Renkus-Heinz Module Data 电路图.pdf

《Renkus-Heinz Module Data 电路图.pdf》由会员分享，可在线阅读，更多相关《Renkus-Heinz Module Data 电路图.pdf（2页珍藏版）》请在收音机爱好者资料库上搜索。

1、 Plug-In Loudspeaker Controllers C12 C22 L20 Renkus-Heinz P2400 and P2700 dual channel, power amplifiers include fa- cilities for plug-in loudspeaker control- lers that can be easily inserted into the rear of the amplifier. These controllers optimize the systems overall performance while protecting

2、the associated loudspeak- ers from damage. The C12 module is a single input, dual output controller designed for use in single-channel (mono) systems hav- ing active 2-way loudspeakers, bi- ampable 3-way loudspeakers, or in systems having both passive loud- speakers and subwoofers. The C12 includes

3、a 4th order cross- over network, parametric equalizers to smooth and extend the loudspeak- ers response, signal alignment facili- ties and protection circuitry. The C12 controller module is custom- ized to match the performance of the associated loudspeaker(s) with a PK kit that matches the operatin

4、g charac- teristics of the controller to the associ- ated loudspeaker(s). The C22 is a dual-input, dual-output controller designed for use with pas- sive loudspeakers or subwoofers in dual channel (stereo) systems . It provides two channels of protection and response equalization for loud- speakers

5、or subwoofers, as well as high and low pass filters. When the C22 is used with subwoof- ers, it also functions as a crossover, thus eliminating the need for a sepa- rate subwoofer crossover. C22 mod- ules are customized to match an asso- ciated family of loudspeakers (for ex- ample, the TRC or SR se

6、ries) and then programed with control switches to match a specific loudspeaker. The L20 is a dual-channel protection (limiter) module designed as a cost effective way to provide loudspeaker protection in dual channel (stereo) systems. It effectively limits the maximum amount of power each amplifier

7、channel can deliver to associated loudspeakers. The maximum level is easily adjusted using control switches. The L20 also includes a means of separately adjusting each amplifier channels low frequency output. This allows additional low frequency protection to be dialed into the system for loudspeake

8、rs having small, relatively low power woofers. They simplify system design by elimi- nating the need for either separate loudspeaker controllers or for sepa- rate electronic crossovers and com- pressor/limiters. This assures top level system perfor- mance while cutting down on rack space requirement

9、s and reducing overall system costs. L20 Dual Channel Limiter C22 Dual Input, Dual Output Controller Plug-In Loudspeaker Controllers C12 Single Input, Dual Output Controller RadioFans.CN 收音机爱 好者资料库 T O REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE TO RE

10、DUCE THE RISK OF ELECTRICAL SHOCK DO NOR REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL MANUFACTURED IN EEC BRIDGE 21 OUTPUTS STEREO 4 OHM MIN./CH. BRIDGED MONO 8 OHM MIN. T 10 A 250 V 117 V RISK OF ELECTRICAL SHOCK DO NOT OPEN IRVINE, CA - U.S

11、.A. POWER CONSUMPTION : 920 W SERIAL N MODEL P-2400 Input cc PIN 1 = GND PIN 2 = + PIN 3 = - MODEL C12 SUB/LF OUT FR/HFINPUT RENKUS-HEINZ MADE IN USA Channel 1 & 2 controller outputs (processed signals) to additional power amplifiers. Sub/LF amplifier output to associated subwoofers or to the low fr

12、equency section of active 2-way loudspeakers. FR/HF amplifer output to associated full-range loudspeakers or to the high frequency section of active 2-way loudspeakers. WIRING DIAGRAMS RH367 36/97 cc GROUND LOOPING / HPF PIN 1 = GND PIN 2 = + PIN 3 = - CH 2 OUTPUTS MODEL C22 PROCESSEDLOOPING / HPF C

13、H 1 INPUTCH 2 INPUT RENKUS-HEINZ MADE IN USA CH 1 OUTPUTS T O REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE TO REDUCE THE RISK OF ELECTRICAL SHOCK DO NOR REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSON

14、NEL MANUFACTURED IN EEC BRIDGE 21 OUTPUTS STEREO 4 OHM MIN./CH. BRIDGED MONO 8 OHM MIN. T 10 A 250 V 117 V RISK OF ELECTRICAL SHOCK DO NOT OPEN IRVINE, CA - U.S.A. POWER CONSUMPTION : 920 W SERIAL N MODEL P-2400 “Ch. 1” In Channel 1 & 2 “Looping” (unprocessed signals) or HPF (high pass filter) contr

15、oller outputs (processed signals) to additional power amplifiers.“Ch. 2” In Channel 1 & 2 controller outputs (processed signals) to additional power amplifiers. Channel 1 output to loudspeaker(s) or subwoofers. PROCESSED Channel 2 output to loudspeaker(s) or subwoofers. T O REDUCE THE RISK OF FIRE O

16、R ELECTRICAL SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE TO REDUCE THE RISK OF ELECTRICAL SHOCK DO NOR REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL MANUFACTURED IN EEC BRIDGE 21 OUTPUTS STEREO 4 OHM MIN./CH. BRIDGED MONO 8 OHM MIN.

17、 T 10 A 250 V 117 V RISK OF ELECTRICAL SHOCK DO NOT OPEN IRVINE, CA - U.S.A. POWER CONSUMPTION : 920 W SERIAL N MODEL P-2400 Ch. 1 Input Channel 1 Channel 2 Channel 1 and 2 outputs to loudspeakers. Channel 1 & 2 looping outputs (unprocessed signals) to additional power amplifiers, Ch. 2 Input PIN 1

18、= GND PIN 2 = + PIN 3 = - MODEL L20 CH 1 INPUTCH 2 INPUT CH 1 OUTPUT CH 2 OUTPUT GROUNDSTEREO LIMIT SET BRIDGE LIMIT SET HPF SELECTHPF SELECT PARALLEL X C12 Loudspeaker Controller Wiring Diagram C22 Loudspeaker Controller Wiring Diagram L20 Limiter Wiring Diagram 19201 Cook Street, Foothill Ranch, CA 92610-3501 Tel: 949-588-9997 Fax: 949-588-9514 E-mail: Salesrenkus- Web: RadioFans.CN 收音机爱 好者资料库