Rane MM 12 Mixer Schematics 电路图.pdf

《Rane MM 12 Mixer Schematics 电路图.pdf》由会员分享，可在线阅读，更多相关《Rane MM 12 Mixer Schematics 电路图.pdf（5页珍藏版）》请在收音机爱好者资料库上搜索。

1、VI. SERVICE INFORMATION CAUTION:MM 12 service information is included for use only by qualified technical service personnel. There are no user serviceable parts in the MM 12. VI-l. DISASSEMBLY PROCEDURE. 1. To gain access to ail internal assemblies. remove the rear pan as follows: set the MM 12 on t

2、he bench top with the front panel facing up and the LINE CORD UNPLUGGED FROM ANY AC OUTLET. Remove the 16 phillips #6-32 thread-forming screws from the outside perimeter of the front panel. 2.Lift the front panel assembly upward out of the pan and flip it over TO YOUR LEFT and lay it face down (on t

3、he knobs) on the bench right next to the pan. There is enough service loop in the line cord to allow this. 3. To completely remove the pan from the front panel assembly, remove the two phillips screws from the line cord retaining tab on the pan. Then pull the line cord and plug inward through the ho

4、le in the pan. VI-2. GENERAL SERVICE PROCEDURE 1. PCB Component ReplacementDue to the shallow depth of the PCBs, there should rarely be a need to remove one of these boards completely for servicing. PCB components may be replaced with the PCBs in place, using a desoldering tool and needlenose pliers

5、 (solder-wick may be used in place of a desoldering tool). 2. Replacing Broken or Defective Pots.Remove the knobs and shaft nuts (use 10mm nut driver) from all of the pots on that circuit board. Gently pull the PCB up from the front panel as far as the slack in the buss wires will allow. Now desolde

6、r and replace the defective pot 3. Complete removal of a Circuit Board.Remove the knobs and shaft nuts from all the pots on that board. Then cut each of the stranded buss wires ON THE FOIL SIDE ONLY, right next to the foil solder joint Then desolder the foil connections and pull the remaining buss w

7、ires out of the PCB holes. The PCB may now be completely removed. To replace, insert the board and tighten the shaft nuts. Reposition the buss wires in the PCB holes and resolder in place. VI-3. SCHEMATICS AND ASSEMBLY DIAGRAMS. RadioFans.CN 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库