FLUKE 2815866C_w 电路图.pdf

《FLUKE 2815866C_w 电路图.pdf》由会员分享，可在线阅读，更多相关《FLUKE 2815866C_w 电路图.pdf（4页珍藏版）》请在收音机爱好者资料库上搜索。

1、Technical Data 8845A/8846A Digital Multimeters accessory guide Test leads, probes, and probe tips TL71 Premium Test Lead Set Included with 8845A and 8846A One pair (red, black) comfort grip probes with silicone insu- lated, right-angle test leads Probe tip size: 2 mm Recommended for V measurements C

2、AT IV 600 V, CAT III 1000 V, 10 A rating. UL listed. One-year warranty TL910 Precision Electronic Probe Set Very small 1 mm tips to access hard- to-reach test points Probe tip length up to 100 mm, test lead length: 1 m Included : 3 sets of spring loaded gold tips and 2 sets of stainless steel tips C

3、AT IV 600 V, CAT III 1000 V, 3 A rating One-year warranty Introduction The 8845A/8846A Digital Multimeters are complemented by a comprehensive range of accessories, all of which are designed to help you get the most from your multimeter. This data sheet explains in more detail the makeup of key acce

4、s- sories and offers technical specifications where required. TL80A Basic Electronic DMM Test Set One pair (red, black) each 1 meter long silicone test lead set, alligator clip and probe tip extender Probe tip size: 2 mm C75 soft carrying case CAT II 300 V. UL listed. One-year warranty 8845A-TPIT Te

5、st Probe IC Tip Set One pair (red and black) Snaps onto DMM probes with .080 in (2 mm) O.D. Tips Designed to IEC 1010 standard Pin tip jack at the adapter end is recessed for added insulation protection Adapter allows easy access to leads of through-hole ICs Insulation at the tip fits between leads

6、to prevent accidental shorting Specifications MaterialsTip: Stainless steel, nickel plated Body: Polypropylene, fire retardant, UL94 V-2 rated ColorOne red, one black SafetyIEC 1010-2-031, Category II, P2 compliant Operating voltage 300 V rms/dc Current3 A RadioFans.CN 收音机爱 好者资料库 2 Fluke Corporation

7、 8845A/8846A Digital Multimeters accessory guide 8845A-EFPT Fine Point Extended Test Probe Adapter Set One pair (red and black) Snaps onto DMM probes with .080 in (2 mm) O.D. Tips Designed to IEC 1010 standard Adapter allows access to hard-to-reach test points Tips are insulated to the point to prev

8、ent short- ing of adjacent components Specifications MaterialsTip: Stainless steel Tip insulation: Kynar Body: Polypropylene, fire retar- dant, UL94 V-2 rated ColorOne red, one black SafetyIEC 1010-2-031, Category II, P2 compliant Operating voltage 300 V rms/dc Current 3 A TL2X4W-PTII 2X4 Wire Ohms

9、Test Lead Perform 4-wire mea- surements with only two test leads Two conduc- tors per lead (one source and one measure) Excellent resolution and accuracy Specifications Maximum voltage between test lead and ground: 1000 V Maximum transient overvoltage and input voltage combined: 1000 V Maximum curre

10、nt: 500 mA TemperatureOperating: 0 to 55 C 90 % relative humidity Storage: -40 C to 170 C Altitude2000 m SafetyComplies with EN/IED 61010-031 and CAN/CSA C22.2 No. 61010- 1-04 for Measurement Category 1 1000 V Test leads, probes, and probe tips cont. 884X-Short 4-wire short 4-terminal shorting bar 4

11、 mm banana terminals sized and orientated to short DMM input source and sense terminals Used to null out front end offsets or as required by the calibration procedure 884x-RTD 100 Ohm RTD Temperature Probe Manufactured using a coil suspension element design for increased shock and vibration resistan

12、ce Mineral-insulated sheath with a minimum bend radius of 19 mm (3/4 in) for flexibility and durability Specifications ResistanceNominal 100 Temperature coefficient0.00385 / C nominal Temperature range-200 C to 300 C (transition and cable temperature: 0 C to 150 C) Drift rate+ 0.13 C at 0 C after 10

13、00 hours at 300 C Sheath material316 stainless steel LeadsPTFE-insulated, nickel-plated stranded copper, 22 AWG Termination4-wire banana Time constantFour seconds maximum for 63.2 % response to step change in water moving at 3 fps Bending radius19 mm (3/4 in) except for 50 mm (2 in) area of sheath n

14、ear tip CalibrationIncludes manufacturers NIST-traceable calibration and table with R vs. T values in 1 C increments from -196 C to 300 C. Callendar van Dusen coefficients included ImmersionAt least 100 mm (4 in) recommended Accuracy (includes cali- bration uncertainty and short-term stability) 0.05

