ID-1_user.pdf

《ID-1_user.pdf》由会员分享，可在线阅读，更多相关《ID-1_user.pdf（116页珍藏版）》请在收音机爱好者资料库上搜索。

1、INSTRUCTION MANUAL ID-1 DIGITAL TRANSCEIVER MIC TD/RDPWRTX/RX POWER TRANSCEIVER ID-1 DIGITAL New2001 ID-1_ENG_1.qxd 03.7.22 16:17 Page 1 (1,1) i New2001 FOREWORD Thank you for purchasing this Icom product. The ID-1 DIGITAL TRANSCEIVERis designed and built with Icoms superior tech- nology and craftsm

2、anship. With proper care, this product should provide you with years of trouble-free operation. We want to take a couple of moments of your time to thank you for making your ID-1 your radio of choice, and hope you agree with Icoms philosophy of “technology fi rst.” Many hours of research and develop

3、ment went into the design of your ID- 1. DDFEATURES FM, Digital Voice and Data modes available Standard PC control application via USB terminal connection Remote controller for current mobile trans- ceiver style operation (optional for some versions) Standard 10BASE-T connector for data transmission

4、/reception IMPORTANT READ ALL INSTRUCTIONScarefully and completely before using the transceiver. SAVE THIS INSTRUCTION MANUALThis in- struction manual contains important operating instructions for the ID-1. EXPLICIT DEFINITIONS WORDDEFINITION R WARNING! CAUTION NOTE Personal injury, fi re hazard or

5、electric shock may occur. Equipment damage may occur. Recommended for optimum use. No risk of personal injury, fi re or electric shock. Icom, Icom Inc. and the logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United Kingdom, Ger- many, France, Spain, Russia and/o

6、r other countries. Microsoft and Windows are registered trademarks of Microsoft Cor- poration in the United States and/or other countries. All other products or brands are registered trademarks or trademarks of their respective holders. ID-1_ENG_1.qxd 03.7.22 16:17 Page i (1,1) RWARNING RF EXPOSURE!

7、This device emits Radio Frequency (RF)energy. Extreme caution should be ob- served when operating this device. If you have any questions re- garding RF exposure and safety standards please refer to the Federal Communications Commission Offi ce of Engineering and Technologys report on Evaluating Comp

8、liance with FCC Guide- lines for Human Radio frequency Electromagnetic Fields (OET Bulletin 65). RWARNING! NEVER connect the transceiver to an AC outlet. This may pose a fi re hazard or result in an electric shock. RWARNING! NEVER operate the transceiver while dri- ving a vehicle. Safe driving requi

9、res your full attentionanything less may result in an accident. RWARNING! NEVER transmit without an operational antenna for 1.2 GHz operation. Transmission into a shorted or non resonant antenna may damage the transceiver. NEVER cut the DC power cable between the DC plug and fuse holder. If an incor

10、rect connection is made after cutting, the transceiver may be damaged. NEVER connect the transceiver to a power source of more than 16 V DC. This will damage the transceiver. NEVER connect the transceiver to a power source using re- verse polarity. This will damage the transceiver. NEVER expose the

11、transceiver to rain, snow or any liquids. The transceiver may be damaged. NEVER operate or touch the transceiver with wet hands. This may result in an electric shock or damage the transceiver. NEVER place the transceiver where normal operation of the vehicle may be hindered or where it could cause b

12、odily injury. NEVER let objects impede the operation of the cooling fan on the rear panel. DO NOT push the PTT when not actually desiring to trans- mit. DO NOT allow children to play with any radio equipment con- taining a transmitter. During mobile operation, DO NOToperate the transceiver without r

13、unning the vehicles engine. When the transceivers power is ON and your vehicles engine is OFF, the vehicles bat- tery will soon become exhausted. BE CAREFUL! The transceiver will become hot when op- erating it continuously for long periods. ii New2001 PRECAUTION ID-1_ENG_1.qxd 03.7.22 16:17 Page ii

