IC-V85_T_user.pdf

《IC-V85_T_user.pdf》由会员分享，可在线阅读，更多相关《IC-V85_T_user.pdf（80页珍藏版）》请在收音机爱好者资料库上搜索。

1、INSTRUCTION MANUAL This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FM TR

2、ANSCEIVER iV85 iV85-T i FOREWORD Thank you for purchasing this Icom transceiver. The IC-V85 FM TRANSCEIVERis designed and built with Icoms superior technology and craftsmanship. With proper care, this trans- ceiver should provide you with years of trouble-free operation. We want to take a couple of

3、moments of your time to thank you for making the IC-V85 your radio of choice, and hope you agree with Icoms philosophy of “technology fi rst.” Many hours of research and development went into the design of your IC- V85. DDFEATURES 7 W* high transmit output power *7 W: IC-V85 except THA version, 5.5

4、W : IC-V85 THA version CTCSS and DTCS encoder/decoder stan- dard Optional DTMF decoder IMPORTANT READ ALL INSTRUCTIONScarefully and completely before using the transceiver. SAVE THIS INSTRUCTION MANUALThis in- struction manual contains important operating instructions for the IC-V85. EXPLICIT DEFINI

5、TIONS WORDDEFINITION R WARNING! CAUTION NOTE Personal injury, fi re hazard or electric shock may occur. Equipment damage may occur. Recommended for optimum use. No risk of personal injury, fi re or electric shock. Icom, Icom Inc. and the logo are registered trademarks of Icom Incorporated (Japan) in

6、 the United States, the United Kingdom, Ger- many, France, Spain, Russia and/or other countries. ii RWARNING RF EXPOSURE!This device emits Radio Frequency (RF) energy. Extreme caution should be ob- served when operating this device. If you have any questions regarding RF exposure and safety standard

7、s please refer to the Federal Communications Commission Office of Engi- neering and Technologys report on Evaluating Compliance with FCC Guidelines for Human Radio frequency Electro- magnetic Fields (OET Bulletin 65) RWARNING! NEVERhold the transceiver so that the antenna is very close to, or touchi

8、ng exposed parts of the body, especially the face or eyes, while transmitting. The transceiver will perform best if the microphone is 5 to 10 cm (2 to 4 inches) away from the lips and the transceiver is verti- cal. RWARNING! NEVERoperate the transceiver with a headset or other audio accessories at h

9、igh volume levels. Hearing experts advise against continuous high volume op- eration. If you experience a ringing in your ears, reduce the volume or discontinue use. RWARNING! NEVERoperate the transceiver while driving a vehicle. Safe driving requires your full attention anything less may result in

10、an accident. RWARNING! NEVERconnect the transceiver to an AC outlet. This may pose a fi re hazard or result in an electric shock. NEVERconnect a power supply of more than 16 V DC through the optional CP-19R CIGARETTE LIGHTER CABLEto the DC 11V jack to prevent damaging the transceiver. NEVERconnect t

11、he transceiver to a power source using reverse polarity. This will ruin the transceiver. NEVERcut the DC power cable between the DC plug and fuse holder. If an incorrect connection is made after cutting, the transceiver may be damaged. NEVERexpose the transceiver to rain, snow or any liquids. The tr

12、ansceiver may be damaged. NEVERoperate or touch the transceiver with wet hands. This may result in an electric shock or ruin the transceiver. NEVERattempt to charge alkaline or dry cell batteries. Be aware that external DC power connections will charge batter- ies inside the battery case. This will

13、damage not only the bat- tery case but also the transceiver. DO NOTpush the PTT when not actually desiring to trans- mit. PRECAUTIONS iii SUPPLIED ACCESSORIES q Antenna* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 w Hand strap* . . . . . . . . . . . . . . . . . . . .

14、. . . . . . . . . . . . . . . 1 e 2251 OPT sheet*. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 r Battery pack*/Battery case* . . . . . . . . . . . . . . . . . . . . . . 1 t Belt clip* (with screws) . . . . . . . . . . . . . . . . . . . . . . . . . . 1 y AC Adapter*. . . . . . . . .

15、 . . . . . . . . . . . . . . . . . . . . . . . . . . 1 *Not supplied with some versions. y qwt e r DO NOToperate the transceiver near unshielded electrical blasting caps or in an explosive atmosphere. BE CAREFUL!The transceiver will become hot when operating it continuously for long periods. AVOIDus

16、ing or placing the transceiver in direct sunlight or in areas with temperatures below 10C (+14F) or above +60C (+140F). Place the unit in a secure place to avoid inadvertent use by children. AVOIDthe use of chemical agents such as benzine or al- cohol when cleaning, as they can damage the transceive

17、rs surfaces. Even when the transceiver power is OFF, a slight current still fl ows in the circuits. Remove the battery pack or case from the transceiver when not using it for a long time. Otherwise, the battery pack (Li-Ion: BP-227) or installed batteries will be- come exhausted. For USA only: Cauti

18、on: Changes or modifi cations to this transceiver, not ex- pressly approved by Icom Inc., could void your authority to operate this transceiver under FCC regulations. PRECAUTIONScontinued iv BP-226 BATTERY CASE Battery case for 5AA (LR6) size alkaline batteries. BP-227 LI-ION BATTERY PACK 7.2 V/1700

19、 mAh Lithium-Ion battery pack. BC-119N DESKTOP CHARGER+ AD-100CHARGER ADAPTER For rapid charging of battery packs. An AC adapter is sup- plied with the charger. Charging time: approx. 22.5 hrs. BC-121NMULTI-CHARGER+ AD-100CHARGER ADAPTER (6 pcs.) For rapid charging of up to 6 battery packs (six AD-1

