BP61 Dark Brown 94BP62 Tan 94BP84 Light Brown 94BP66 Gray 94BP80 Brown Leather 94BP81 Black
2、 Leather The following models comprise the 2nd Production 94BP1 Series -all contain the No. RC 4078 chassis. 94BP61 Dark Brown 94BP62 Tan 94BP64 Light Brown 94BP66 Gray Electrical and Mechanical Specifications RC 407 Frequency Range Intermediate Frequency 550-1,720 kc 455 kc RCA TUBE COMPLEMENT (1)
3、RCA- IA7-G 1st-Det.-Osc. (2) RCA -1N5 -G (3) RCA -1H5 -G 2nd-Det., A- (4) RCA -105-G BATTERIES REQUIRED A, one 1.5 volt dry plug -type A, 2 -in. x (Eveready No. 742 or equivalent) B, two 45 volt dry plug -type B, 2* -in. x (Eveready No. 762 or equivalent) CURRENT CONSUMPTION A, 0.24 ampere-B, 9.0 mi
4、lliamperes Frequency Range Intermediate Frequency RCA TUBE (OMPt.EMENT F, and A.V.C. I -F Amplifier Output 21 -in. x 4 -in. 4 -in. x 51 -in. POWER OUTPUT Undistorted Maximum 0.10 watt 0.21 watt LOUDSPEAKER Type 4 -inch permanent -magnet dynamic Voice -coil Impedance 2 ohms at 400 cycles Height Width
5、 Depth Cabinet Dimensions (inches) 9 12* 611 Weight-(Net) less batteries 6 pounds With batteries 12 pounds Tuning Drive Ratio 10 to 1 Electrical and Mechanical Specifications 530-1,650 kc POWER OUTPUT 455 kc 1ndistorted 0.12 watt (1) RCA -1A7 -G (2) RCA -1N5 -G (3) RCA-IHS-G (4) RCA-IQS-GT Ist-net.-
6、Osc. I -F Amplifier 2nd-Det., A -F, and A.(. Output 1st -Production, RC -407: The following notes apply only to the 1st. production of Models 94BP1 Series (94BP-81, 62,-84,66,80,-81). Antenna Attachment: Due to the extended service that -the 94BP1 Series radio has been put to use by many of its owne
7、rs-such as service on small boats, camping trips, and other uses in locations far distant from a reliable broadcasting source -there have been requests for information on the use of an antenna to be used in conjunction with the receiver. The radio is one of high sensitivity, but where few stations a
8、re receivable, two method, of using an external antenna may be used: (a) Five to ten turns -of wire may be wrapped around the left end (loop end) of the cab- inet attaching one end of the wire to a high antenna and the other to ground. (b) One to two turns of insulated wire spay b wrapped around one
9、 end of the loop in the cabinet, making connections to the end of an external antenna and ground. The wire may be fastened to the loop supports with scotch tape or string and the ends brought out through the rear -of the cabinet making a permanent attachment for an outside an- tenna. If care is take
10、n in placing the wire around the loop (using small 22 gauge D.C.C. wire spaced as far as possible from the loop winding) the receiver will not have to be realigned and the directional effect of the loop will not be so prevalent. Oscillator Grid Resistor in 1st -Production: The oscillator grid resist
11、or is changed from 220,000 ohms to 150,000 ohms (Stock No. 14020). RC 407E3 Maximum. 0.25 watt CURRENT CONSUMPTION A, 0.24 ampere-B, 11.6 Volume Control Change in 1st -Production: The volume control is changed from Stock No.33304 to 34427. Additional Replacement Parts: Stock No. 34426 Indicator-On-o
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- RCA-Victor-Co-Inc-94BP 电路原理图 RCA Victor Co Inc 94 BP 电路 原理图
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


