Kenwood-XDV252-cs-sm 电路图 维修手册.pdf
《Kenwood-XDV252-cs-sm 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Kenwood-XDV252-cs-sm 电路图 维修手册.pdf(26页珍藏版)》请在收音机爱好者资料库上搜索。
1、MINI HiFi COMPONENT SYSTEM RXD-V252/V252-H SERVICE MANUAL 2001-10 PRINTED IN KOREA B51-5759-00 (K/K) 404 * Refer to parts list on page 27. In compliance with Federal Regulations, following are repro- duction of labels on, or inside the product relating to laser product safety. KENWOOD-Corp. certifie
2、s this equipment conforms to DHHS Regulations No.21 CFR 1040. 10, Chapter 1, subchapter J. DANGER : Laser radiation when open and interlock defeated. AVOID DIRECT EXPOSURE TO BEAM. *Refer to page 2 if you want to know system configuration. (XD-V252)* 70% Dress ring (A21-3966-08) FRT cab assy * (A60-
3、) FL panel * (B10-) Panel(VCD) (A60-2220-08) Knob(VOLUME) (K29-8047-08) Cassette lid(R) (A21-3959-08) Phone jack (E11-0942-08) Cassette lid(L) (A21-3958-08) Jack(MIC) (E11-0953-08) RadioFans.CN 收音机爱 好者资料库 RXD-V252/V252-H 2 CONTENTS / ACCESSORIES / CAUTIONS CONTENTS / ACCESSORIES / CAUTIONS. 2 EXTERN
4、AL VIEW.3 CIRCUIT DESCRIPTION.4 ADJUSTMENT.7 WIRING DIAGRAM.8 PC BOARD . 9 SCHEMATIC DIAGRAM . 15 EXPLODED VIEW .25 PARTS LIST.27 SPECIFICATIONS .Back cover Contents AC Plug Adaptor (1) (E03-0115-05) Use to adapt the plug on the power cord to the shape of the wall outlet. (Accessory only for regions
5、 where use is necessary.) AM Loop Antenna(1) (T90-0879-08) AA size battery(2) (UM/SUM-3, R6, HP-7 or similar) Remote Control(1) (A70-1574-08) FM Antenna(1) (T90-0883-08) Video Cable(1) (E30-7255-08) The marking of products using lasers (Except for some areas) The marking is located on the rear panel
6、 and says this product has been classified as Class 1. It means that there is no danger of hazard- ous radiation outside the product CLASS 1 LASER PRODUCT Accessories ModelColorM(General Market)I(Malaysia) RXD-V252Blue-I RXD-V252-HGrayMI2 System Configurations Cautions Attention Please contact our K
7、ENWOOD Service Department in your side if you want the service information; Circuit Description. Full Described Parts list and so. Information is available to you by internet from us. RESETTING THE MICROCOMPUTER Reset the microcomputer under the following con- ditions : To erase all of the stored me
8、mory contents (clock and timer settings, and tuner and CD presets). If the display is not correct. If the operation is not correct. 1Press the ON/STANDBY button to enter the standby mode. 2Whilst pressing down the 7 STOP button and the SOUND MODE button, hold down the ON/STANDBY button for at least
9、1 second. “CLEAR AL” will appear . Caution : The operation explained above will erase all data stored in memory including clock and timer set- tings, and tuner and CD presets. TRANSPORTING THE UNIT Before you move this product to a new location, proceed as follows : 1Press the ON/STANDBY button to t
10、urn the power on. 2Press the CD button. 3Press the 0 OPEN/CLOSE button to open the disc tray. Remove all CDs inserted in the unit. 4Press the 0 OPEN/CLOSE button to close the disc tray. Make sure that “NO DISC” is displayed. 5Press the ON/STANDBY button to enter the standby mode and then unplug the
11、AC power cord from the AC socket. SOUND MODE ON/ STANDBY 7 STOP ON/ STANDBY CD 0 OPEN/CLOSE RadioFans.CN 收音机爱 好者资料库 RXD-V252/V252-H 3 EXTERNAL VIEW * Refer to parts list on page 27. ANTENNA AM LOOP FM 75 VIDEO /AUX VIDEO OUT SPAN SELECTOR 230V 240V FM 50kHz AM 9kHz FM 100kHz AM 10kHz + +- - L SPEAKE
12、RS RATED SPEAKER IMPEDANCE: 6 OHMS MIN. R LR Cabinet(TOP) (A02-3014-08) AC power cord (E30-2881-08) RCA socket (E02-0021-08) Lock terminal board (E70-0151-08) FM Antenna (E70-0145-08) Slide switch (S62-0086-08) RCA socket (E63-1219-08) AC power cord bushing (J42-0338-08) RadioFans.CN 收音机爱 好者资料库 RXD-
