IC-FR3000_IC-FR4000_user.pdf

《IC-FR3000_IC-FR4000_user.pdf》由会员分享，可在线阅读，更多相关《IC-FR3000_IC-FR4000_user.pdf（24页珍藏版）》请在收音机爱好者资料库上搜索。

1、INSTRUCTION MANUAL VHF FM REPEATER iFR3000 UHF FM REPEATER iFR4000 Downloaded by? RadioAmateur.EU i IMPORTANT READ THIS INSTRUCTION MANUAL CAREFULLYbefore attempting to operate the re- peater. SAVE THIS INSTRUCTION MANUALThis manual contains important safety and operating in- structions for the IC-F

2、R3000/FR4000 series. EXPLICIT DEFINITIONS RWARNING HIGH VOLTAGE! NEVERat- tach an antenna or internal antenna connector during transmission. This may result in an electrical shock or burn. RWARNING HIGH VOLTAGE! NEVERinstall the antenna at any place that person touch the an- tenna easily during tran

3、smission. This may result in an electrical shock or burn. RNEVERapply AC to the BATTERY terminals on the repeater rear panel. This could cause a fire or damage the repeater. RNEVERapply more than 16 V DC, such as a 24 V battery, to the BATTERY terminals on the repeater rear panel. This could cause a

4、 fi re or damage the re- peater. RNEVERlet metal, wire or other objects touch any internal part or connectors on the rear panel of the re- peater. This may result in an electric shock. RNEVERexpose the repeater to rain, snow or any liquids. AVOID using or placing the repeater in areas with tem- pera

5、tures below 30C (22F) or above +60C (+140F). Be aware that temperatures on a vehicles dashboard can exceed 80C (+176F), resulting in per- manent damage to the repeater if left there for ex- tended periods. AVOID placing the repeater in excessively dusty envi- ronments or in direct sunlight. AVOID pu

6、tting anything on top of the repeater. This will obstruct heat dissipation. Place the repeater in a secure place to avoid inadver- tent use by children. BE CAREFUL! The heatsink will become hot when op- erating the repeater continuously for long periods. BE CAREFUL! If a linear amplifier is connecte

7、d, set the repeaters RF output power to less than the linear amplifi ers maximum input level, otherwise, the linear amplifi er will be damaged. Use Icom microphones only (optional). Other manu- facturers microphones have different pin assignments, and connection to the IC-FR3000/FR4000 series may da

8、mage the repeater. For U.S.A. only CAUTION: Changes or modifi cations to this repeater, not expressly approved by Icom Inc., could void your authority to operate this repeater under FCC regula- tions. CAUTION: This repeater is intended for use as a fi xed base station with the antenna located outdoo

9、rs on the rooftop or on antenna tower. PRECAUTION WORD R WARNING CAUTION NOTE DEFINITION Personal injury, fire hazard or electric shock may occur. Equipment damage may occur. If disregarded, inconvenience only. No risk of personal injury, fire or electric shock. Icom, Icom Inc. and the logo are regi

10、stered trademarks of Icom Incorporated (Japan) in the United states, the United Kingdom, Germany, France, Spain, Russia and/or other coun- tries. ii For U.S.A. This equipment complies with the Federal Communi- cations Commission (FCC) rules and regulations gov- erning telephone equipment and the Tec

11、hnical Requirements for Connection to the Telephone Net- work published by the industrys Administrative Council for Terminal Attachments (ACTA). On the right side of this equipment is a label that contains, among other in- formation, a product identifier in the format US:ICMOT03BIC-FR4000. If reques

12、ted, this number must be provided to the telephone company. The applicable certifi cation jack (connector) USOC-RJ- 11C is used for this equipment. This device can only be connected to the Public Switched Telephone Network (PSTN) using a tele- phone cord and modular plug that is compliant with the c

13、riteria adopted by the ACTA. This equipment is de- signed for connection to the telephone network or premises wiring using a compatible modular jack that is also compliant. The Ringer Equivalence Number (or REN) is used to determine the number of devices that may be con- nected to a telephone line.

14、Excessive RENs on a tele- phone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of RENs should not exceed fi ve (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the

15、local telephone company. The REN for this product is printed on the product identifi er label CAUTION: If this equipment is deemed potentially harmful to the telephone network, the telephone com- pany will attempt to notify you in advance of discontin- uing service. If advance notice is not practica

16、l, the telephone company will notify you as soon as possi- ble. If service is disconnected, you will be advised of your right to fi le a complaint with the Federal Commu- nications Commission (FCC) should you believe it nec- essary. The telephone company may make changes in its fa- cilities, equipme

17、nt, operations or procedures that could affect the operation of this equipment. Should this occur, advance notice you be provided in order for you to make necessary modifi cations to maintain uninter- rupted service. Should you experience trouble with this equipment, please contact: ICOM America, Te

18、chnical Support at 425-454-7619 for repair or warranty information. If the equipment is causing harm to the telephone network, the telephone company may request that you discon- nect the equipment until the problem is resolved. There are no user serviceable parts for a telephone cir- cuit inside of

19、this IC-FR3000 or IC-FR4000. NOTICE: Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information. If your home has specially wired alarm equipment con- nected to the telephone line, ens

20、ure the installation of this IC-FR3000 or IC-FR4000 does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone com- pany or a qualifi ed installer. For CANADA NOTICE: This equipment meets the applicable Indus- try Canada Terminal Equi

