Shure_556_Data_Sheet 电路图.pdf

《Shure_556_Data_Sheet 电路图.pdf》由会员分享，可在线阅读，更多相关《Shure_556_Data_Sheet 电路图.pdf（2页珍藏版）》请在收音机爱好者资料库上搜索。

1、SHURE BROTHERS INCORPORATED Microphones and Acoustic Devices 225 WEST HURON STREET : CHICAGO 10, ILLINOIS PHONE Delaware 7-4550 : CABLE: SHUREMICRO DATA SHEET DATE: FEBRUARY, 1947 SUBJECT: Model 556 Multi-Impedance Broadcast Unidyne Dynamic Microphone. 556 Multi-Impedance Broadcast Unidyne Microphon

2、e (Super-Cardioid Uni-directional Moving-CoilDynamic) General: Model 556 is a Super-Cardioid type uni- directional moving-coil dynamic microphone providing wide-range high quality reproduction of sound. The true unidirectional characteristic of the Unidyne, obtained by the uniphase principle* provid

3、es highly satisfactory operation under adverse acoustic conditions where a con- ventional microphone would be practically useless. (See Acoustic Considerations). The microphone has a New Acousto-Mechanical cir- cuit containing a moving-coil element, which operating in conjunction with a high flux ma

4、gnet provides high efficiency and smooth peak free response from 40 to 15,000 cycles. The rear response is down approximately 15 db due to the uniphase unidirectional acoustic network. The new moving-coil unit is provided with a double wind-screen to permit quiet out-door operation. As a pre- cautio

5、n against mechanical vibration pickup, the unit is spring-suspended inside the microphone case, which is in turn floated in live rubber in the stand connector. The case is modern in design with attractive stream- lining and grille treatment, and is provided with a swivel that allows the microphone t

6、o be aimed at the source of sound for best pickup. A seven foot length of two conductor shielded cable is provided for attachment of any type plug the user may desire. This cable is held by screw terminals in the base of the isolation unit, and may be easily replaced by longer lengths. Applications:

7、Model 556 is especially constructed and tested to meet the requirements of the broadcast studio, and is held within close tolerances in frequency response. and directivity. It may also be used for high- quality recording, public address, and similar applications. The true unidirectional characterist

8、ic of the Unidyne provides an easy solution to the feedback problem in reverberant locations, facilitates orchestral placement, permits best utilization of space in small broadcast studios, and allows. practically complete exclusion of un- wanted noises. The swivel allows the head to be tilted throu

9、gh an angle of 90 permitting the microphone to be aimed at the source of sound. The instrument is unusually rugged and is practically immune to the effects of moisture, temperature and mechanical vibration. Installation:All microphones have the standard 5/8-27 thread and may be mounted on any Shure

10、desk, banquet, or floor stand. When long lines are used, care should be taken that the cable does not parallel A.C. power lines for long distances to avoid A.C. hum induction. Connections:The Model 556 Microphone is of the multi-impedance type. Model 556 may be worked directly into a 30-50 ohm line,

11、 a 150-250 ohm line, or a high im- pedance input. Selection of these impedances is accom- Model 556 Broadcast Unidyne plished by changing the position of the switch at the rear of the microphone. The switch positions are marked L for low impedance (30-50 ohms), M for medium imped- ance (150-250 ohms

12、), and H for high impedance (35,000 ohms). The low and medium impedance positions of the Model 556 may be fed into a standard low or medium impedance input amplifier (Fig. A-1), or into an amplifier with high impedance input (Fig. A-2). In the latter case, Shure Model A86A Cable-Type Transformer is

13、available for coupling the low impedance line to the amplifier input. The double winding primary of the Shure Model A86A Cable type transformer permits coupling either a 30-50 ohm line or 150-250 ohm line to high impedance input. The low and medium impedance positions are recom- mended where long ca

14、ble lengths are required or under conditions of severe hum disturbances. The permissible line length is practically unlimited, since neither response nor level is appreciably affected by reasonable lengths of line. The high impedance position on the Model 556 Microphone may be used with any crystal

