FEI 385-8000AB 电路图.pdf

《FEI 385-8000AB 电路图.pdf》由会员分享，可在线阅读，更多相关《FEI 385-8000AB 电路图.pdf（139页珍藏版）》请在收音机爱好者资料库上搜索。

1、 CommSync II Model 385 Redundant GPS Synchronized Time and Frequency System Users Manual Document 385-8000 Revision AB RadioFans.CN 收音机爱 好者资料库 CommSync II Users Manual 385-8000 Rev AB 2008 FEI-Zyfer Inc. All rights reserved. 2 RadioFans.CN 收音机爱 好者资料库 CommSync II Users Manual 385-8000 Rev AB 2008 FEI

2、-Zyfer Inc. All rights reserved. 3 DATE REVISIONS 12/22/2000 Rev A: Moved address information from page i to page iv and added additional contact information. Incorporated spelling and grammar corrections. Changed specifications to be consistent with published specifications. Added Section 5 and Sec

3、tion 6. 01/22/2001 Rev B: Changed applicable pages to reflect KDC V1.04.00, GTF V1.07.00 firmware changes, and added external Sync Input related descriptions. 03/14/2001 Rev C: Changed applicable pages in Section 6 to reflect the addition of the TIME OFFSET capability in the Time Code module 385-402

4、0-01, -02. 08/03/2001 Rev D: Added SAASM specific information. Changed Section 6 to reflect module status information. Corrected typographical errors. 09/18/2001 Rev E: Added DTF-specific information. Added RS-232 I/O External Input module information to Section 6. Added Menu 7 to Front Panel inform

5、ation. 12/17/2001 Rev F: Updated LPN Sine wave information for new modules. Added Frequency Synthesizer module and +12VDC Power Supply module information. 03/27/2002 Rev G: Updated Frequency Synthesizer module Added Ethernet I/O (385-4038), 1 MHz TTL module (385-4010-10), and Pulse Rate TTL module (

6、385-4033-02) information. 06/11/2002 Rev H: Separated out Section 6, Option Module information to new Users Manual (385-8003). 07/15/2002 Rev J: Added Paragraph 2.2 10/30/2002 Rev K: Added Power Supply specifications to General Specifications. Updated Declaration of Conformity. 04/10/2003 Rev L: Add

7、ed information on VCXO version of GTF/DTF. Added information for DTF setup. Rearrange manual to separate GTF and DTF operation. 07/16/2003 Rev M: Updated contact information and FEI-Zyfer references. 02/03/2004 Rev N: Updated GPS receiver interfaces for NavMan receiver 03/29/2004 Rev P: Updated for

8、variations in GPS receiver operations. 07/29/2004 Rev R: Added information on time to Ready LED light. 12/05/2004 Rev S: Changed applicable pages to reflect GTF V1.31.00 firmware changes. RadioFans.CN 收音机爱 好者资料库 CommSync II Users Manual 385-8000 Rev AB 2008 FEI-Zyfer Inc. All rights reserved. 4 03/2

9、2/2005 Rev T: Corrected Section 2.2.6.1(Keying the SAASM receiver). 06/06/2005 Rev U: Added Ruggedized DC Power Supply module (385-4077-05). 08/10/2005 Rev V: Added Menu 7.3 for System External 1 PPS Delay, Added Phase Aligned modules in Module ID codes and messages list 07/05/2006 Rev W: Added cabl

10、e mismatch information at end of Section 2.2.3.1. Updated Section 2.2.3.2 to reflect new line amplifiers. 03/06/2007 Rev Y: Major manual update. 06/12/07 Rev Z: Updated glossary, adjusted index entries, performed general formatting cleanup and corrected various typographical errors. 09/21/07 Rev AA:

11、 Updated with Kill backup memory (SAASM), HINT Information and Baud rate setting options. 2/7/08 Rev AB: Updated for New 385-4103-xx SAASM GTF Modules, added 385-4090 Dual Port Ethernet module. Legal Information CommSync II Users Manual 385-8000 Rev AB 2008 FEI-Zyfer Inc. All rights reserved. 5 WARR

12、ANTY FEI-Zyfer, Inc.s standard warranty is for one year unless otherwise agreed upon by contract or purchase order. Warranty terms and conditions are explained in the Standard Terms and Conditions of Sale provided with the quotation. DISCLAIMER This document reflects the specifications and features

13、of the equipment that were current at the time of release of this manual. FEI-Zyfer, Inc. disclaims responsibility for any errors contained herein, and reserves the right to make changes to this manual and related equipment without notice or obligation. TRADEMARKS Windows 95, Windows 98, and Windows

14、 are registered trademarks of Microsoft Corporation. All brand names and product names used in this document are trademarks, registered names of their respective holders. FEI-Zyfer, Inc. is not associated with any referenced product or manufacturer mentioned in this document. FEDERAL COMMUNICATIONS

15、COMMISSION (FCC) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are design to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses

16、and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interf

17、erence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the

18、receiver Connect the equipment into a outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. THIS PRODUCT IS NOT AUTHORIZED FOR USE AS A CRITICAL COMPONENT IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESSED

19、 WRITTEN CONSENT OF THE CHIEF EXECUTIVE OFFICER OF FEI-ZYFER, INC. Safety Information CommSync II Users Manual 385-8000 Rev AB 2008 FEI-Zyfer Inc. All rights reserved. 6 WARNINGS Warning statements in this manual call attention to conditions or practices that could result in injury or loss of life.

