IC-V85_E_T_user.pdf

《IC-V85_E_T_user.pdf》由会员分享，可在线阅读，更多相关《IC-V85_E_T_user.pdf（80页珍藏版）》请在收音机爱好者资料库上搜索。

1、INSTRUCTION MANUAL This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. iV85

2、FM TRANSCEIVER iV85E iV85-T i FOREWORD Thank you for purchasing this Icom transceiver. The IC-V85 FM TRANSCEIVER is designed and built with Icoms superior tech- nology and craftsmanship. With proper care, this transceiver should provide you with years of trouble-free operation. We want to take a cou

3、ple of moments of your time to thank you for making the IC-V85 your radio of choice, and hope you agree with Icoms philosophy of “technology fi rst.” Many hours of research and development went into the design of your IC-V85. D FEATURES 7 W* high transmit output power * 7 W : IC-V85 except THA versi

4、on, 5.5 W : IC-V85 THA version CTCSS and DTCS encoder/decoder stand- ard Optional DTMF decoder IMPORTANT READ ALL INSTRUCTIONS carefully and completely before using the transceiver. SAVE THIS INSTRUCTION MANUAL This in- struction manual contains important operating instructions for the IC-V85. EXPLI

5、CIT DEFINITIONS WORD DEFINITION R WARNING! CAUTION NOTE Personal injury, fire hazard or electric shock may occur. Equipment damage may occur. Recommended for optimum use. No risk of personal injury, fi re or electric shock. Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorpor

6、ated (Japan) in Japan, the United States, the United Kingdom, Germany, France, Spain, Russia and/or other countries. ii RWARNING RF EXPOSURE! This device emits Radio Frequency (RF) energy. Extreme caution should be ob- served when operating this device. If you have any questions regarding RF exposur

7、e and safety standards please refer to the Federal Communications Commission Offi ce of Engineer- ing and Technologys report on Evaluating Compliance with FCC Guidelines for Human Radio frequency Electromagnetic Fields (OET Bulletin 65) RWARNING! NEVER hold the transceiver so that the antenna is ver

8、y close to, or touching exposed parts of the body, especially the face or eyes, while transmitting. The transceiver will perform best if the microphone is 5 to 10 cm (2 to 4 inches) away from the lips and the transceiver is verti- cal. RWARNING! NEVER operate the transceiver with a headset or other

9、audio accessories at high volume levels. Hearing experts advise against continuous high volume op- eration. If you experience a ringing in your ears, reduce the volume or discontinue use. RWARNING! NEVER operate the transceiver while driving a vehicle. Safe driving requires your full attention anyth

10、ing less may result in an accident. RWARNING! NEVER connect the transceiver to an AC outlet. This may pose a fi re hazard or result in an electric shock. NEVER connect a power supply of more than 16 V DC through the optional CP-19R CIGARETTE LIGHTER CABLE to the DC 11V jack to prevent damaging the t

11、ransceiver. NEVER connect the transceiver to a power source using reverse polarity. This will ruin the transceiver. NEVER cut the DC power cable between the DC plug and fuse holder. If an incorrect connection is made after cutting, the transceiver may be damaged. NEVER expose the transceiver to rain

12、, snow or any liquids. The transceiver may be damaged. NEVER operate or touch the transceiver with wet hands. This may result in an electric shock or ruin the transceiver. NEVER attempt to charge alkaline or dry cell batteries. Be aware that external DC power connections will charge bat- teries insi

13、de the battery case. This will damage not only the battery case but also the transceiver. DO NOT push the PTT when not actually desiring to trans- mit. PRECAUTIONS iii SUPPLIED ACCESSORIES q Antenna* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 w Hand strap* . . . . . .

14、. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 e 2251 OPT sheet* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 r Battery pack*/Battery case* . . . . . . . . . . . . . . . . . . . . . . 1 t Belt clip* (with screws) . . . . . . . . . . . . . . . . . . . . . . . . . . 1 y A

15、C Adapter* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 *Not supplied with some versions. r y qwt e r DO NOT operate the transceiver near unshielded electri- cal blasting caps or in an explosive atmosphere. BE CAREFUL! The transceiver will become hot when operating it contin

16、uously for long periods. AVOID using or placing the transceiver in direct sunlight or in areas with temperatures below 10C (+14F) or above +60C (+140F). Place the unit in a secure place to avoid inadvertent use by children. AVOID the use of chemical agents such as benzine or al- cohol when cleaning,

17、 as they can damage the transceivers surfaces. Even when the transceiver power is OFF, a slight current still fl ows in the circuits. Remove the battery pack or case from the transceiver when not using it for a long time. Otherwise, the battery pack (Li-ion: BP-227) or installed batteries will be- c

18、ome exhausted. For USA only: Caution: Changes or modifi cations to this transceiver, not expressly approved by Icom Inc., could void your authority to operate this transceiver under FCC regulations. PRECAUTIONScontinued iv BP-226BATTERY CASE Battery case for 5AA (LR6) size alkaline batteries. BP-227

19、LI-ION BATTERY PACK 7.4 V, 1850 mAh (minimum)/1950 mAh (typical) Lithium-ion battery pack. BC-119NDESKTOP CHARGER + AD-100 CHARGER ADAPTER For rapid charging of battery packs. An AC adapter is sup- plied with the charger. Charging time: approx. 22.5 hrs. BC-121N MULTI-CHARGER + AD-100 CHARGER ADAPTE