14、(1,1) iii New2001 PRECAUTION AVOID using or placing the transceiver in direct sunlight or in areas with temperatures below 10C (+14F) or above +60C (+140F). AVOIDthe use of chemical agents such as benzine or alcohol when cleaning, as they can damage the transceivers surfaces. USEIcom microphones onl

15、y (supplied or optional). Other man- ufacturers microphones have different pin assignments and may damage the transceiver if attached. DO NOT use the supplied CD for any other devices. The CD is for the ID-1 only. If a connection cable is disconnected or has a loose connec- tion during operation, an

16、 error may occur. Connect the con- nectors correctly, and DO NOT touch the connectors during operation. For the operation of PC and peripheral devices, follow the in- structions provided in the manuals which come with the PC and peripheral devices. This device may cause signal interference when used

17、 in a do- mestic setting. When interference occurs, move this unit as far as possible away from the affected device. All copyrights associated with this manual and all intellectual property rights associated with the hardware and software of the ID-1 are held by Icom Inc. Unauthorised reproduction o

18、r transmission of this manual, or any part hereof, is prohibited. The content of this manual, the hardware and software asso- ciated with the ID-1, and the appearance of the ID-1 are all subject to change without notice. For U.S.A. only CAUTION: Changes or modifi cations to this device, not ex- pres

19、sly approved by Icom Inc., could void your authority to operate this device under FCC regulations. ID-1_ENG_1.qxd 03.7.22 16:17 Page iii (1,1) iv New2001 SUPPLIED ACCESSORIES qMicrophone (HM-118N) 1 wExternal speaker (SP-22)1 eEthernet cable coupler 1 rDC power cable (3 m; 9.8 ft) 1 tUSB extension c

20、able (1.5 m; 4.9 ft) 1 yEthernet cable (3 m; 9.8 ft) 1 uSelf-adhesive rubber feet 1 iApplication CD 1 oRemote controller (RC-24)*1 !0Mounting bracket for remote controller*1 !1Mounting screws, nuts and washers*1 set !2Mic extension cable (2.5 m; 8.2 ft)* 1 *Optional for some versions. o!0 q !2 ew ty

21、 ui !1 r ID-1_ENG_1.qxd 03.7.22 16:17 Page iv (1,1) New2001 v TABLE OF CONTENTS FOREWORD .i IMPORTANT . i EXPLICIT DEFINITIONS . i PRECAUTION . ii SUPPLIED ACCESSORIES . iv TABLE OF CONTENTS . v 1 PANEL DESCRIPTION . 112 I Front panel . 1 I Rear panel . 2 I Microphones (HM-118N/TN) . 3 I Application

22、 screens . 4 I Remote controller (RC-24; Optional for some versions) . 9 2 INSTALLATION AND CONNECTIONS . 1317 I Unpacking . 13 I Selecting a location . 13 I Antenna connection . 13 I Power supply connections . 15 I Microphone and speaker connections . 16 I Connecting a PC . 17 3 DRIVER INSTALLATION

23、 . 1829 I MicrosoftWindowsXP . 18 I MicrosoftWindows98/Me . 22 I MicrosoftWindows2000 . 23 I COM port confi rmation . 28 4 APPLICATION INSTALLATION . 3031 5 BASIC OPERATION . 3238 I Preparation . 32 I Squelch level adjustment (FM mode only) . 33 I Audio level adjustment . 34 I VFO and memory mode .

