Albrecht_AE-485S_user_2010.pdf

《Albrecht_AE-485S_user_2010.pdf》由会员分享，可在线阅读，更多相关《Albrecht_AE-485S_user_2010.pdf（15页珍藏版）》请在收音机爱好者资料库上搜索。

1、 1 AE 485 S 10 meter Amateur Radio Transceiver for AM / FM / SSB according to EU standard EN 301 783 -2 2 Contents Legal and General Information.3 Preparation for Use.5 General Use Instructions.5 Connect to Power Supply.5 Safety Precautions and Vehicle Installation .5 Select Antenna - Vehicle Antenn

2、a.5 Operation as Base Station.6 Location of Controls AE 485 S (The picture is for the similar AE 5800 CB radio version).6 Controls and Switches.6 On/Off, Volume and Squelch Setting.6 Mic Gain (3) .6 RF Gain (4).7 Clarifier (11).7 LCD, S Meter and Power Meter .7 Channel or Frequency Display.7 Frequen

3、cy Steps (channel knob).8 Buttons AE 485 S (5-12).8 Select Mode.8 USB and LSB.8 Set Transmission Power.9 How to Receive SSB? .9 Use Frequency Memory .9 Enter Frequency .9 Recall saved Frequency.9 CALL Channel .9 Scan Mode.9 Start and Stop Scanning.9 Reverse Scanning Direction.9 Last Channel Recall (

4、LCR).10 Noise Blanker .10 Simplex- and Repeater Operation.10 Repeater settings.10 Activate the Repeater Shift.10 Change Shift Value.10 Sound Filter.10 Activate/Deactivate Key Tone.10 Interesting Facts Relating to the Technical Data.10 Storage and Backup of Set Data.10 Ports for Additional External D

5、evices.11 Reset to Default and Deleting All Memory.11 Disposal and Recycling .11 European Warranty 2 Years from Purchase Date.12 Technical Data.12 General.12 Service Contact Address (in Germany).13 3 Legal and General Information The legal regulations in some countries demand a printout of our CE De

6、claration of Conformity in its original wording (editorial status: March 2010). The latest regulations, announcements and other documentation for this device are published in the service download area at www.hobbyradio.de or www.alan-albrecht.info. Please observe the country-specific regulations whe

7、n using this device and take the obligatory registration in individual countries and possible operation restrictions serious! As Amateur Radio, there are important restrictions for use of this radio. Most important is the following The radio is allowed to be used only by licensed radio amateurs It i

8、s not allowed to transmit on frequencies outside the allocated 10 m amateur band, even if the frequency switching of the radio should allow it technically. The band limitation depends on country specific amateur radio regulations. For use in Germany, there is no band limitation requested for amateur

9、 radios. In other countries except Germany it may be allowed only to use band limited equipment. Even if you have an Amateur radio license, the license does not give you the right to use this transceiver for any other purpose than amateur radio in the 10 m Band. Persons, who do not have a valid amat

10、eur radio license, are not allowed to operate this radio. The radio fulfills the technical requirements of European Amateur radio standard EN 301 783-2. Among other parameters, this means, that the essential requirements for radiations in the spurious domain are within limits. However, any combinati

11、on with power amplifiers, permanently connected SWR meters or automatic RF operated antenna switches may increase the radiated spurious values. The radio amateur is responsible to keep his radiations within the amateur radio limits at any time. It cannot be excluded, that the national authorities ma

12、y impose restrictions of use in individual cases. Please consider the minimum distances between antennas and persons in the near field of your antenna installation (as base station) and observe the national requirements for site registration, where requested. 4 Declaration of Conformity CE- Declarat

13、ion of Conformity / Konformittserklrung We hereby declare that our product: / Wir erklren hiermit, dass unser Produkt Amateur Radio Albrecht AE 485 S satisfies all technical regulations applicable to the product within the scope of EU Council Directives, European Standards and national frequency app

14、lications:/ alle technischen Anforderungen im Geltungsbereich der EU Richtlinien, europischer Normen und nationaler Frequenzanwendungen einhlt: 73/23/EEC, 2004/108/ EG and 99/5/EC EN 301 783-2 V 1.1.1 EN 301 489-1 V.1.8.1, EN 301 489-15 V1.2.1, EN 60 950-1 :2006 All essential radio test suites have