15、0 C at -196 C 0.050 C at 0 C 0.051 C at 200 C 0.055 C at 300 C Size9 in L x 3/16 in diameter MarkingEach RTD is marked with the Fluke name and part number RadioFans.CN 收音机爱 好者资料库 884X-USB USB to RS-232 Cable Adapter USB to serial RS-232 inter- face adapter cable Converts from standard DB 9-pin seria

16、l to USB 2.0 Requires an available PC communications port 1.65 m cable length Includes cable and USB driver disk (CD-ROM) 884X-ETH Ethernet Interface Cable 8-conductor (4 twisted pair) unshielded cable (48 inches) with an 8-position modular plug (RJ45) on each end, with an overmold boot/strain relie

17、f Rated working voltage: 100 V rms max. Operating temperature range: -40 C to + 80 C 884X-512M 12 Mbyte memory Used on the 8846A only Plugs into USB device host port on the 8846A front panel Fully compliant with Universal Serial Bus Specification v2.0 Dual LED indicates power and busy status 884X-1G

18、 USBMemory 1 GB Used on the 8846A only Plugs into USB device host port on the 8846A front panel Fully compliant with Universal Serial Bus Specification v2.0 Dual LED indicates power and busy status Memory Interface cables RS43 RS-232 cable RS43, 2 m DB9-to-DB9 for PC to unit Y8021 and Y8022 IEEE-488

19、 cables Shielded IEEE 488 one-meter (39.4 inches) and two-meter (78.8 inches) cables, with plug and jack at each end Software FlukeView Forms Document, store and analyze individual readings or series of measurements, then convert them into professional-looking documents FlukeView Forms Basic, includ

20、ed with 8845A/8846A, transfers data points from the meter to a PC, displays readings in table or graphical form For a larger array of forms, or to use FlukeView Forms Designer to customize your forms, upgrade to FlukeView Forms version 3.0 with FVF-UG Model NameDescription FVF-SC5FlukeView Forms, Ba

21、sic Software Includes: CD for FlukeView Forms Basic Users manual, registration card, and software license agreement FVF-UGFlukeView Forms, Software Upgrade No Cable Includes: CD for FlukeView Forms Version 3.0 Users manual, registration card, and software license agreement FVF-SC4Extended FlukeView

22、Forms with USB Cable Includes: CD for FlukeView Forms Version 3.0 PC-to-meter serial-to-USB adapter cable Users manual, registration card, and software license agreement FlukeView Forms Requirements Operating system for FVF-SC2 and FVF-Basic Windows 98 Second Edition, Windows Me, Windows 2000, or Wi

23、ndows XP Operating system for FVF-SC1 and FVF-SC3 Windows 95, Windows 98, Windows Me, Windows NT 4.0, Windows 2000, or Windows XP Minimum PC HardwarePentium class or better microprocessor; 32 MB RAM; 70 MB hard disk space (100 MB to install); Serial or USB port RadioFans.CN 收音机爱 好者资料库 4 Fluke Corpor

24、ation 8845A/8846A Digital Multimeters accessory guide 884X-CASE Tough molded plastic case with die cut foam to hold and protect the 8845A or 8846A meter Accessories and manual compart- ments One-year warranty Rack Mount Kit Y8846S allows meter to be mounted in a standard 19-inch rack Y8846D enables

25、mounting two meters side- by-side in a standard 19-inch rack Parts list Quantity Description Y8846SY8846D 12Small filler plate 1NALarge filler plate 1NALarge filler plate bracket 11Rack mount tray NA1Dual center mount 22#8-32 x 1/2 in panhead Philips screws 12#6-32 x 1/4 in panhead Philips screws 44

26、#10-32 x 3/4 in Philips rack screws 12#6-32 x 1/2 in panhead Philips screws 44#10-32 rack nuts Other accessories Traceable calibration with data Traceable calibration without data Accredited calibration Repair services Extended warranty agreements Calibration and repair coverage services Product upg

27、rades *Contact your local Fluke service center for details and availability Calibration and Service Fluke Corporation PO Box 9090, Everett, WA 98206 U.S.A. Fluke Europe B.V. PO Box 1186, 5602 BD Eindhoven, The Netherlands For more information call: In the U.S.A. (800) 443-5853 or Fax (425) 446-5116

28、In Europe/M-East/Africa +31 (0) 40 2675 200 or Fax +31 (0) 40 2675 222 In Canada (800)-36-FLUKE or Fax (905) 890-6866 From other countries +1 (425) 446-5500 or Fax +1 (425) 446-5116 Web access: 2007-2012 Fluke Corporation. Specifications subject to change without notice. Printed in U.S.A. 5/2012 2815866C_EN Modification of this document is not permitted without written permission from Fluke Corporation. Fluke. Keeping your world up and running.