15、microphone amplifier or other amplifier with an input impedance of 100,000 ohms or more (See Fig. A-3). For best high frequency response, the total cable lengths should not ex- ceed 25 feet: longer cable lengths may be used with some loss of high frequency response. The additional loss at 5000 cycle

16、s is of the order of 2.5 db for an additional 25 ft. length of cable (50 ft. total) and 6 db for an additional 50 ft. length (75 ft. total). If the Model 556 Microphone is being used in the high impedance position, single conductor shielded cable may be used to provide additional cable-lengths; also

17、, the two-conductor cable furnished with the Microphone may be replaced with single conductor shielded cable, if the microphone is in- tended to operate directly into high impedance (grid) input only. Copyright, 1948, Shure Brothers, Inc. *Patented by Shure Brothers, Inc. (Over)Printed in U.S.A. Rad

18、ioFans.CN 收音机爱 好者资料库 Operation:No special precautions beyond ordinary care are necessary in the operation of the Model 556 Dy- namic microphone. It will operate efficiently and depend- ably under all ordinary conditions in hot and cold climates. Dropping the microphone or other severe mechanical sho

19、cks should be avoided. Acoustic Considerations: The expression Su- per-Cardiod type response simply means that the polar characteristic of the microphone approximates a modi- fied cardioid of revolution. There is a wide, useful pickup angle at the front of the microphone while the response at the si

20、des is down 8.5 db from that at the front. The rear response is down of the order of 15 db over a broad range of frequencies.The true unidirectional charac- teristic of the Unidyne should not be confused with the relatively slight directional effect at high frequencies only which can be produced by

21、baffle effects in the conven- tional pressure microphone. By directing the rear side of the microphone towards the audience or other source of interfering sound, pickup can be concentrated on the desired source. Reverbera- tion energy pick up is decreased over two-thirds. The microphone can be place

22、d close to reflecting surfaces without objectionable effects if the rear side of the micro- phone is toward the reflecting surface. This is particularly valuable in small broadcast studios. It is desirable to experiment with microphone place- ment and orientation in order to secure the greatest bene

23、fits from the unidirectional characteristic. Specifications 1000 C.P.S. Response: Model 556 L Position: Open Circuit Voltage Level. . . . . . . .-84.1 db. (*) Loaded With 40 Ohms. . . . . . . . . . . . -90.1 db. (*) Power Level Into 40 Ohms. . . . . . . . . . .-56.1 db. (*) Model 556 M Position: Ope

24、n Circuit Voltage Level. . . . . . . . . . -76.8 db. (*) Loaded With 250 Ohms . . . . . . . . . . . -82.8 db. (*) Power Level Into 250 Ohms. . . . . . . . .-56.8 db. (*) Model 556 H Position: Open Circuit Voltage Level. . . . . . . . -57.5 db. (*) Loaded With 100,000 Ohms . . . . . . . .-60.1 db. (*

25、) (*) 0 db. = 1 Volt Per Dyne Per Sq. cm. (*) 0 db. = 1 Milliwatt with 10 Dynes Per Sq. cm. Recommended Load Impedance: Model 556 L Position 30-50 Ohms. Model 556 M Position 150-250 Ohms. Model 556 H Position 100,000 Ohms or More. Model 556 Microphone Horizontal Polar Response FREQUENCY-CYCLES PER S

26、ECOND Fig. B. Typical Frequency Response, Model 556 Microphone. MODEL 556 Code WordRUMUB Net Wt.2 lb. Shipping Weight4 Ibs. Height, Case *8-3/8 Width * 4-7/16 Thickness * 3-3/16 Height, Overall *3-9/16 FinishSatin Chrome *See Fig. C. BOTTOM VIEW OF ISOLATION UNIT Guarantee: Each microphone is guaran

27、- teed to be free from electrical and mechanical defects for a period of one year from date of ship- ment from the factory, provided all instructions are complied with fully. In case of damage. return the microphone to the factory for repairs. Our guaran- tee is voided if the microphone case is opened. 27A32 (7-48) RadioFans.CN 收音机爱 好者资料库