Kenwood-KDSP-900-Service-Manual(2) 电路图 维修手册.pdf
《Kenwood-KDSP-900-Service-Manual(2) 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Kenwood-KDSP-900-Service-Manual(2) 电路图 维修手册.pdf(14页珍藏版)》请在收音机爱好者资料库上搜索。
1、 2000-12 PRINTED IN JAPAN B51-7713-00 (N)3381 DVD SURROUND PROCESSOR KDS-P900 SERVICE MANUAL CENTER SUBW FRONT R FRONT L REAR R REAR L AV IN R AV IN L TO MZ-BUS DIGITAL IN CD-CH 1 DIGITAL IN TV/DVD Digital Signal Processor D I G I T A L D I G I T A L S U R R O U N D Metallic cabinet (A01-2742-01) Co
2、rd with plug (E30-4740-05) Magic tape (H30-0051-05) Screw set (N99-1558-05) Cord with connector (E30-4938-05) Mounting hardware (J21-3801-04) x2 RadioFans.CN 收音机爱 好者资料库 KDS-P900 2 BLOCK DIAGRAM A8V AVR M5237ML A5V AVR BA178M05T LM2595S-ADJ D3.3V AVR 2SB1184 SW9V MC033063AD -9V B.U5V 2SB1565 CDTI CCL
3、K CDT0 ERF CS DIR DSP SS CLK RST SI S0 IERX IETX IEON HA12187FP MZ-BUS DRIVER CLK DATA SEL EVOL SYSTEM u-COM 703035AGC-XXX B.U DET MZ-BUS CN SEL TDA7501 EVOL+6dB INPUT GAIN BA3121F ISO AV IN (+4.6dB) BUFF NJM4565M-TE2 AK5353VT A/D AK4112A DIR D IN D IN DSP56362PV200 DSP6ch D/A AK4356VQ L.P.F NJM4565
4、M-TE2 (-6.5dB) (CD IN) +3dB 2ZONE VOL ANALOG : +2dB DIGITAL : 0dB 2ZONE : 0dB NJM4565M-TE2 BUFF (-3dB) MUTE NJM4565M-TE2 PRE AMP (9.1dB) (9.1dB+15dB) NJM4565M-TE2 PRE AMP PRE OUT A8V A5V D3.3V SW9V SW-9V B.U5V PON SYS ON RESET MUTE BUDET B.U5V DAPD B.U5V BUS+ B.U GND MUTE BUS ON RESET BUS- REAR OUT
5、FRONT OUT AUDIO I/O CD IN A8V A5VA5V D3.3V D3.3VA5V A8V CASS IN A OUT RR RL FR FL CENTER SUB SW9V, FRONT L,R REAR L,R SW9V,-9V CENTER SUB FR FL RR RL SW9V,-9V SW9V A8V -9V AM : 200mV FM,TV : 600mV CD, MD,DVD,CH : 1200mV ANALOG AV : 920mV AV : 800mV FM,TV : 400mV CD, MD,DVD,CH : 800mV ANALOG AM : 135
6、mV FM,TV : 720mV CD,MD,DVD,CH,SUB : 240mV CD, MD,DVD,CH : 1400mV ANALOG AM : 240mV DIGITAL CD,DVD,CH : 1840mV AV : 1400mV CD,MD,DVD,CH,SUB : 120mV AV : 680mV CD,DVD,CH : 865mV FM,TV : 340mV AM : 110mV DIGITAL CD, MD,DVD,CH : 680mV ANALOG AM : 750mV CD,MD,DVD,CH : 4500mV AV : 4500mV DIGITAL FM,TV : 2
7、250mV CD,MD,DVD,CH,SUB : 4500mV CD, MD,DVD,CH : 4500mV ANALOG AM : 285mV CD,MD,DVD,CH : 1700mV AV : 1700mV DIGITAL FM,TV : 850mV CD,MD,DVD,CH,SUB : 300mV CD, MD,DVD,CH : 1700mV ANALOG CD, MD,DVD,CH : 480mV FM,TV : 240mV ANALOG AM : 80mV AV : 480mV AM : 200mV CD,MD,DVD,CH : 1200mV AV : 1200mV FM,TV :
8、 600mV CD, MD,DVD,CH : 1200mV DIGITAL ANALOG RadioFans.CN 收音机爱 好者资料库 KDS-P900 3 COMPONENTS DESCRIPTION Relation Between 2ZONE MUTE Terminals MUTE_F TerminalMUTE_R TerminalMUTE Terminal 2zone ON Lo outputHi output Hi: MUTE ON Speaker Select NORMAL(Muting enabled for Front speakers) 2zone ON Hi output
9、Lo output Hi: MUTE ON Speaker Select REVERSE(Muting enabled for Rear speakers) 2zone OFFLo outputLo output Hi: MUTE ON (Muting enabled for Front/R Ref.Purpose, FunctionOperation, Condition, Compatibility PROCESSOR UNIT (X32-4980-00) IC1System microcomputer IC2DSP IC IC3DIR IC4A/D converterAnalog-to-
10、digital conversion. IC5E-VOL IC6D/A converterDigital-to-analog conversion. IC7Inverter for DSP ICs oscillator IC8Isolation ICIsolation IC for AUDIO IN. IC9Switching regulatorDIGITAL 3.3 V AVR. IC10Power supply ICPreamp (for -9 V). IC12Reset IC Executes resetting at below 4.2 V (Output L). IC13BUS IC
11、Bus communication IC. IC14Power supply ICAVR for AUDIO 5 V. IC15Power supply IC IC16SRAM for DSP IC IC17SRAM for DSP IC IC18ROM for dts IC19OpampOpamp for reference voltage output. IC20- 22OpampD/A converter output LPF. IC23- 25OpampOpamp for Pre-Out output. IC26Muting logic circuit2-input NOR (x 2)
12、. IC28, 29OpampBus audio output buffer. IC30OpampA/D converter input buffer. IC31Muting logic circuit2-input NOR (x 2). IC32 Muting logic circuit2-input AND. Q1-3Preamp (+9 V) SW Supplies +9 V when the bases of Q1and Q3 are H and the base of Q2 is L. Q4- 6Preamp (-9 V) SW Supplies -9 V when the base