21、pment Technical Specifica- tions. This is confirmed by the registration number. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifi cations were met. It does not imply th

22、at Industry Canada approved the equipment. NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is 0.3. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be con- nected to a telephone interface. The termination on an i

23、nterface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed fi ve. DECLARATION OF CONFORMITY iii FORWARD Thank you for purchasing this Icom product. The IC- FR3000/FR4000 VHF/UHF FM REPEATERis de

24、signed and built with Icoms state of the art technology and craftsmanship. With proper care, this product should provide you years of trouble-free operation. We want to take a couple of moments of your time to thank you for making the IC-FR3000/FR4000 your re- peater of choice, and hope you agree wi

25、th Icoms phi- losophy of “technology fi rst.” Many hours of research and development went into the design of your IC- FR3000/FR4000 series. DFEATURES 50 W continuous full duty cycle operation This repeater looks as good as it performs. A rugged heatsink, large cooling fans and a high performance pow

26、er module provide the repeater with a stable 50 W at full duty cycle operation. Automatic battery backup system A built-in backup system supports automatic switch- ing to an external power supply (13.6 V DC) if the AC power supply fails. Multiple CTCSS 26 lb 7 oz Transmitter RF output power:50 W Mod

27、ulation system:Variable reactance frequency modulation system Max. frequency deviation : 5.0 kHz (Wide), 2.5 kHz (Narrow) Spurious emissions: 70 dB Adjacent channel power:More than 70 dB (Wide), More than 60 dB (Narrow) Audio harmonic distortion :3.0% typical (at 1 kHz, 40% deviation) Hum and noise:

28、More than 40 dB (Wide), More than 34 dB (Narrow) Microphone impedance:600 (8-pin modular) Receiver Receive system:Double conversion superheterodyne system Sensitivity (12 dB SINAD) :0.25 V typical Intermediate frequencies :1st; 31.65 MHz, 2nd; 455 kHz Adjacent channel selectivity:More than 70 dB (Wi

29、de), More than 60 dB (Narrow) Spurious response :More than 70 dB Intermodulation:More than 70 dB Hum and noise :More than 40 dB (Wide), More than 34 dB (Narrow) Audio output power:2.5 W typical at 10% distortion with a 4 load External speaker connector:2-conductor 3.5 (d) mm (18) 4 DDIC-FR4000 Gener

30、al Frequency coverage :400.000430.000 MHz* 430.000450.000 MHz* 450.000480.000 MHz* * Depends on version Channel specing:12.5/25.0 kHz (Narrow/Wide) PLL channel step:5.0, 6.25 kHz Frequency stability:1.5 ppm*/2.5 ppm* * Depends on version Number of channels:Max. 32 channel Antenna connector:Type-N2 (

31、50 ) Operating temp. range:30C to +60C (22F to +140F) Power supply voltage:100120 V AC (50/60 Hz)* 220240 V AC (50/60 Hz)* 13.6 V DC (negative ground) * Depends on version Current drain (at 13.6 V):TX high (50 W)20.0 A Max. audio2.0 A Stand-by1.0 A Dimensions :410(W)110(H)360(D) mm (Projections not

32、included)1613(W)413(H)1414(D) in Weight (approx.):12 kg; 26 lb 7 oz All stated specifi cations are subject to change without notice or obligation. Downloaded by? RadioAmateur.EU 16 6SPECIFICATION AND OPTIONS Transmitter RF output power:50 W Modulation system:Variable reactance frequency modulation s

33、ystem Max. frequency deviation : 5.0 kHz (Wide), 2.5 kHz (Narrow) Spurious emissions: 70 dB Adjacent channel power:More than 70 dB (Wide), More than 60 dB (Narrow) Audio harmonic distortion :3.0% typical (at 1 kHz, 40% deviation) Hum and noise:More than 40 dB (Wide), More than 34 dB (Narrow) Microph

34、one impedance:600 (8-pin modular) Receiver Receive system:Double conversion superheterodyne system Sensitivity (12 dB SINAD) :0.25 V typical Intermediate frequencies :1st; 70.0 MHz, 2nd; 455 kHz Adjacent channel selectivity:More than 70 dB (Wide), More than 60 dB (Narrow) Spurious response :More tha

35、n 70 dB Intermodulation:More than 70 dB Hum and noise :More than 40 dB (Wide), More than 34 dB (Narrow) Audio output power:2.5 W typical at 10% distortion with a 4 load External speaker connector:2-conductor 3.5 (d) mm (18) 4 I Options MB-77 WALL MOUNT BRACKET (p. 10) For mounting the repeater to a

36、wall. MB-78 19 INCH RACK MOUNT BRACKET (pgs. 9, 10) For mounting the repeater into a 19 inch rack. HM-100N HAND MICROPHONE HM-100TN DTMF MICROPHONE Hand microphone with a DTMF keypad. SM-25 DESKTOP MICROPHONE UT-109 (#01) VOICE SCRAMBLER UNIT (p. 11) Non-rolling type (max. 32 codes). UT-110 (#01) VO

37、ICE SCRAMBLER UNIT (p. 11) Rolling type (max. 1020 codes). The scrambler systems of the UT-109 and UT-110 are not compatible with each other. Downloaded by? RadioAmateur.EU 17 MEMO 18 MEMO Count on us! 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003 Japan A-6228H-1EX-w Printed in Japan 2003 Icom Inc. Downloaded by? RadioAmateur.EU