Ten-Tec_RX-321_sch.pdf
《Ten-Tec_RX-321_sch.pdf》由会员分享,可在线阅读,更多相关《Ten-Tec_RX-321_sch.pdf(20页珍藏版)》请在收音机爱好者资料库上搜索。
1、 RX-321 DSP Receiver Ten-Tec, Inc 1185 Dolly Parton Parkway Sevierville, TN 37862 Copyright Ten-Tec Incorporated Rx-321 Receiver The RX-321 receiver was deisgned by Ten-Tec for OEM applications. It was manufactured by Ten-Tec under agreement with third parties and never produced with the Ten-Tec bra
2、nd name. The RX-321 is based on the RX-320D receiver. Addional circuitry to support integration with a transmitter was added, along with an RF preselector and 600 Ohm audio output. GENERAL DESCRIPTION The Rx-321 is a general coverage receiver capable of receiving AM, SSB, and CW signals from 100kHz
3、to 30MHz. The receiver is controlled by an external computer via a serial connection (see to download the Rx-320D PC-GUI and programmers reference guide which will provide more information on controlling and programming the Rx-321). The Rx-321 is powered from any DC power supply operating in the ran
4、ge of 12-28VDC and capable of supplying at least 800mA of current (please observe the correct polarity as shown on rear panel). The antenna connection is designed for a 50-ohm antenna and is an SO239 type connector. The speaker connection is also available on the rear panel and is clearly marked. Pl
5、ease connect a 4 to 8 ohm speaker (again, please observe the correct polarity as shown). Finally, there is also a 9-pin connector on the rear panel labeled REMOTE. This connector provides an optional 600- ohm audio output and a mute pin that allows the AGC circuit to be turned off when used with an
6、external transmitter (this keeps the external transmitter from loading up the AGC and causing receive recovery problems). Please see the schematic description of the 9-pin connector labeled remote for the pin out of this connector and DC voltage levels to apply to the mute pin when using an external
7、 transmitter. SCHEMATIC DESCRIPTION The receive signals from the antenna pass through one of eight preselector filters that are selected based on the band in which the receiver is tuned. From there, the selected signals go through a preamp stage before passing through an IF notch filter and on to th
8、e first mixer. The first mixer translates the tuned signal to 45MHz. The 45MHz signal then passes through a 45MHz IF filter and gain stage before going to the second mixer. The second mixer translates the signal to 455kHz. The 455kHz signal then pass through a 455kHz IF filter and gain stage before
9、going to the third mixer. The third mixer translates the signal to 12kHz where the signal is then passed on to the AD1847 codec and ADSP- 2101 DSP processor for decoding and translating to a low-level audio signal. The low level audio signal is then passed on to an audio amplifier which amplifies th
10、e signal and passes it on to the external speaker connector provided at the rear panel. An external speaker can be connected and the received signal can be heard. Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten
11、-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Cop
12、yright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated Copyright Ten-Tec Incorporated RF BOARD GW320 Revised: December 2, 1999 Revision: Bill Of Materials December 16, 1999 11:12:13 Page 1 Item Quantity
13、Reference Part _ 1 16 C1,C3,C18,C75,C76,C77, .001MF C82,C88,C94,C148,C151, C152,C153,C168,C170,C184 2 2 C2,C108 220PF 3 56 C4,C5,C6,C7,C13,C14,C16, .1MF C17,C21,C22,C25,C28,C34, C36,C37,C38,C39,C44,C72, C74,C84,C87,C100,C103, C104,C105,C107,C110,C111, C116,C117,C118,C123,C124, C128,C129,C134,C135,C1
14、39, C140,C144,C145,C146,C149, C150,C155,C159,C171,C176, C185,C187,C188,C189,C190, C191,C192 4 21 C8,C10,C12,C15,C19,C20, .01MF C24,C49,C50,C51,C54,C55, C56,C57,C58,C66,C67,C70, C83,C89,C106 5 7 C9,C68,C80,C109,C113, 68PF C137,C163 6 7 C11,C52,C53,C85,C162, 470PF C182,C183 7 5 C23,C78,C91,C95,C99 33/
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Ten Tec_RX 321 _sch
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