20、00s are required) simultaneously. An AC adapter may be supplied depending on version. Charging time: approx. 22.5 hrs. CP-19RCIGARETTE LIGHTER CABLE WITH NOISE FILTER Used for operation and charging a battery pack connected to transceiver via a DC power source. (11.7 V15.9 V DC) MB-98BELT CLIP MB-98

21、: Same as that supplied with the transceiver. UT-108DTMF DECODER UNIT Provides pager and code squelch capabilities. SP-13 EARPHONE Provides clear receive audio in noisy environments. FA-B2E WHIP ANTENNA Same as that supplied with transceiver. HM-75A/HM-131L/HM-158LSPEAKER-MICROPHONES Combination spe

22、aker-microphones that provide convenient operation while hanging the transceiver from your belt. HM-75A has 4 function switches for remote control capabilities. HM-131L/HM-158L are equipped with an earphone jack and a revolving clip. HM-128L/HM-153L/HM-166LEARPHONE-MICROPHONE You can clip the microp

23、hone with PTT switch to your lapel or breast pocket. HS-85 HEADSET Allows you hands-free operation. Includes VOX, PTT and “one-touch” PTT with time-out timer. VS-1LPTT/VOX UNIT+HS-94 HEADSET VS-1LPTT/VOX UNIT Required when using the headset. HS-94EAR-PIECE TYPE HEADSET Earhook headset with fl exible

24、 boom microphone. CS-V85CLONING SOFTWARE+OPC-478/U/UCCLONING CABLE Provide quick and easy programming of memory channel, memory name etc. OPC-474CLONING CABLE For cloning between transceivers. LC-167 CARRYING CASE Helps protect the transceiver from scratches, etc. OPTION LIST v TABLE OF CONTENTS FOR

25、EWORD. i IMPORTANT. i EXPLICIT DEFINITIONS. i PRECAUTIONS . iiiii SUPPLIED ACCESSORIES . iii OPTION LIST . iv TABLE OF CONTENTS. vvi QUICK REFERENCE GUIDE . IVI Preparation. I Your fi rst contact. IV Repeater operation. V Programming memory channels. VI 1 ACCESSORIES. 12 Accessory attachment. 1 2 PA

26、NEL DESCRIPTION . 38 Switches, controls, keys and connectors. 3 Function display. 7 3 BATTERY PACKS. 916 Battery pack replacement . 9 Cautions . 11 Regular charging . 13 Rapid charging . 14 External DC power operation. 16 4 BASIC OPERATION. 1721 Power ON. 17 VFO mode selection. 17 Setting a frequenc

27、y. 17 Setting audio/squelch level . 19 Receive and transmit . 19 Monitor function. 19 Display type. 20 Key lock function. 20 Weather channel operation (USA version only) . 21 5 REPEATER OPERATION . 2225 General . 22 Reversed duplex mode. 22 Offset frequency. 23 Subaudible tones . 23 Repeater lockout

28、. 24 Auto repeater function (USA version only). 25 6 MEMORY/CALL OPERATION. 2631 General description. 26 Selecting a memory channel. 26 Selecting the call channel . 26 Programming the memory/call channels. 27 Channel name programming. 28 Memory transfers. 28 vi 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

29、 17 18 19 Memory bank selection. 30 Memory bank setting. 30 Transferring bank contents. 31 7 DTMF MEMORY. 3234 Programming a DTMF code sequence. 32 Transmitting a DTMF code sequence. 33 DTMF transmission rate. 34 8 SCAN OPERATION. 3538 Scan types . 35 Programmed scan. 35 Memory scan.36 Skip channels

30、. 37 Scan resume condition. 37 Priority watch. 38 9 SUBAUDIBLE TONES. 3942 Tone squelch. 39 Pocket beep operation. 41 Tone scan. 42 10PAGER/CODE SQUELCH (Requires Optional UT-108). 4346 Pager function. 43 Code programming . 43 Pager operation. 45 Code squelch. 46 11 SET MODES. 4756 SET MODE . 47 INI

31、TIAL SET MODE . 51 12SET MODE INSPECTION. 5758 13CLONING . 5960 Transceiver-to-transceiver cloning. 59 Cloning using a PC . 60 14RESETTING FUNCTIONS . 61 Partial reset. 61 CPU reset. 61 15TROUBLESHOOTING . 62 16OPTION. 63 Optional UT-108 installation. 63 17SPECIFICATIONS. 64 General . 64 Transmitter

32、. 64 Receiver. 64 18CE. 6566 I QUICK REFERENCE GUIDE Preparation D Antenna Attach the antenna to the transceiver as illustrated at right. D Belt clip Conveniently attaches to your belt. Attach the belt clip with the supplied screws using a phillips screwdriver. D Battery pack replacement Before repl

33、acing the battery pack, push and hold PWR for 1 sec. to turn the power OFF. To attach the battery pack Slide the battery pack on the back of the transceiver in the di- rection of the arrow (q), then lock it with the battery release button. Slide the battery pack until the battery release button make

34、s a click sound. To release the battery pack Push the battery release button in the direction of the arrow (w) as shown below. The battery pack is then released. w q Battery pack Battery release button To attach the belt clip II QUICK REFERENCE GUIDE Quick reference guide D Battery case optional for some versions When using a BP-226 BATTERY CASEattached to the trans- ceiver, install 5 AA (LR6) size alkaline batteries as illustrated at right. q Hook your fi nger under the latch, and open the cover in the direction of the arrow (q). (Fig.1) w Then, install 5 AA (LR6) size alkalin