15、been carried out. / Alle fr das Produkt vorgeschriebenen Funktestreihen wurden durchgefhrt. Alan Electronics GmbH Daimlerstr.1 k D- 63303 Dreieich This declaration is issued under our sole responsibility. Basing on not harmonised frequency applications and international amateur radio regulations, th

16、e use of this radio in Europe is restricted to holders of a valid amateur radio licence and is only allowed for amateur radio traffic on the dedicated amateur radio frequencies. This radio is not allowed for any other application, not by radio amateurs or any other persons. Diese Erklrung wird unter

17、 unserer alleinigen Verantwortung abgegeben. Dieses Funkgert darf wegen der nicht harmonisierten Frequenzanwendungen und der internationalen Regelungen ber den Amateurfunk in Europa grundstzlich nur von Inhabern einer gltigen Amateurfunklizenz benutzt werden. Dabei drfen nur dem Amateurfunk zugewies

18、ene Frequenzen im Rahmen des Amateurfunks benutzt werden. Jegliche andere Verwendung des Gerts ist weder durch Funkamateure noch andere Personen erlaubt. Point of contact/Ansprechpartner: Dipl.-Phys. Wolfgang Schnorrenberg Place and date of issue: Dreieich, 28. 3. 2010 (Signature) Dipl.-Phys. Wolfga

19、ng Schnorrenberg Alan Electronics GmbH 5 Preparation for Use General Use Instructions This AM-FM-SSB transceiver AE 485 S is a universal 10 m radio for 12VDC power supply. It an be connected to powerful 12V batteries, such as rechargeable lead batteries, but also via a suitable 12V power adapter wit

20、h at least 6A stabilized constant current to 230V mains power supply. Due to its SSB operation, demanding repeated fine- tuning and delicate operation, the radio is not intended for the use in vehicles when driving. The radio is intended for intermittent operation with an average transmission time o

21、f approx. 10% of its duty cycle, as it is typical for voice operation. This device is not intended for continuous transmission without regular reception periods as cooling phases. Avoid subjecting your radio to high humidity, extremely high or low temperatures, dust and direct sunlight. Only open th

22、e casing of your radio if you are knowledgeable in this regard, have the correct tools and measuring devices. The device comes with the international 10 m band range 28.000 MHz to 29.6 MHz with user selectable frequency steps or channel steps similar to the common CB rules. AM, FM, USB and LSB can b

23、e selected. Any extension of the frequency range und the use of other channels and modes than permitted in the individual countries may lead to prosecution. Connect to Power Supply Connect your device with the supplied DC cable to a 12V network or a 12V power adapter. Voltage fluctuation between 11V

24、 and 14V for power adapters and max. 15.6V, as in vehicles, campers or boats with rechargeable lead battery, chargers or alternators, are permissible. Battery and/or power adapter must supply at least 6-8 Ampere with good stabilization. Do not extend the power cord. In vehicles always try to connect

25、 directly to the battery terminals. In this case you have best immunity against interferences from ignition and alternator and the most stable supply voltage. In case the fuse integrated in the DC cable blows, please check the possible cause first (commonly voltage reversal and a flyback diode has r

26、eacted) and replace the fuse only with same type (10 Ampere, American glass fuse), and never bypass with foil or similar measures! Connect the red cable to the + terminal, and the black cable to the terminal of the power source. The minus terminal for this radio is on the casing, as usual for all mo

27、dern vehicles. When installing in boats safety measures against electrolytic and/or galvanic corrosion, such as insulated installation and galvanic insulation of the antenna connections may be necessary due to the grounding of the casing. Safety Precautions and Vehicle Installation The device contai

28、ns no components that must be accessible for the user during operation. Leave the opening of the casing to experts. Do not open the casing before disconnecting from 12V power supply. For use in cars, trucks, boats or RV vehicles mount your radio with the supplied screws and bracket in a suitable position. Ensure that no risk of injuries for driver and passengers comes from the mounting position and avoid close proximity of air vents. Do not use your radio when driving. The device is neither intended not approved for this kind of operation. According to the Federal Motor Transpor