TS-590SG_user_2014.pdf

《TS-590SG_user_2014.pdf》由会员分享，可在线阅读，更多相关《TS-590SG_user_2014.pdf（96页珍藏版）》请在收音机爱好者资料库上搜索。

1、 B5A-0180-00 (K, E) INSTRUCTION MANUAL HF/50MHz TRANSCEIVER TS-590SG COPYRIGHTS FOR THIS MANUAL JVC KENWOOD Corporation shall own all copyrights and other intellectual properties for the product and the software and for all manuals and documents attached to the product and the software. A user is re

2、quired to obtain approval from JVC KENWOOD corporation, in writing, prior to redistributing this document on a personal web page or via packet communication. A user is prohibited from assigning, renting, leasing or reselling the document. JVC KENWOOD Corporation does not warrant that quality and fun

3、ctions described in this manual comply with each users purpose of use and, unless specifi cally described in this manual, JVC KENWOOD Corporation shall be free from any responsibility for any defects and indemnities for any damages or losses. INDEMNITY JVC KENWOOD Corporation takes all appropriate m

4、easures to ensure all descriptions in this manual are accurate; however, this manual may still contain typographical errors (“typos”) and expressions that are misleading. JVC KENWOOD Corporation is entirely free from any responsibilities arising from any losses or damages caused by such typos or exp

5、ressions. JVC KENWOOD Corporation has the right to change or improve the product specifi cations, etc., described in this manual without prior notice. JVC KENWOOD Corporation is entirely free from any responsibilities for any losses or damages caused by such changes and improvements. JVC KENWOOD Cor

6、poration is entirely free from any responsibilities for any failures, damages or losses arising from, or in connection with, use of the transceiver with or connected to any external equipment. JVC KENWOOD Corporation does not warrant that the quality and functions described in this manual comply wit

7、h your purpose of use and, unless specifi cally described in this manual, JVC KENWOOD Corporation shall be free from any responsibilities for any defects and indemnities for any damages or losses. Selection and installation of any external equipment shall be done at your own risk. You are fully resp

8、onsible for the use and effects of external equipment. JVC KENWOOD Corporation shall be free from any responsibilities for any incidental losses or damages, such as missing communications or call opportunities caused by a failure or performance error of the transceiver. Bu rn 28300 sayl Resmi Gazete

9、de yaymlanan Atik Elektrikli ve Elektronik Eyalarin Kontrol Ynetmelie uygun olarak retilmitir. Eski Elektrikli ve Elektronik Cihazlarn ve Pillerin İmhas Hakknda Bilgi (ayr atk toplama sistemlerine sahip olan lkelerde geerlidir) Bu sembol (zeri izili p bidonu) ieren rn ve piller evsel at k pleri ile

10、birlikte atlamaz. Kullanlm elektrikli ve elektronik cihaz ve piller, bu tr maddeleri ve bunlarn yan rnlerini i lemeye elverili bir geri kazanm tesisine gnderilmelidir. Size en yakn geri kazanm tesisinin konumunu renmek zere yerel yetkililerinize dann. Doru geri kazanm ve atk uzaklatrma y ntemleri, s

11、adece z kaynaklarn korunmasna yardmc olmakla kalmayp ayrca salmza ve evreye olacak zararl etkilerini engellemeye yardmc olur. Uyar: Pilin alt tarafnda bulunan “Pb” iareti, bu pillin kurun ierdiini belirtir. i THANK YOU Thank you for choosing this KENWOOD TS-590SG transceiver. It has been developed b

12、y a team of engineers determined to continue the tradition of excellence and innovation in KENWOOD transceivers. This transceiver features a Digital Signal Processing (DSP) unit to process IF and AF signals. By taking maximum advantage of DSP technology, the TS- 590SG transceiver gives you enhanced

13、interference reduction capabilities and improves the quality of audio. You will notice the differences when you fi ght QRM and QRN. As you learn how to use this transceiver, you will also fi nd that KENWOOD is pursuing “user friendliness”. For example, each time you change the Menu No. in Menu mode,