20、CAUTIONS Caution statements in this manual call attention to conditions or practices that could result in damage to the CommSync II unit. GENERAL SAFETY PRECAUTIONS Always locate heavy equipment towards the bottom of the cabinet (rack) to avoid accidental tip-over of the cabinet (rack). Make certain

21、 the maximum operating ambient temperature does not exceed 55 C. Never restrict the airflow through the instruments vents, located on the top and bottom of the instrument. Never apply a voltage to any terminal that is outside the range specified for the terminal If the instrument is configured to op

22、erate from an AC power source, pay special attention to the following: o Connect the instrument only to a properly rated supply circuit o The supplied 3-prong power cord provides safety grounding. Do not defeat this feature. The user must comply with all applicable national and local electrical regu

23、lations regarding grounding and safety o Always ensure that the power switch is OFF (switch position 0) prior to removing an AC Power Supply module from a CommSync II system o Never remove the protective cover from the AC Power Supply module o Replace fuse(s) with same type and rating as marked Cont

24、act Information CommSync II Users Manual 385-8000 Rev AB 2008 FEI-Zyfer Inc. All rights reserved. 7 CONTACT INFORMATION FEI-Zyfer, Inc (North America) Technical Support: Phone (714) 933-4003 (888) 886-7465 (USA only) Fax (714) 933-4001 Email techsupportfei- Sales: Phone (714) 933-4002 Fax (714) 933-

25、4001 Email salesfei- Data Sheets: http:/www.fei- RMA Numbers: Phone (714) 933-4000 Fax (714) 933-4001 Shipping Address for Repairs/Returns: FEI-Zyfer, Inc. Attention: RMA # 7321 Lincoln Way Garden Grove, CA 92841-1428 USA Please obtain a Returned Material Authorization (RMA) number prior to returnin

26、g a product to FEI-Zyfer, Inc. Contact Information CommSync II Users Manual 385-8000 Rev AB 2008 FEI-Zyfer Inc. All rights reserved. 8 This page intentionally left blank Table of Contents 9 CommSync II Users Manual 385-8000 Rev W 2004 FEI-Zyfer Inc. All rights reserved. Contents at a Glance Legal In

27、formation.5 Safety Information.6 Contact Information.7 Table of Figures.15 List of Tables .16 1 Manual Overview .17 1.1 Introduction.17 1.2 Assumptions.17 1.3 Related Manuals and Reference Documents.17 1.4 Conventions .18 1.5 Where to Look.18 2 Quick Start Guide - GPS Timing and Frequency System (GT

28、F).19 3 Quick Start Guide - Distribution Timing and Frequency System (DTF).21 4 General Information.23 4.1 Basic System Configuration Information.24 4.2 Reference.25 4.3 Basic System Description.25 4.4 GTF (GPS Time/Frequency) Modules.27 4.5 DTF (Distribution Time/Frequency) Modules .28 4.6 Rear Pan

29、el Modules.29 4.7 Power Supply Modules.29 4.8 System Monitor/Control and/or Ext Input Modules (slots 14 and 15 only) .30 4.9 Remote Firmware Upgrade.31 4.10 Output Option Modules .31 4.11 System Redundancy and Switchover Considerations.32 4.12 Storage Considerations (SAASM Receivers).33 5 GPS Timing

30、 and Frequency Systems.35 5.1 Details of GTF Operation .36 5.2 Getting Started.38 6 Distribution Timing and Frequency Systems .61 6.1 Details of DTF Operation.62 6.2 Getting Started.65 7 Display Menus and Controls.77 7.1 Introduction.78 7.2 Front Panel General Description.78 7.3 Menu/Display Overvie

31、w.79 7.4 Screen Descriptions.79 8 General Specifications.97 8.1 Introduction.98 Table of Contents CommSync II Users Manual 385-8000 Rev AB 2008 FEI-Zyfer Inc. All rights reserved. 10 8.2 Mechanical.98 8.3 Environmental .98 8.4 Power Requirements.98 8.5 System Electrical Signals.100 8.6 Output Signal

32、s.102 8.7 Antenna Interface.103 8.8 Optional Antenna Kits.103 8.9 I/O Control/Monitor Interface.104 8.10 Outline and Mounting.105 8.11 Certifications and Compliance.106 9 Maintenance and Repair.107 9.1 Introduction.108 9.2 Periodic Service and Calibration.108 9.3 Troubleshooting.108 9.4 Repair Procedure.114 10 Power Supply Modules.117 10.1 Introduction.118 10.2 AC Power Supply Module 385-4021.