Gibson_Guitar_Pickup_Wiring_Diagrams电路图.pdf

《Gibson_Guitar_Pickup_Wiring_Diagrams电路图.pdf》由会员分享，可在线阅读，更多相关《Gibson_Guitar_Pickup_Wiring_Diagrams电路图.pdf（3页珍藏版）》请在收音机爱好者资料库上搜索。

1、Gibson Pickup Wiring Diagram P-94R and P-94T GREEN & BARE TO GROUND WHITE LEAD BLACK LEAD The P-94 pickup comes with two insulated lead wires plus a bare wire twisted with a green lead (note: there may be a red wire included, this is a “dead” lead which you may cut). Connect either the white or blac

2、k lead wire to the volume control and connect the other lead to ground. If you get a thin sound with both pickups in operation, you may need to change the polarity of the pickup. Simply reverse the lead wires to do this. If you are using both the P-94T and P-94R together, use the black lead on one p

3、osition, and the white lead for the other. This will give you hum-cancelling operation when both pickups are in use. RadioFans.CN 收音机爱 好者资料库 Gibson Pickup Wiring Diagram Vintage Style Two Conductor Models P-90 P-100 57 Classic 57 Classic Plus Angus Young Sig. BurstBucker SHIELD TO GROUND TO VOLUME P

4、OT OR SELECTOR SWITCH RadioFans.CN 收音机爱 好者资料库 Gibson Pickup Wiring Diagram Four Conductor Models (490R/490T, 498T, 496R, 500T, Tony Iommi Sig.) Standard Humbucking Operation Note: If pickup is out of phase with existing pickup, reverse black and red leads green & white solder together & tape black &

5、 shield to ground red to controls Coil Tap - Humbucking Switching Single Coil SPDT ON / ON MINI-TOGGLE Humbucking Red to Control Black & shield to ground Series - Parallel Switching Parallel “Single Coil” Sound DPDT ON / ON MINI-TOGGLE Series “Humbucking” Sound Red to Control Shield to ground RadioFans.CN 收音机爱 好者资料库