14、 you will see scrolling messages on the display, telling you what you are selecting. Though user friendly, this transceiver is technically sophisticated and some features may be new to you. Consider this manual to be a personal tutorial from the designers. Allow the manual to guide you through the l

15、earning process now, then act as a reference in the coming years. FEATURES All mode operation from HF to 50 MHz amateur radio band 500 Hz/ 2.7 kHz roofi ng fi lter Superior C/N response by the DDS largely decreases the noise of the undesired signal. IF DSP through the adoption of 32-bit fl oating po

16、int DSP Digital Noise Blanker PC interface via a Universal Serial Bus port (B-type) Drive output/ RX Antenna output Direct band keys Built-in Antenna Tuner Morse Code Decoder 100 W output power for SSB, CW, FSK, FM, and 25 W output power for AM. NOTICE TO THE USER One or more of the following statem

17、ents may be applicable for this equipment. FCC WARNING This equipment generates or uses radio frequency energy. Changes or modifi cations to this equipment may cause harmful interference unless the modifi cations are expressly approved in the instruction manual. The user could lose the authority to

18、operate this equipment if an unauthorized change or modifi cation is made. INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pr

19、ovide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can generate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is

20、 no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more o

21、f the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Consult the dealer for technical assistance. This device complies

22、with Industry Canada license exempt RSS standard(s). Operation is subject to the following two conditions : (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This product is designed

23、for connection to an IT power distribution system. Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for countries that have adopted separate waste collection systems) Products and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as ho

24、usehold waste. Old electrical and electronic equipment and batteries should be recycled at a facility capable of handling these items and their waste byproducts. Contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help cons

25、erve resources whilst preventing detrimental effects on our health and the environment. Firmware Copyrights The title to and ownership of copyrights for fi rmware embedded in KENWOOD product memories are reserved for JVC KENWOOD Corporation. NOTIFICATION This equipment complies with the essential re

26、quirements of Directive 1999/5/EC. The use of the warning symbol means the equipment is subject to restrictions of use in certain countries. This equipment requires a licence and is intended for use in the countries below. ATBEDKFIFRDEGRISIE ITLILUNLNOPTESSECH GBCYCZEEHULVLTMTPL SKSIBGROHR ISO3166 i

27、i BEFORE STARTING Amateur radio regulations vary from country to country. Confi rm your local amateur radio regulations and requirements before operating the transceiver. Depending on the size and type of vehicle, the maximum transmission output power for the mobile operation will vary. The maximum

28、transmission output power is usually specifi ed by the car manufacturer to avoid interference with other electric devices used in the vehicle. Consult your car manufacturer and amateur radio equipment dealer for the requirements and installation. MARKET CODES K-type: The Americas E-type: Europe The

29、market code is shown on the carton box. Refer to the specifi cations page 86 for information on the available operating frequencies. WRITING CONVENTIONS FOLLOWED The writing conventions described below have been followed to simplify instructions and avoid unnecessary repetition. InstructionAction Pr

30、ess KEY.Press and release KEY. Press Mic KEY. Press and release KEY on the microphone. Press and hold KEY. Press and hold KEY down for a moment, then release KEY. Hold KEY. Press and hold KEY down until instructed to release KEY. Press KEY + . With the transceiver power OFF, press and hold KEY, then

31、 switch the transceiver power ON by pressing . SUPPLIED ACCESSORIES After carefully unpacking the transceiver, identify the items listed in the table below. We recommend you keep the box and packing materials in case you need to repack the transceiver in the future. AccessoryComment Quantity K-typeE

32、-type Microphone11 DC power cable11 Fuse 25 A; for DC power cable 11 Fuse 4 A; for an external antenna tuner 11 DIN plug 7-pin (For REMOTE connector) 11 DIN plug 13-pin (For ACC2 connector) 11 Screw setFor bracket11 Plastic spacerFor bracket44 Instruction Manual English11 French11 Spanish1 Italian1

33、German1 Dutch1 Schematic diagram 2 Warranty Card11 iii PRECAUTIONS Please observe the following precautions to prevent fi re, personal injury, and transceiver damage: Connect the transceiver only to a power source as described in this manual or as marked on the transceiver itself. Route all power ca

