Adlab ADBxMP MX UM HW IO Module User Manual 电路图.pdf

《Adlab ADBxMP MX UM HW IO Module User Manual 电路图.pdf》由会员分享，可在线阅读，更多相关《Adlab ADBxMP MX UM HW IO Module User Manual 电路图.pdf（3页珍藏版）》请在收音机爱好者资料库上搜索。

1、ADBxMP MX 2in/2out 1 ADBHardware Control User Manual 1. Connect the Demo Board Connect the module to demo board ADDxDB, then link the power (outside: negative, inside: positive) and the audio I/O connect hardware panel by hardware bus; As upper figure, there are three different boards: “Main board”

2、includes 7 segment display control panel and effect module. Please check all pins socket when you install demo board. Find the audio input that you want to use, do not use Line and Microphone/Guitar input simultaneously. At the top(Line, Microphone, Guitar), the microphone input L and guitar are con

3、trolled by Microphone/Guitar switch. There are line and headphone audio output at left side. Before you turn on the power, insert the DC 9V socket. RadioFans.CN 收音机爱 好者资料库 2 2. Adjust Volume The microphone volume(at the top) just for microphone input the preamplifier only. Headphone Volume(at left s

4、ide) for headphone. Be careful with the Original Volume and the Effect Volume(at top left), they use to mix original sound and effect sound. If you want to hear the sound of effect module only, turn off original sound then turn on effect volume what you want. 3. Operate Hardware Control Panel There

5、are two different control boards: LCM(at left) and 7 segment display(at right).The blue frame area(at bottom right) includes: Mute, Tap and up-down switch button. Depend on the controller of module setting, switch the jumper(yellowframe area) at the same side.The switch will not influence the Mute a

6、nd the Tap. RadioFans.CN 收音机爱 好者资料库 3 - 7 segment display Up: BCD encoder(orange frame area) Down: rotary encoder(red frame area) or Up-Down switch button(blue frame area). - LCM display Left: rotary encoder(red frame area) Right: Up-Down switch button(blue frame area) 4. Operation BCD encoder, rota

7、ry encoder, Up-Down switch button: switch different effects. POTENTIOMETER: change parameters. (16 effects project only) MUTE: silence. You can change to BYPASS status if you want. TAP: it will blink at some delay effect status, you can double press TAP. EEPROM: remember the last choice. Load automa

8、tically if boot. (This function can not combine with BCD encoder). Control/Display project combination table 7 segment display EFFECT 16 32 99 BCD encoder 1 ROTARY encoder 1 1 UP-DOWN switch button 2 2 POTENTIOMETER 1 MUTE 1,2 1 1,2 TAP 1,2 EEPROM 1,2 Control/Display project combination table LCM display EFFECT 16 32 99 BCD encoder ROTARY encoder 1 1 1 UP-DOWN switch button POTENTIOMETER MUTE 1 1 1 TAP 1 EEPROM 1 1 If “2” appeared at the same column, it means that there is the second project you can use.