McIntosh MC2300 Power Amplifier Service Information.pdf
《McIntosh MC2300 Power Amplifier Service Information.pdf》由会员分享,可在线阅读,更多相关《McIntosh MC2300 Power Amplifier Service Information.pdf(13页珍藏版)》请在收音机爱好者资料库上搜索。
1、HIHntosii MC2300 SERVICE INFORMATION STARTING WITH SERIAL NO. 1Y001 McIntosh laboratory inc. 2 chambers street Binghamton, new york 2300 ELECTRICAL SPECIFICATIONS PERFORMANCE McIntosh audio power ratings are in accordance with the Federal Trade Commisssion Regulation of Novem ber 4, 1974 concerning
2、power output claims for ampli fiers used in home entertainment products. POWER OUTPUT STEREO 300 watts minimum sine wave continuous average power output, per channel, both channels operating into 0.5 ohm, 1 ohm, 2 ohms, 4 ohms, 8 ohms, or 16 ohms load impedance, which is: 12.2 volts RMS across 0.5 o
3、hm 17.3 volts RMS across 1 ohm 24.5 volts RMS across 2 ohms 34.6 volts RMS across 4 ohms 49.0 volts RMS across 8 ohms 69.3 volts RMS across 16 ohms MONO 600 watts minimum sine wave continuous average power output into 0.25 ohm, 0.50 ohm, 1 ohm, 2 ohms, or 8 ohms load im pedance, which is: 12.2 volts
4、 RMS across 0.25 ohm 17.3 volts RMS across 1 ohm 36.6 volts RMS across 2 ohms 49.0 volts RMS across 4 ohms 69.3 volts RMS across 8 ohms OUTPUT LOAD IMPEDANCE iSTEREO 0.5 ohm, 1 ohm, 2 ohms, 4 ohms, 8 ohms and 16 ohms; separate terminals are pro vided for each output MONO 0.25 ohm, 0.5 ohm, 1 ohm, 2
5、ohms, 4 ohms and 8 ohms; separate terminals are pro vided for each output RATED POWER BAND 20 Hz to 20,000 Hz TOTAL HARMONIC DISTORTION STEREO 0.25% maximum harmonic distortion at any power level from 250 milliwatts to 300 watts per channel from 20 Hz to 20,000 Hz, both channels operating MONO 0.25%
6、 maximum harmonic distortion at any power level from 250 milliwatts to 600 watts from 20 Hz to 20,000 Hz OUTPUT POWER MONITOR METER Meter is calibrated to read +3.0 dB when amplifier produces 300 watts. Meter range switch is provided to increase meter sensitivity by 10 dB or 20 dB. Calibra tion accu
7、racy at 0 dB reading is 2.0% at all frequen cies; meter range accuracy is 5.0% INTERMODULATION DISTORTION STEREO 0.25% if instantaneous peak power output is 600 watts or less per channel with both channels operating for any combination of frequencies, 20 Hz to 20,000 Hz MONO 0.25% if instantaneous p
8、eak power output is 1200 watts or less per channel with both channels operating for any combination of frequencies, 20 Hz to 20,000 Hz FREQUENCY RESPONSE (at 1 watt output) STEREO 20 Hz to 20,000 Hz, +0 -0.5 dB; 1, 4, 8 or 16 ohms; +0 1.0 dB; 0.5 or 2 ohms 12 Hz to 35,000 Hz, +0-1.5 dB MONO 20 Hz to
9、 20,000 Hz, +0 -0.5 dB; 1, 4, 8 Or 16 ohms; + 0; 1.0 dB; 0.25 or 1.0 ohm 12 Hz to 35,000 Hz, +0-1.5 dB NOISE AND HUM 90 dB below rated output RATINGS OUTPUT VOLTAGES 25 volts, stereo and mono; 70 volts, stereo and mono for distribution lines DAMPING FACTOR 27 at 0.5 ohm output, 50 at 1 ohm output, 2
10、9 at 2 ohms output, 21 at 4 ohms output, 14 at 8 ohms output INPUT IMPEDANCE 200,000 ohms INPUT SENSITIVITY 0.5 volt. Level control provided for higher input voltage GENERAL INFORMATION POWER REQUIREMENTS 120 volts 50/60 Hz, 160 watts at zeijo signal output, 1400 watts at rated output SEMICONDUCTOR
11、COMPLEMENT 46 silicon transistors 16 diodes, rectifiers and bridge rectifiers MECHANICAL INFORMATION SIZE Front panel measures 19 inches wide (48.26 cm) by IOV2 inches high (26.67 cm). Chassis measures 17 inches wide (43.18 cm) by 10 inches high (25.4 cm) by 17 inches deep (43.18 cm), including conn
12、ectors. Clearance in front of mounting panel including knobs 2 inches (5.08 cm) FINISH Front panel is anodized gold and black. Chassis is black baked enamel. MOUNTING Standard 19 (48.26 cm) rack mounting WEIGHT 128 pounds (58.06 kg) net, 143 pounds (64.86 kg) in shipping carton - -.-.-. METER OUTPUT
13、 MONITOR CLASS B OUTPUT STAGE DRIVER METER MC 2300 2300 BLOCK DIAGRAM MC 2 300 V QI37 top QI33 MIDDLE Q129 BOTTCM MC 2300 INPUT PC BOARD 044-650 LEFT INPUT RIGHT/MONO GAIN S 7= u. _:J I RIGHT/MONO INPUT | 3.3K . % CM 0 - 0 - li. - 3 0 capacitance values smaller than 1 are in microfarads (pF); capaci
14、tance values greater than 1 are in picofarads (pF); inductors are in microhenries (pH). 2. Printed circuit board components are outlined on the schematics by dotted lines. The circled numbers on the dotted lines correspond to the numbers on the PC board layouts. 3. The heavy lines on the schematics
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- McIntosh MC2300 Power Amplifier Service Information
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。
链接地址:http://www.radiofans.cn/p-191083.html



Marshall-9100-62-02-Schematic电路原理图.pdf


