Kenwood-DVK-751-Service-Manual 电路图 维修手册.pdf
《Kenwood-DVK-751-Service-Manual 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Kenwood-DVK-751-Service-Manual 电路图 维修手册.pdf(36页珍藏版)》请在收音机爱好者资料库上搜索。
1、In compliance with Federal Regulations, following are reproduc- tions of labels on, or inside the product relating to laser product safety. KENWOOD-Crop. certifies this equipment conforms to DHHS Regulations No. 21 DFR 1040. 10, Chapter 1, Subchapter J. DANGER : Laser radiation when open and interlo
2、ck defeated. AVOID DIRECT EXPOSURE TO BEAM Caution : No connection of ground line if disassemble the unit. Please connect the ground line on rear panel, PCBs, Chassis and some others. NOTE : Please replace the mechanism PCB (W02-266x-05) with new one, if it is malfunction. CD/VIDEO-CD/DVD PLAYER DV-
3、K751/S701 SERVICE MANUAL 1998-8/B51-5468-00 (K/K) 3547 Illust. is DV-K751. * Refer to parts list on page 33. 73 ? ? 4 ? ? 1 MIC 2MIC 1 POWER - ON OFF ON / STANDBY SHUTTLE 0 w? ? 8/ MIC LEVEL MIC 1MIC 2 FL DISPLAY (PCM/BIT STREAM) COAXIALOPTICAL DIGITAL OUTPUT CENTER S VIDEO OUTPUT VIDEO OUTPUT MIX L
4、INE OUTPUT SUB WOOFER SURROUNDFRONT 6CH. OUTPUT L R 1 2 SYSTEM CONTROL Knob (K29-6835-22) Indicator (B12-0311-04) AC power cord * (E30-) Phono jack (E63-1064-05) Phono jack (E63-1052-05) Power cord bushing (J42-0083-05) Phono jack (E11-0366-05) Knob (K27-2249-04) Knob (K29-6835-22) Phono jack (E63-0
5、128-05) Phono jack (E63-0122-05) Cylindrical receptacle (E56-0014-05) Oscillating module (W02-1114-05) Dressing panel (A21-3728-03) Knob (K29-6677-03) Panel * (A60-) Dressing panel (A21-3627-12) Miniature phone jack (E11-0188-05) Knob (K29-6679-03) Front glass (B10-2386-12) Knob (K29-6835-22) Knob (
6、K29-6945-04) DV-K751(K) COVER1,1( 98.12.12 15:04 yW 2 RadioFans.CN 收音机爱 好者资料库 Audio (E30-0505-05)(E30-1427-05) (E30-2365-05) (E30-2733-05) cord (Red, White) . (3) Remote (A70-1231-05): RC-D0703: M2T1E1 (A70-1243-05): RC-D0704: K (A70-1244-05): RC-D0706: M1C1 Battery cover (A09-1105-05) control unit.
7、 (1)Batteries (R6/AA) . (2) Digital cord (Orange). (1) Video cord (Yellow). (1) System control cord . (1) AC (E03-0115-05) plug adaptor . (1) Use to adapt the plug on the power cord to the shape of the wall outlet. (Accessory only for regions where use is necessary.) DV-K751/S701 2 CONTENTS / ACCESS
8、ORIES CONTENTS / ACCESSORIES .2 CAUTIONS.3 CONTROLS .4 BLOCK DIAGRAM .8 CIRCUIT DESCRIPTION.9 ADJUSTMENT. 10 PARTS DESCRIPTIONS .12 PC BOARD .13 SCHEMATIC DIAGRAM .17 EXPLODED VIEW .30 PARTS LIST.33 SPECIFICATIONS .43 Contents Accessories DV-K751(K) COVER1,1( 98.12.12 15:04 yW 3 RadioFans.CN 收音机爱 好者
9、资料库 DV-K751/S701 3 CAUTIONS Operation to reset The microprocessor may fall into malfunction (impossibility to operate erroneous display, etc.) when the power cord is unplugged while power is ON or due to an external factor. In this case, execute the following procedure to reset the microprocessor an
10、d return it to normal condi- tion. Please note that resetting the microprocessor clears the contents stored in, it returns the microprocessor to the condition when it left the factory. Perform the following operation. 1 Press the POWER key to the ON position. 2 Press the ON/STANDBY () key to ON. 3 W
11、ait for a few seconds to ensure that the display shows “NO DISC”. 4 While holding the 7 key, press and hold the ON/STANDBY () key until “INITIAL OK!” appears. N OD I S C Note related to transportation and move- ment Before transporting or moving this unit, be sure to remove any disc from it and carr
12、y out the following operation. 1. Press the POWER key to the ON position. 2. Press the ON/STANDBY () key to ON. 3. Wait a few seconds and verify that the display shown appears. 4. Set the POWER key to OFF. Operation to reset The microprocessor may fall into malfunction (impossibility to operate erro
13、neous display, etc.) when the power cord is unplugged while power is ON or due to an external factor. In this case, execute the following procedure to reset the microprocessor and return it to normal condi- tion. Please note that resetting the microprocessor clears the contents stored in, it returns
14、 the microprocessor to the condition when it left the factory. Perform the following operation. 1 Press the MAIN POWER key to the ON position. 2 Press the REMOTE POWER key to ON. 3 Wait for a few seconds to ensure that the display shows “NO DISC”. 4 While holding the 7 key, press and hold the REMOTE
15、 POWER key until “INITIAL OK!” appears. N OD I S C Note related to transportation and move- ment Before transporting or moving this unit, be sure to remove any disc from it and carry out the following operation. 1. Press the MAIN POWER key to the ON position. 2. Press the REMOTE POWER key to ON. 3.
16、Wait a few seconds and verify that the display shown appears. 4. Set the MAIN POWER key to OFF. WITH ON/STANDBY KEY WITH REMOTE POWER KEY DV-K751(K) COVER1,1( 98.12.12 15:04 yW 6 RadioFans.CN 收音机爱 好者资料库 DV-K751/S701 4 CONTROLS 73 4 1 MIC 2MIC 1 POWER - ON OFF ON / STANDBY SHUTTLE 0 w8/ MIC LEVEL MIC
17、 1MIC 2 FL DISPLAY 16832457 0!#$% DVD VCDCD P.B.C.DOLBYDIGITALRANDOMPROG.STEREO ANGLE PCM REPEAT ALL LR TITLE CHAPTER TRACKAB ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? KARAOKE 9 POWER - ON OFF Display / Main unit (DV-K751) L, STEREO, R indicators Character information display Opera
18、tion indicators 3 :Play 8 :Pause DVD, VCD, CD indicators Special playback related indicators Display VCD and CD related indicators DVD related indicators 1 ON/STANDBY () key Press to turn power of the unit from on to standby or vice versa. 2 Standby indicator 3 Remote control sensor 4 FL DISPLAY key
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Kenwood-DVK-751-Service-Manual 电路图 维修手册 Kenwood DVK 751 Service Manual 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