24、34 I Setting a frequency . 35 I Tuning step selection . 37 I Lock function (RC-24 only) . 38 I Operating mode selection . 38 6 CALL SIGN PROGRAMMING . 3944 I Your call sign programming . 39 I Station/Repeater call sign programming . 42 7 TRANSMIT AND RECEIVE VOICE . 4550 I FM mode operation . 45 I D

25、igital voice mode operation . 45 I When receiving a Digital call. 47 I S-meter squelch . 48 I AFC function . 49 I Monitor function . 49 8 REPEATER OPERATION VOICE . 5159 I About D-STAR system . 51 I General . 52 I Accessing an FM repeater . 53 I Repeater tone frequency setting. 55 I Offset frequency

26、 setting . 56 I Accessing a Digital repeater . 57 9 DATA OPERATION . 6066 I General . 60 I Precaution . 60 I Internet access . 61 I Data transferring . 64 ID-1_ENG_1.qxd 03.7.22 16:17 Page v (1,1) New2001 vi I Slow data communication . 66 10MEMORY/CALL OPERATION . 6778 I General description . 67 I M

27、emory channel selection. 67 I Call channel selection . 68 I Programming a memory/call channel . 70 I Copying a memory contents . 73 I Memory clearing . 74 I Programming memory name . 76 I Memory name indication . 78 11SCAN OPERATION . 7985 I Scan types . 79 I Scan start/stop . 80 I Programming scan

28、edge channels . 81 I Skip channel setting . 84 I Scan resume condition . 85 12PRIORITY WATCH. 8687 I Priority watch types . 86 I Priority watch operation . 86 13POCKET BEEP AND TONE/DIGITAL SQUELCH . 8895 I Pocket beep operation . 88 I Tone/Digital code/call sign squelch operation . 92 14OTHER FUNCT

29、IONS . 96104 I Set mode . 96 I Emergency communication . 101 I Break-in communication . 102 I CPU reset . 104 15MAINTENANCE . 105106 I Troubleshooting . 105 I Fuse replacement . 106 16SPECIFICATIONS AND OPTIONS . 107108 I Specifi cations . 107 I Options . 108 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 I

30、D-1_ENG_1.qxd 03.7.22 16:17 Page vi (1,1) I Front panel qMICROPHONE CONNECTOR MIC Connects the supplied microphone or the remote con- troller, RC-24 (optional for some versions). q +8 V DC output (Max. 100 mA) w Channel up/down e Data out r PTT t GND (microphone ground) y MIC (microphone input) u GN

31、D i Data IN wDATA TRANSMIT/RECEIVE INDICATOR Lights green while receiving; lights red while transmitting data in DD mode. ePOWER INDICATOR Lights while the transceiver power is turned ON. rTRANSMIT/RECEIVE INDICATOR Lights green while receiving; lights red while transmitting in FM/digital voice mode

32、. tPOWER SWITCH POWER Turns power ON and OFF when pushed for 1 sec. qi MIC TD/RDPWRTX/RX POWER TRANSCEIVER ID-1 DIGITAL qewrt 1 PANEL DESCRIPTION New2001 1 ID-1_ENG_1.qxd 03.7.22 16:17 Page 1 (1,1) 2 1PANEL DESCRIPTION New2001 1I Rear panel qETHERNET RECEPTACLE (p. 17) Connects to a PC directly, or

33、via an extension cable. wEXTERNAL SPEAKER JACK SP (p. 16) Connects the supplied (or optional) external speaker for voice reception. eCOOLING FAN The fan rotates when the internal temperature of the trans- ceiver exceeds the preset value until the temperature drops. Also runs while receiving dependin

34、g on the setting in set mode. rANTENNA CONNECTOR (p. 13) Connects a 50 antenna with a type-N connector and a 50 coaxial cable. tUSB RECEPTACLE(p. 17) Connects to a PC directly or via an extension cable. yPOWER RECEPTACLE(p. 15) Accepts 13.8 V DC 15% with the supplied DC power cable. qewr ty ID-1_ENG

35、_1.qxd 03.7.22 16:17 Page 2 (1,1) 3 1PANEL DESCRIPTION New2001 I Microphones(HM-118N/TN) qPTT SWITCH Push and hold to transmit; release to receive. wUP/DOWN SWITCHES UP/DN Push either switch to change operating frequency, mem- ory channel, etc. eUP/DN LOCK SWITCH Slide to toggle UP/DN switches function ON and OFF. rKEYPAD (HM-118TN onl