TS-590SG_user_2019.pdf

《TS-590SG_user_2019.pdf》由会员分享，可在线阅读，更多相关《TS-590SG_user_2019.pdf（100页珍藏版）》请在收音机爱好者资料库上搜索。

1、B5A-0180-20 (K, E) INSTRUCTION MANUAL HF/50MHz TRANSCEIVER TS-590SG COPYRIGHTS FOR THIS MANUAL JVC KENWOOD Corporation shall own all copyrights and other intellectual properties for the product and the software and for all manuals and documents attached to the product and the software. A user is req

2、uired to obtain approval from JVC KENWOOD corporation, in writing, prior to redistributing this document on a personal web page or via packet communication. A user is prohibited from assigning, renting, leasing or reselling the document. JVC KENWOOD Corporation does not warrant that quality and func

3、tions described in this manual comply with each users purpose of use and, unless specifi cally described in this manual, JVC KENWOOD Corporation shall be free from any responsibility for any defects and indemnities for any damages or losses. INDEMNITY JVC KENWOOD Corporation takes all appropriate me

4、asures to ensure all descriptions in this manual are accurate; however, this manual may still contain typographical errors (“typos”) and expressions that are misleading. JVC KENWOOD Corporation is entirely free from any responsibilities arising from any losses or damages caused by such typos or expr

5、essions. JVC KENWOOD Corporation has the right to change or improve the product specifi cations, etc., described in this manual without prior notice. JVC KENWOOD Corporation is entirely free from any responsibilities for any losses or damages caused by such changes and improvements. JVC KENWOOD Corp

6、oration is entirely free from any responsibilities for any failures, damages or losses arising from, or in connection with, use of the transceiver with or connected to any external equipment. JVC KENWOOD Corporation does not warrant that the quality and functions described in this manual comply with

7、 your purpose of use and, unless specifi cally described in this manual, JVC KENWOOD Corporation shall be free from any responsibilities for any defects and indemnities for any damages or losses. Selection and installation of any external equipment shall be done at your own risk. You are fully respo

8、nsible for the use and effects of external equipment. JVC KENWOOD Corporation shall be free from any responsibilities for any incidental losses or damages, such as missing communications or call opportunities caused by a failure or performance error of the transceiver. Bu rn 28300 sayl Resmi Gazeted

9、e yaymlanan Atik Elektrikli ve Elektronik Eyalarin Kontrol Ynetmelie uygun olarak retilmitir. Eski Elektrikli ve Elektronik Cihazlarn ve Pillerin İmhas Hakknda Bilgi (ayr atk toplama sistemlerine sahip olan lkelerde geerlidir) Bu sembol (zeri izili p bidonu) ieren rn ve piller evsel at k pleri ile b

10、irlikte atlamaz. Kullanlm elektrikli ve elektronik cihaz ve piller, bu tr maddeleri ve bunlarn yan rnlerini i lemeye elverili bir geri kazanm tesisine gnderilmelidir. Size en yakn geri kazanm tesisinin konumunu renmek zere yerel yetkililerinize dann. Doru geri kazanm ve atk uzaklatrma y ntemleri, sa

11、dece z kaynaklarn korunmasna yardmc olmakla kalmayp ayrca salmza ve evreye olacak zararl etkilerini engellemeye yardmc olur. i THANK YOU Thank you for choosing this KENWOOD TS-590SG transceiver. It has been developed by a team of engineers determined to continue the tradition of excellence and innov

12、ation in KENWOOD transceivers. This transceiver features a Digital Signal Processing (DSP) unit to process IF and AF signals. By taking maximum advantage of DSP technology, the TS- 590SG transceiver gives you enhanced interference reduction capabilities and improves the quality of audio. You will no

13、tice the differences when you fi ght QRM and QRN. As you learn how to use this transceiver, you will also fi nd that KENWOOD is pursuing “user friendliness”. For example, each time you change the Menu No. in Menu mode, you will see scrolling messages on the display, telling you what you are selectin

14、g. Though user friendly, this transceiver is technically sophisticated and some features may be new to you. Consider this manual to be a personal tutorial from the designers. Allow the manual to guide you through the learning process now, then act as a reference in the coming years. FEATURES All mod