13、V252/V252-H 4 CIRCUIT DESCRIPTION Block Diagram for MPEG1 Video/Audio Processing RAS# ProcessorLA(17:0) DRAM InterfaceDA(8:0) InterfaceLD(7:0) Huffman DBUS(15:1) LCS3#, LCS#(1:0) RISC Decoder DOU#DRAM LWR# Processor 2Kx32 ROMDWE# LOE# 2x32 SRAMCAS# ACLKAUX(7:1)AUX SerialATCLK MPEG AudioAIN Serial Au
14、dio Processor InterfaceAOUT Interface ARFS64x32 ROMYUV(7:0) ATFS32x32 SRAMPCLK2XScreen ARCLKRegistersVideo OutputPCLK VSYNC HSYNC TDMSEL-PLL(1:0) TDM InterfaceTDMCLK Interface On Screen TDMDR DisplayCPUCLKMisc TDMFS DRAM DMA RESET# Controller Port No.Port NameI/OFunction 1,31,51VCC3-Supply voltage f
15、or 3.3V. 2RAS#ODRAM row address strobe (active low). 3DWE#ODRAM write enable (active low). 412MA(08)ODRAM multiplexed row and column address bus. 1328DBUS(015)I/ODRAM data bus. 29RESET#ISystem reset (active low). 30,50,80,100GND-Ground. 3239YUV(07)O Y is luminance, UV are chrominance data bus for sc
16、reen video interface. YUV(07) for 8 bit YUV mode. 40VSYNCI/O Vertical sync for screen video interface, programmable for rising or falling edge. 41HSYNCI/O Horizontal sync for screen video interface, programmable for rising or falling edge. 42CPUCLKIRISC and system clock input. 43PCLK2XI/OPixel clock
17、: two times the actual pixel clock for screen video interface. 44PCLK I/OPixel clock qualifier in for screen video interface. 4549,52,53,54AUX(07)I/OAuxiliary control pins (AUX0 and AUX1are open collectors). 5562LD(07)I/ORISC interface data bus. 63LWR#OUnused. 64LOE#ORISC interface output enable (ac
18、tive low). 65,66,67LCS(3,1,0)#ORISC interface chip select (active low). 6879,8287LA(017)ORISC interface address bus. 81VCC-Digital supply voltage for 5.0V. 88ACLKI/O Master clock for external audio DAC(8.192MHz, 11.2896MHz, 12.288MHz, 16.9344MHz, and 18.432MHz). ODual-purpose pin. AOUT is the audio
19、interface serial data output. Pins SEL -PLL(1: 0) select phase-lock loop(PLL) clock frequency 89AOUT/SEL/PLL0ICPUCLK for the Visba : 00 = bypass PLL 01 = 54MHz PLL 10 = 67.5MHz PLL 11 = 81MHz PLL 90ATCLKI/OAudio transmit bit clock. ODual-purpose pin. ATFS is the audio interface transmit frame sync.
20、91ATFS/SEL/PLL1I Pins SEL -PLL(1: 0) select phase-lock loop(PLL) clock frequency CPUCLK for the Visba. See the SEL -PLL0 pin above for the settings. 92DOEO Dual-purpose pin. DRAM output enable (active low)/DRAM multiplexed row and column address bus. 93AINIAudio interface serial data input. 94ARCLKI
21、Audio receive bit clock. 95ARFSIAudio interface receive frame sync. 96TDMCLKITDM interface serial clock. 97TDMDRITDM interface serial data receive. 98TDMFSITDM interface frame sync. 99CAS#ODRAM column address strobe bank 0 (active low). Port Function of MPEG1 Video/Audio Processing : ES3880 (ICM2) R
22、XD-V252/V252-H 5 CIRCUIT DESCRIPTION Port No.Port NameI/OFunction 1,25,26,31,72 75,77,91,100 VSSIGround. 5,16,32,66 73, 78,90 VCCISupply voltage for 5.0v. 6DSC CIClock for programming to access internal registers. 7AUX0I/OUnused. 9AUX1I/OServo reverse or control pin. 11AUX2I/OServo LD ON or control
23、pin. 70AUX3I/OUnused. 69AUX4I/OServo CCW/Close or control pin. 68AUX5I/OUnused. 67AUX6I/OServo XLAT or control pin/VFD DO. 14AUX7I/OServo BRKM/Sense or control pin/VFD DI. 18AUX8I/OServo Mute/Open or control pin/VFD CLK. 20AUX9I/OServo SQS0 or control pin. 34AUX10I/OUnused. 35AUX11I/OUnused. 36AUX12
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Kenwood-XDV252-cs-sm 电路图 维修手册 Kenwood XDV252 cs sm 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


