Alto_aVerb_FX_Service_Manual电路图.pdf
《Alto_aVerb_FX_Service_Manual电路图.pdf》由会员分享,可在线阅读,更多相关《Alto_aVerb_FX_Service_Manual电路图.pdf(26页珍藏版)》请在收音机爱好者资料库上搜索。
1、Service Manual Version: 1.1 Model: VERB 24x32 BIT DIGITAL EFFECTS RadioFans.CN 收音机爱 好者资料库 CONTENTS 1. Specification 2. Block Diagram 3. Schematic Diagram 4. Printed Circuit Board 5. Wiring Diagram 6. Test Procedure 7. Electrical Parts List 8. Exploded Views & Mechanical Parts List 9. Notes RadioFans
2、.CN 收音机爱 好者资料库 1. SPECIFICATION (aVERB) Electrical Frequency Response: +0.5 / -1.5 dB from 20Hz to 20 kHz S/N Ratio (process) 80 dB A wtg, 20 Hz-22kHz S/N Ratio (bypass) 90 dB A wtg, 20 Hz-22kHz THD+Noise: 500 Kohms A/D - D/A Conversions A/D converter: 1 bit Sigma-Delta D/A converter: 1 bit Sigma-De
3、lta Output Number of Channels:2 Format:1/4 unbalanced Maximum Level (bypass): +9 dBu Output Impedance: LEFT input of the device under test. -LEFT output of the device under test - A input of Audio Precision System Two -RIGHT output of the device under test - B input of Audio Precision System Two On
4、the Alphaverb: -Turn on the power switch. -Set INPUT volume to maximum. -Set OUTPUT volume to maximum. -Set PROGRAM to DELAY. -Set VARIATION to 1. Start the sweep (F9) and control the results (Page3 Graph) in the following conditions: -MIX potentiometer turned to 0. -MIX potentiometer turned to 10.
5、Audio Precision05/22/02 12:55:43 alfaverb_amplitude.at2c ColorLine StyleThickDataAxis CyanSolid1Anlr.Level ALeft GreenSolid1Anlr.Level BRight -10 +10 -7.5 -5 -2.5 +0 +2.5 +5 +7.5 d B V -10 +10 -7.5 -5 -2.5 +0 +2.5 +5 +7.5 d B V 2020k501002005001k2k5k10k Hz THD test On PC: -Load file: alfaverb_THD (A
6、PWin File menu / Open / Test ) Test Connections: -Output A of Audio Precision System Two - LEFT input of the device under test. On the Alphaverb: -Turn on the power switch. -Set INPUT volume to maximum. -Set OUTPUT volume to maximum. -Set PROGRAM to DELAY. -Set VARIATION to 1. Start the sweep (F9) a
7、nd control the results (Page3 Graph) in the following conditions: -LEFT output of the device under test - A input of Audio Precision System Two / MIX potentiometer turned to 10 -RIGHT output of the device under test - B input of Audio Precision System Two / MIX potentiometer turned to 10 Audio Preci
8、sion05/22/02 13:06:12 alfaverb_THD.at2c ColorLine StyleThickDataAxis CyanSolid2Anlr.THD+N RatioLeft 0.1 1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 % 206k501002005001k2k Hz S/N test On PC: -Load file: alfaverb_SN (APWin File menu / Open / Test ) Test Connections: -Output A of Audio Precision System Two - LEFT
9、 input of the device under test. On the Alphaverb: -Turn on the power switch. -Set OUTPUT volume to maximum. - With MIX command turned to 10, increase the INPUT level until the devices outputs clip, and after reduce the INPUT level itself until the outputs exit from clipping state. -Set PROGRAM to D
10、ELAY. -Set VARIATION to 1. Start the sweep (F9) and control the results (Page3 Graph) in the following conditions: -LEFT output of the device under test - A input of Audio Precision System Two / MIX potentiometer turned to 10 -RIGHT output of the device under test - B input of Audio Precision System
11、 Two / MIX potentiometer turned to 10 Audio Precision05/22/02 13:13:22 alfaverb_SN.at2c ColorLine StyleThickDataAxis CyanSolid2Anlr.AmplLeft -100 +20 -80 -60 -40 -20 +0 d B V -1000.000+0-900-800-700-600-500-400-300-200-100 dBV Dynamics test On PC: -Load file: alfaverb_dyn (APWin File menu / Open / T
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Alto_aVerb_FX_Service_Manual 电路图
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