15、e operation from HF to 50 MHz amateur radio band 500 Hz/ 2.7 kHz roofi ng fi lter Superior C/N response by the DDS largely decreases the noise of the undesired signal. IF DSP through the adoption of 32-bit fl oating point DSP Digital Noise Blanker PC interface via a Universal Serial Bus port (B-type

16、) Drive output/ RX Antenna output Direct band keys Built-in Antenna Tuner Morse Code Decoder 100 W output power for SSB, CW, FSK, FM, and 25 W output power for AM. NOTICE TO THE USER One or more of the following statements may be applicable for this equipment. FCC WARNING This equipment generates or

17、 uses radio frequency energy. Changes or modifi cations to this equipment may cause harmful interference unless the modifi cations are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modifi cation is made. INFORMA

18、TION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa

19、tion. This equipment generates, uses and can generate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. I

20、f this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the

21、 separation between the equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Consult the dealer for technical assistance. This device complies with Industry Canada license exempt RSS standard(s). Operation is subject to the f

22、ollowing two conditions : (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This product is designed for connection to an IT power distribution system. Information on Disposal of Old

23、Electrical and Electronic Equipment and Batteries (applicable for countries that have adopted separate waste collection systems) Products and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment and batteries should be rec

24、ycled at a facility capable of handling these items and their waste byproducts. Contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environ

25、ment. Firmware Copyrights The title to and ownership of copyrights for fi rmware embedded in KENWOOD product memories are reserved for JVC KENWOOD Corporation. Notifi cation This equipment complies with the essential requirements of Directive 2014/53/EU. Restrictions This equipment requires a licenc

26、e and is intended for use in the countries below. ATBEDKFIFRDEGRISIE ITLILUNLNOPTESSECH GBCYCZEEHULVLTMTPL SKSIBGROHRTR ISO3166 ii BEFORE STARTING Amateur radio regulations vary from country to country. Confi rm your local amateur radio regulations and requirements before operating the transceiver.

27、Depending on the size and type of vehicle, the maximum transmission output power for the mobile operation will vary. The maximum transmission output power is usually specifi ed by the car manufacturer to avoid interference with other electric devices used in the vehicle. Consult your car manufacture

28、r and amateur radio equipment dealer for the requirements and installation. MARKET CODES K-type: The Americas E-type: Europe The market code is shown on the carton box. Refer to the specifi cations page 88 for information on the available operating frequencies. WRITING CONVENTIONS FOLLOWED The writi

29、ng conventions described below have been followed to simplify instructions and avoid unnecessary repetition. InstructionAction Press KEY.Press and release KEY. Press Mic KEY. Press and release KEY on the microphone. Press and hold KEY. Press and hold KEY down for a moment, then release KEY. Hold KEY

30、. Press and hold KEY down until instructed to release KEY. Press KEY + . With the transceiver power OFF, press and hold KEY, then switch the transceiver power ON by pressing . SUPPLIED ACCESSORIES After carefully unpacking the transceiver, identify the items listed in the table below. We recommend y

31、ou keep the box and packing materials in case you need to repack the transceiver in the future. AccessoryComment Quantity K-typeE-type Microphone11 DC power cable11 Fuse 25 A; for DC power cable 11 Fuse 4 A; for an external antenna tuner 11 DIN plug 7-pin (For REMOTE connector) 11 DIN plug 13-pin (F

32、or ACC2 connector) 11 Screw setFor bracket11 Plastic spacerFor bracket44 Instruction Manual English11 French11 Spanish1 Italian1 German1 Dutch1 Schematic diagram 2 Warranty Card11 iii PRECAUTIONS Please observe the following precautions to prevent fi re, personal injury, and transceiver damage: Conn

33、ect the transceiver only to a power source as described in this manual or as marked on the transceiver itself. Route all power cables safely. Ensure the power cables can neither be stepped upon nor pinched by items placed near or against the cables. Pay particular attention to locations near AC rece

