AMPEXAmpex_plug-in_mic_preamp 维修电路原理图.pdf
《AMPEXAmpex_plug-in_mic_preamp 维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《AMPEXAmpex_plug-in_mic_preamp 维修电路原理图.pdf(5页珍藏版)》请在收音机爱好者资料库上搜索。
1、Ampex plug-in Microphone Preamp 4010066 The preamplifier is wired so that a variable gain control may be inserted between the two stages. When used with Ampex recorders (AG-440, AG-500, AG-600), the record level control on the equipment is so connected, making the preamplifier a variable-gain device
2、 that accommodates a wide variety of professional-quality microphones. The unit can be used to drive any amplifier with a 100K ohm input impedance, at a 0.1 VRMS level. When so used, the signal input is connected across pins 4 and 8, the unbalanced output is taken across pins 7 and 2 (ground). Power (+24VDC) is connected to pin 5, with pin 2 again as ground. The previously mentioned variable-gain control (100K ohms) is connected across pins 3 and 6. Pin 1 should be connected to the case of the unit, and should also be grounded. (from the Ampex AG-600B user manual)
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- AMPEX Ampex_plug-in_mic_preamp 维修电路原理图 Ampex_plug in_mic_preamp 维修 电路 原理图