13、s of Q4 and Q6 are L and the base of Q5 is H. Q7, 8Preamp (+9 V) AVRTurns ON when the base of Q7 is H. Ref.Purpose, FunctionOperation, Condition, Compatibility Q9, 10Preamp (+9 V) SWTurns ON when the base of Q10 is H. Q11, 12AUDIO +B AVRTurns ON when pin 2 of Q12 is H. Q13, 14AUDIO 5 V SWTurns ON wh
14、en pin 2 of Q17 is H. Q16DIGITAL 3.3 V SWTurns ON when the base is H. Q17AUDIO 5 V SWTurns ON when pin 2 of Q17 is H. Q18, 19B.U. 5 V AVRTurns ON when the base of Q18 is H. Q101P-ON 5 VTurns ON when the base is L. Q103System ON/OFF request SW Turns ON and sends the System ON request when the base is
15、 H. Q104Back-Up detection SW Turns ON when Back-Up is H, OFF when power down is detected. Q105Reset SWExecutes resetting when the base isH. Q106IC26 muting SWTurns ON to apply muting when the base isL. Q107BUS MUTE inversion SWTurns ON when BUSMUTE is H. Q201FET5 V:3.3 V level shifting FET. Q202FET5
16、 V:3.3 V level shifting FET. Q204FET5 V:3.3 V level shifting FET. Q301E-VOL muting SWTurns ON to apply muting when the base is H. Q499PRE-OUT muting SWTurns ON to mute CENTER/SUB when pin 2isH. Q500PRE-OUT muting SWTurns ON to mute FR/FL when pin 2 is H. Q501PRE-OUT muting SWTurns ON to mute RR/RL w
17、hen pin 2 is H. Q502PRE-OUT muting SW Turns ON to mute CENTER when pin 2 of Q499 is H. Q503PRE-OUT muting SW Turns ON to mute SUB when pin 2 of Q499 is H. Q504PRE-OUT muting SWTurns ON to mute FR when pin 2 of Q500 isH. Q505PRE-OUT muting SWTurns ON to mute FL when pin 2 of Q500 is H. Q506PRE-OUT mu
18、ting SW Turns ON to mute RR when pin 2 of Q501 is H. Q507PRE-OUT muting SW Turns ON to mute RL when pin 2 of Q500 is H. RadioFans.CN 收音机爱 好者资料库 KDS-P900 4 MICROCOMPUTERS TERMINAL DESCRIPTION PinPin NameI /OPurposeProcessing Operation Processing During Non-Operation System Microcomputer 703035AGC-015
19、 : IC1 (X32-4980-00) 1DIR_CSODIR (AK4112A) chip select.L: DIR communication permitted.H 2MUTE_FOFRONT muting enable terminal. L: 2-zone main source (when 2ZONE is OFF).H H: 2-zone sub source. 3DIR CDTIIDIR (AK4112A) DATA input terminal.DIR data input.Input 4DIR CDTOODIR (AK4112A) DATA output termina
20、l.DIR data output.Last status held 5DIR CCLKODIR (AK4112A) CLOCK output terminal.DIR communication clock output.H 6Evdd-Positive power supply terminal for function-sharing terminals.Positive power supply.- 7Evss-GND terminal for function-sharing terminals.GND potential.- 8-11 NCONot used.Open (Outpu
21、t fixed at Low).L 12DSP_SIIDSP (DSP56362) DATA input terminal.DSP data input 13DSP_SOODSP (DSP56362) DATA output terminal.DSP data output.Last status held 14DSP_CLKODSP (DSP56362) CLOCK output terminal.DSP communication clock output.L 15DSP_SSODSP (DSP56362) Communication Permission output terminal.
22、L: Start of communication permitted.H 16DSP_RSTO(DSP56362) RESET output terminal.L: DSP Reset.H 17NCONot used.Open (Output fixed at Low).L 18IC/Vpp-IConnected directly to Vss.Internally connected terminal.- 19DA_PDOD/A converter Power Down SW.L: Power Down.H 20P_ONOP-ON control output terminal.H: OF
23、F. L: ON.Hi-Z 21,22NCONot used.Open (Output fixed at Low).L 23IERXIIE bus input.IE bus input. 24IETXOIE bus output.IE bus output.L 25,26NCONot used.Open (Output fixed at Low).L 27IE_ONOIEBUS current driver power supply terminal.L: STBY. H: Bus communication permitted.L 28MUTEOMUTE control terminal.L
24、: OFF. H: ON.L 29,30NCONot used.Open (Output fixed at Low).L 31RESETISystem reset inputL: Reset. H: Start of operation.- 32XT1ISub system clock oscillation terminal.Open.- 33XT2-Sub system clock oscillation terminal.Open.- 34REGCIRegulator oscillator connection terminal.Connection of an electrolytic
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Kenwood-KDSP-900-Service-Manual2 电路图 维修手册 Kenwood KDSP 900 Service Manual 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