34、ptacles, AC outlet strips, and points of entry to the transceiver. Take care not to drop objects or spill liquid into the transceiver through enclosure openings. Metal objects, such as hairpins or needles, inserted into the transceiver may contact voltages resulting in serious electrical shocks. Nev

35、er permit children to insert any objects into the transceiver. Do not attempt to defeat methods used for grounding and electrical polarization in the transceiver, particularly involving the power input cable. Adequately ground all outdoor antennas for this transceiver using approved methods. Groundi

36、ng helps protect against voltage surges caused by lightning. It also reduces the chance of a build-up of static charge. EXAMPLE OF ANTENNA GROUNDING ANTENNA LEAD IN WIRE GROUND CLAMP ELECTRIC SERVICE EQUIPMENT ANTENNA DISCHARGE UNIT GROUNDING CONDUCTORS GROUND CLAMPS POWER SERVICE GROUNDING ELECTROD

37、E SYSTEM Minimum recommended distance for an outdoor antenna from power lines is one and one-half times the vertical height of the associated antenna support structure. This distance allows adequate clearance from the power lines if the support structure fails for any reason. Locate the transceiver

38、so as not to interfere with its ventilation. Do not place books or other equipment on the transceiver that may impede the free movement of air. Allow a minimum of 10 cm (4 inches) between the rear of the transceiver and the wall or operating desk shelf. Do not use the transceiver near water or sourc

39、es of moisture. For example, avoid use near a bathtub, sink, swimming pool, or in a damp basement or attic. The presence of an unusual odor or smoke is often a sign of trouble. Immediately turn the power OFF and remove the power cable. Contact a KENWOOD service station or your dealer for advice. Loc

40、ate the transceiver away from heat sources such as a radiator, stove, amplifi er or other devices that produce substantial amounts of heat. Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzene to clean the cabinet of the transceiver. Use only a clean cloth with warm wate

41、r or a mild detergent. Disconnect the input power cable from the power source when the transceiver is not used for long periods of time. Remove the transceivers enclosure only to do accessory installations described in this manual or accessory manuals. Follow provided instructions carefully, to avoi

42、d electrical shocks. If unfamiliar with this type of work, seek assistance from an experienced individual, or have a professional technician do the task. Enlist the services of qualifi ed personnel in the following cases: a) The power supply or plug is damaged. b) Objects have fallen into or liquid

43、has spilled into the transceiver. c) The transceiver has been exposed to rain. d) The transceiver is operating abnormally or performance has seriously degraded. e) The transceiver has been dropped or the enclosure damaged. Do not attempt to perform any kind of confi guration or menu setup while driv

44、ing. Do not wear headphones while driving. Install the transceiver in a safe and convenient position inside your vehicle so as not to subject yourself to danger while driving. Consult your car dealer for the transceiver installation to ensure safety. HF/ 50 MHz mobile antennas are larger and heavier

45、 than VHF/ UHF antennas. Therefore, use a strong and rigid mount to safely and securely install the HF/ 50 MHz mobile antenna. Do not put the plastic bag used for packing of this equipment on the place which reaches a small childs hand. It will become a cause of suffocation if it wears fl atly. iv C

46、ONTENTS CARRIER LEVEL .23 CHAPTER 6 ENHANCED COMMUNICATIONS SPLIT-FREQUENCY OPERATION .24 DIRECTLY ENTERING THE FREQUENCY SPLIT SPECIFIED BY A DXer .24 TURN THE TUNING CONTROL TO SEARCH FOR THE TRANSMIT FREQUENCY .24 TF-SET (TRANSMISSION FREQUENCY SET) .24 SHIFTABLE RX FREQUENCY DURING SPLIT TRANSMI

47、SSION .25 FM REPEATER OPERATION .25 TRANSMITTING A TONE .26 Activating the Tone Function .26 Selecting a Tone Frequency .26 TONE FREQUENCY ID SCAN .26 FM CTCSS OPERATION .27 CTCSS FREQUENCY ID SCAN .27 CROSS TONE .28 CHAPTER 7 COMMUNICATING AIDS RECEPTION .29 SELECTING YOUR FREQUENCY .29 Direct Frequency Entry .29 Frequency Entry History .