Yaesu_G-450XL_wires.pdf

《Yaesu_G-450XL_wires.pdf》由会员分享，可在线阅读，更多相关《Yaesu_G-450XL_wires.pdf（1页珍藏版）》请在收音机爱好者资料库上搜索。

1、Antenna Rotator Model G- 450XL Use the following Ghart to calculate confjgurations for tower-mounted antennas: J-7) P-() lSJ-,J S C5 /./lrv 6 . VI -geiL6 (; _A?J e ,J Antenna Type Rotation Radius Weight Antenna K Coefficient Wind Loading Area (in m2 ) 50M 5 el 2.5 m (98.4 inches) 7 kg (15.4 Ibs) (ma

2、st: 2.5kg, or 5.5 Ibs)* 17.5 0.3 21M 3 el 4.2 m (165.4 inches) 10 kg (22 Ibs) (mast: 2.5 kg, or 5.5 Ibs)* 42 0.45 TOTAL 59.5 0.75 I e- Co -f:;.,/) * Mast weight of 5kg (II Ibs) is divided equally between the two calculations. 6* Installing and Adjusting I) Use 5-conductor (or 6-conductor) cable with

3、 a diameter of 0.5mm (#24 AWG). Only use as much cable as you need. NOTE: If the cable exceeds 40m (131 ft) in length, increase the diameter to 0.75mm (#22 AWG). 2) Assemble the cable according to the following diagram: Tin the wire with solder. Rotator co,-:14; Side Side Make sure to insert this fi

4、rst. Do not use #1. Make sure to perform the following procedure with the POWER switch in the off position. 3) Connect the round plug to the rotator, and attach the other end to the Rotator Control Cable Jack on the controller, making sure to match the numbers on the pins (use only pins #2 to #6). 4

5、) Check the power switch with the cable in this state. Insert the power plug in the wall socket, and turn the POWER switch on. The pilot lamp should light, and the direction indicator will rotate until it reaches the current direction of the rotator. 5) Press the LEFT switch on the controller to tur

6、n the rotator counterclock wise. It will stop automatically. Confirm that the needle of the direction indicator rests exactly on the 0 0 (N) position. If there is needle error, loosen the screw in the center of the ind icator and adjust the needle to 00. 6) Look at the rotator, choosing a point from

7、 which to mark its rotation. 7) Next, press the RIGHT switch on the controller to turn the rotator 360 0 In a clockwise direction, watching the point on the rotator that you chose In step #6. Make sure that the rotator returns to the correct position. Also watch the needle on the direction indicator

8、, checking that it returns exactly to the 0 (N) position. If it does not align correctly, adjust the ADJ potentiometer on the rear panel of the controller. Furthermore, ensure the OVERLAP indicator LED lights up when the rotator near the end of its 360 0 rotation (If it does not light up, adjust the potentiometer (VR1) on the printed circuit board inthe controller). PAGE5