34、bles safely. Ensure the power cables can neither be stepped upon nor pinched by items placed near or against the cables. Pay particular attention to locations near AC receptacles, AC outlet strips, and points of entry to the transceiver. Take care not to drop objects or spill liquid into the transce

35、iver through enclosure openings. Metal objects, such as hairpins or needles, inserted into the transceiver may contact voltages resulting in serious electrical shocks. Never permit children to insert any objects into the transceiver. Do not attempt to defeat methods used for grounding and electrical

36、 polarization in the transceiver, particularly involving the power input cable. Adequately ground all outdoor antennas for this transceiver using approved methods. Grounding helps protect against voltage surges caused by lightning. It also reduces the chance of a build-up of static charge. EXAMPLE O

37、F ANTENNA GROUNDING ANTENNA LEAD IN WIRE GROUND CLAMP ELECTRIC SERVICE EQUIPMENT ANTENNA DISCHARGE UNIT GROUNDING CONDUCTORS GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM Minimum recommended distance for an outdoor antenna from power lines is one and one-half times the vertical height of th

38、e associated antenna support structure. This distance allows adequate clearance from the power lines if the support structure fails for any reason. Locate the transceiver so as not to interfere with its ventilation. Do not place books or other equipment on the transceiver that may impede the free mo

39、vement of air. Allow a minimum of 10 cm (4 inches) between the rear of the transceiver and the wall or operating desk shelf. Do not use the transceiver near water or sources of moisture. For example, avoid use near a bathtub, sink, swimming pool, or in a damp basement or attic. The presence of an un

40、usual odor or smoke is often a sign of trouble. Immediately turn the power OFF and remove the power cable. Contact a KENWOOD service station or your dealer for advice. Locate the transceiver away from heat sources such as a radiator, stove, amplifi er or other devices that produce substantial amount

41、s of heat. Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzene to clean the cabinet of the transceiver. Use only a clean cloth with warm water or a mild detergent. Disconnect the input power cable from the power source when the transceiver is not used for long periods o

42、f time. Remove the transceivers enclosure only to do accessory installations described in this manual or accessory manuals. Follow provided instructions carefully, to avoid electrical shocks. If unfamiliar with this type of work, seek assistance from an experienced individual, or have a professional

43、 technician do the task. Enlist the services of qualifi ed personnel in the following cases: a) The power supply or plug is damaged. b) Objects have fallen into or liquid has spilled into the transceiver. c) The transceiver has been exposed to rain. d) The transceiver is operating abnormally or perf

44、ormance has seriously degraded. e) The transceiver has been dropped or the enclosure damaged. Do not attempt to perform any kind of confi guration or menu setup while driving. Do not wear headphones while driving. Install the transceiver in a safe and convenient position inside your vehicle so as no

45、t to subject yourself to danger while driving. Consult your car dealer for the transceiver installation to ensure safety. HF/ 50 MHz mobile antennas are larger and heavier than VHF/ UHF antennas. Therefore, use a strong and rigid mount to safely and securely install the HF/ 50 MHz mobile antenna. Do

46、 not put the plastic bag used for packing of this equipment on the place which reaches a small childs hand. It will become a cause of suffocation if it wears fl atly. iv CONTENTS CARRIER LEVEL .23 CHAPTER 6 ENHANCED COMMUNICATIONS SPLIT-FREQUENCY OPERATION .24 DIRECTLY ENTERING THE FREQUENCY SPLIT S

47、PECIFIED BY A DXer .24 TURN THE TUNING CONTROL TO SEARCH FOR THE TRANSMIT FREQUENCY .24 TF-SET (TRANSMISSION FREQUENCY SET) .24 SHIFTABLE RX FREQUENCY DURING SPLIT TRANSMISSION .25 FM REPEATER OPERATION .25 TRANSMITTING A TONE .26 Activating the Tone Function .26 Selecting a Tone Frequency .26 TONE FREQUENCY ID SCAN .26 FM CTCSS OPERATION .27 CTCSS FREQUENCY ID SCAN .27 CROSS TONE .28 CHAPTER 7 COMMUNICATING AIDS RECEPTION .