20、R (6 pcs.) For rapid charging of up to 6 battery packs (six AD-100s are required) simultaneously. An AC adapter may be supplied de- pending on version. Charging time: approx. 22.5 hrs. CP-19R CIGARETTE LIGHTER CABLE WITH NOISE FILTER Used for operation and charging a battery pack connected to transc

21、eiver via a DC power source. (11.7 V15.9 V DC) MB-98 BELT CLIP MB-98: Same as that supplied with the transceiver. UT-108 DTMF DECODER UNIT Provides pager and code squelch capabilities. SP-13EARPHONE Provides clear receive audio in noisy environments. FA-B2EWHIP ANTENNA Same as that supplied with tra

22、nsceiver. HM-75A/HM-131L/HM-158LSPEAKER-MICROPHONES Combination speaker-microphones that provide convenient operation while hanging the transceiver from your belt. HM-75A has 4 function switches for remote control capabilities. HM-131L/HM-158L are equipp ed with an earphone jack and a revolving clip

23、. HM-128L/HM-153L/HM-166LEARPHONE-MICROPHONE You can clip the microphone with PTT switch to your lapel or breast pocket. HS-85HEADSET Allows you hands-free operation. Includes VOX, PTT and “one-touch” PTT with time-out timer. VS-1LPTT/VOX UNIT+HS-94HEADSET VS-1L PTT/VOX UNIT Required when using the

24、headset. HS-94 EAR-PIECE TYPE HEADSET Earhook headset with fl exible boom microphone. CS-V85 CLONING SOFTWARE+OPC-478/U/UC CLONING CABLE Provide quick and easy programming of memory channel, memory name etc. OPC-474 CLONING CABLE For cloning between transceivers. LC-167CARRYING CASE Helps protect th

25、e transceiver from scratches, etc. OPTION LIST v TABLE OF CONTENTS FOREWORD . i IMPORTANT . i EXPLICIT DEFINITIONS . i PRECAUTIONS . iiiii SUPPLIED ACCESSORIES . iii OPTION LIST . iv TABLE OF CONTENTS . vvi QUICK REFERENCE GUIDE . IVI Preparation . I Your fi rst contact . IV Repeater operation. V Pr

26、ogramming memory channels . VI 1 ACCESSORIES . 12 Accessory attachment . 1 2 PANELDESCRIPTION . 38 Switches, controls, keys and connectors . 3 Function display . 7 3 BATTERYPACKS . 916 Battery pack replacement . 9 Cautions . 11 Regular charging . 13 Rapid charging . 14 External DC power operation .

27、16 4 BASICOPERATION . 1721 Power ON . 17 VFO mode selection . 17 Setting a frequency . 17 Setting audio/squelch level . 19 Receive and transmit . 19 Monitor function . 19 Display type . 20 Key lock function . 20 Weather channel operation (USA version only). 21 5 REPEATEROPERATION . 2225 General. 22

28、Reversed duplex mode . 22 Offset frequency . 23 Subaudible tones . 23 Repeater lockout . 24 Auto repeater function (USA version only) . 25 6 MEMORY/CALLOPERATION . 2631 General description . 26 Selecting a memory channel . 26 Selecting the call channel . 26 Programming the memory/call channels . 27

29、Channel name programming . 28 Memory transfers . 28 vi 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 Memory bank selection . 30 Memory bank setting . 30 Transferring bank contents . 31 7 DTMFMEMORY . 3234 Programming a DTMF code sequence . 32 Transmitting a DTMF code sequence . 33 DTMF transmissio

30、n rate . 34 8 SCANOPERATION . 3538 Scan types . 35 Programmed scan . 35 Memory scan . 36 Skip channels . 37 Scan resume condition . 37 Priority watch . 38 9 SUBAUDIBLETONES . 3942 Tone squelch . 39 Pocket beep operation . 41 Tone scan . 42 10 PAGER/CODESQUELCH (RequiresOptionalUT-108) . 4346 Pager f

31、unction . 43 Code programming . 43 Pager operation . 45 Code squelch . 46 11SETMODES . 4756 SET MODE . 47 INITIAL SET MODE . 51 12SETMODEINSPECTION . 5758 13CLONING . 5960 Transceiver-to-transceiver cloning . 59 Cloning using a PC . 60 14RESETTINGFUNCTIONS . 61 Partial reset . 61 CPU reset . 61 15TR

32、OUBLESHOOTING . 62 16OPTION . 63 Optional UT-108 installation . 63 17SPECIFICATIONS . 64 General. 64 Transmitter . 64 Receiver . 64 18CE . 6566 I QUICK REFERENCE GUIDE Preparation D Antenna Attach the antenna to the trans- ceiver as illustrated at right. D Belt clip Conveniently attaches to your bel

33、t. Attach the belt clip with the supplied screws using a phillips screwdriver. To attach the belt clip D Battery pack replacement Before replacing the battery pack, push and hold PWR for 1 sec. to turn the power OFF. Toattachthebatterypack Slide the battery pack on the back of the transceiver in the

34、 direction of the arrow (q), then lock it with the battery re- lease button. Slidethebatterypackuntilthebatteryreleasebuttonmakesa click sound. Toreleasethebatterypack Push the battery release button in the direction of the arrow (w) as shown below. The battery pack is then released. w q Battery pac

35、k Battery release button QUICK REFERENCE GUIDE II Quick reference guide D Battery case optional for some versions When using a BP-226 BATTERY CASE attached to the trans- ceiver, install 5 AA (LR6) size alkaline batteries as illustrated at right. q Hook your fi nger under the latch, and open the cover in the direction of the arrow (q). (Fig.1)