Codan_9323_user_addendum.pdf

《Codan_9323_user_addendum.pdf》由会员分享，可在线阅读，更多相关《Codan_9323_user_addendum.pdf（4页珍藏版）》请在收音机爱好者资料库上搜索。

1、HF SSB transceiver reference manual12-50096 Issue 1, Page-1 Addendum The following section is added to the HF SSB transceiver reference manual, Codan part number 15-04076 Issue 1, 1997. Addendum Page-2, 12-50096 Issue 1HF SSB transceiver reference manual GPS position display This information is adde

2、d to Chapter 6, Setup procedures part 2, GPS display on/off. To read the GPS position of your transceiver you must: have GPS enabled have a GPS receiver connected via the GP connector on the rear panel enable the GPS display (see page 6-21 of the HF SSB transceiver reference manual, GPS display on/o

3、ff). When in Channel or Clarifier mode, the longitude and latitude coordinates of your transceiver will be displayed at the top of the display. ? If the GPS receiver does not immediately provide a valid position to the transceiver when the transceiver is switched on, zeroes will replace the longitud

4、e and latitude coordinates on the display. If the transceiver does not receive a valid position from the GPS receiver before the GPS timeout elapses, the message No GPS information is displayed on the top of the display for twenty seconds. After the message is displayed, the GPS coordinates are set

5、to zero. Addendum HF SSB transceiver reference manual12-50096 Issue 1, Page-3 Using the optional RS-232/I2C Interface This information is to be added to the Appendix Using the optional RS-232/I 2C Interface. The RS-232/I 2C Interface is an adaptor that plugs into the Remote Control connector of the transceiver. It provides two additional sockets for connecting a GPS receiver and a computer. Only one socket on the adaptor can be used at the one time. Addendum Page-4, 12-50096 Issue 1HF SSB transceiver reference manual This page has been left blank intentionally.