AN-ARM-109_test_set_repair_parts_TM11-6625-1636-20P_1981.pdf
《AN-ARM-109_test_set_repair_parts_TM11-6625-1636-20P_1981.pdf》由会员分享,可在线阅读,更多相关《AN-ARM-109_test_set_repair_parts_TM11-6625-1636-20P_1981.pdf(16页珍藏版)》请在收音机爱好者资料库上搜索。
1、TM 11-6625-1636-20P TECHNICAL MANUAL ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LISTS FOR TEST SET, ANTENNA COUPLER AN/ARM-109 (NSN 6625-00-903-6385) H E A D Q U A R T E R S , D E P A R T M E N T O F T H E A R M Y 6 February 1981 *TM 11-6625-1636-20P TECHNICAL MANUAL HEADQUARTERS DEPA
2、RTMENT OF THE ARMY No. 11-6625-1636-20WASHINGTON, DC, 6 February 1981 ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST FOR TEST SET, ANTENNA COUPLER AN/ARM-109 (NSN 6625-00-903-6385) Current as of 25 September 1980 REPORTING ERRORS AND RECOMMENDING IMPROVEMENTS You can help improve thi
3、s manual. If you find any mistakes or if you know of a way to improve the procedures, please let us know. Mail your letter, DA Form 2028 (Recommended Changes to Publications and Blank Forms), or DA Form 2028-2 located in back of this manual direct to: Commander, US Army Communications and Electronic
4、s Materiel Readiness Command, ATTN: DRSEL-ME-MQ, Fort Monmouth, NJ 07703. In either case, a reply will be furnished to you. TABLE OF CONTENTS Illus PageFigure SECTIONI.Introduction . 1 II.Repair Parts List. 5 GROUP00Test Set, Antenna Coupler AN/ARM-102.1 01Antenna Coupler Control Tester TS-2353/ARM-
5、109 .2 02Control, Amplifier Electronic TS-2354/ARM-109 9.4 03Discriminator Tester TS-2352/ARM-109 .6 04Cables and Connectors (No parts authorized) SECTIONIII.Special Tools List (Not applicable) IV.National Stock Number and Part Number Index . 12 *This manual supersedes TM 11-6625-1636-20P, 14 Septem
6、ber 1978. TM 11-6625-1636-20P SECTION I INTRODUCTION 1. Scope This manual lists spares and repair parts; special tools; special test, measurement, and diagnostic equipment (TMDE), and other special support equipment required for performance of organizational maintenance of the AN/ARM-109. It authori
7、zes the requisitioning and issue of spares and repair parts as indicated by the source and maintenance codes. 2. General This Repair Parts and Special Tools List is divided into the following sections: a.Section II. Repair Parts List. A list of spares and repair parts authorized for use in the perfo
8、rmance of maintenance. The list also includes parts which must be removed for replacement of the authorized parts. Parts lists are composed of functional groups in numeric sequence, with the parts in each group listed in figure and item number sequence. b. Section III. Special Tools List. Not applic
9、able. c.Section IV. National Stock Number and Part Number Index. A list, in National item identification number (NIIN) sequence, of all National stock numbers (NSN) appearing in the listings, followed by a list, in alphameric sequence, of all part numbers appearing in the listings. National stock nu
10、mbers and part numbers are cross-referenced to each illustration figure and item number appearance. 3. Explanation of Columns a. illustration. This column is divided as follows: (1) Figure number. Indicates the figure number of the illustration on which the item is shown. (2) Item number. The number
11、 used to identify item called out in the illustration. b.Source, Maintenance, and Recoverability (SMR) Codes. (1) Source code. Source codes indicate the manner of acquiring support items for maintenance, repair, or overhaul of end items. Source codes are entered in the first and second positions of
12、the Uniform SMR Code format as follows: Code Definition PA-Item procured and stocked for anticipated or known usage. XD-A support item that is not stocked. When required, item will be procured through normal supply channels. NOTE Cannibalization or salvage may be used as a source of supply for any i
13、tems source coded above except those coded XA and aircraft support items as restricted by AR 700-42. (2)Maintenance code. Maintenance codes are assigned to indicate the levels of maintenance authorized to USE and REPAIR support items. The maintenance codes are entered in the third and fourth positio
14、ns of the Uniform SMR Code format as follows: (a)The maintenance code entered in the third position will indicate the lowest maintenance level authorized to remove, replace, and use the support item. The maintenance code entered in the third position will indicate one of the following levels of main
15、tenance: CodeApplication/Explanation O - Support item is removed, replaced, used at the organizational level. (b) The maintenance code entered in the fourth position indicates whether the item is to be repaired and identifies the lowest maintenance level with the capability to perform complete repai
16、r (i.e., all authorized maintenance functions). This position will contain one of the following maintenance codes: CodeApplication/Explanation H - The lowest maintenance level capable of complete repair of .the support item is the general support level. Z - Nonreparable. No repair is authorized. (3)
17、 Recoverability code. Recoverability codes are assigned to support items to indicate the disposition action on unserviceable items. The recoverability code is entered in the fifth position of the Uniform SMR Code format as follows: Recoverability CodesDefinition Z-Nonreparable item. When unserviceab
18、le, condemn and dispose at the level indicated in position 3. H - Reparable item. When uneconomically reparable, condemn and dispose at the general support level. c.National Stock Number. Indicates the National stock number assigned to the item and will be used for requisitioning purposes. d.Part Nu
19、mber. Indicates the primary number used by the manufacturer (individual, company, firm, corporation, or Government activity), which controls the design and characteristics of the item by means of its 1 TM 11-6625-1636-20P engineering drawings, specifications, standards, and inspection requirements t
20、o identify an item or range of items. NOTE When a stock numbered item is requisitioned, the repair part received may have a different part number than the part being replaced. e. Federal Supply Code for Manufacturer (FSCM). The FSCM is a 5-digit numeric code listed in SB 708-1/ 42 which is used to i
21、dentify the manufacturer, distributor, or Government agency, etc. f.Description. Indicates the Federal item name and, if required, a minimum description to identify the item. g.Unit of Measure (U/M). Indicates the standard of the basic quantity of the listed item as used in performing the actual mai
22、ntenance function. This measure is expressed by a two-character alphabetical abbreviation (e.g., ea, in, pr, etc). When the unit of measure differs from the unit of issue, the lowest unit of issue that will satisfy the required units of measure will be requisitioned. h.Quantity Incorporated in Unit.
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- AN ARM 109 _test_set_repair_parts_TM11 6625 1636 20 P_1981
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。
链接地址:http://www.radiofans.cn/p-196928.html



Marshall-9100-62-02-Schematic电路原理图.pdf
BRAUN 137gw.gif
Alga 21 - Karta Gwarancyjna.zip


