Philips-AJ-3980-Service-Manual(1) 电路图 维修手册.pdf
《Philips-AJ-3980-Service-Manual(1) 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Philips-AJ-3980-Service-Manual(1) 电路图 维修手册.pdf(24页珍藏版)》请在收音机爱好者资料库上搜索。
1、CD Clock RadioAJ 3980 all versions Handling Chip Components and Safety .1 - 1 Technical Specification the display will show Cd: and your current track number. 2.Releaseor when you recognize the passage you want. =Normal CD playback and standby clock time resumes. RADIO RECEPTION (see figure 6) 1.Pre
2、ss the RADIO button to switch on the radio. =Radio touch screen controls appears throughout radio operation =The radio frequency and waveband appears in the display for 10 seconds before reverting back to the clock display. 2.Press the BAND button to select your waveband FM/AM. 3.Tune to your statio
3、n manuallyorautomatically by using / (up / down). To improve reception : FM: extend the coil antenna fully at the back of the set for optimum reception. AM: uses a built-in antenna. Direct the antenna by adjusting the position of your set. 4.Adjust the sound using the + / - VOLUME. 5.To switch off t
4、he radio, press the TIME/ALARM button. TUNING TO A STATION (see figure 6) Manual tuning: 1.Press/briefly to find your station. Repeat until you have found the desired station. Automatic tuning: Press and hold/until the display frequency starts to change frequency. When a station of sufficient streng
5、th has been found, tuning will stop. Or you can stop the automatic tuning search by pressing either /again. Repeat until you have found the desired station. PRESET STATIONS (see figure 6) Storing preset stations You can program up to five radio stations for each band. If you like, you can also repla
6、ce a preset station with another frequency. The current station will be indicated by a square round the preset number in the display. E.g. 1.Tune to your desired station (see RADIO RECEPTION). 2.As soon as you have found your station, press and hold a preset number 1-5. Release the number when you h
7、ear a double beep confirming that the station has now been set. Selecting preset stations Select and press a preset number, 1-5. SLEEP TIMER (see figure 7) About SLEEP TIMER This feature is a built-in timer device which enables the set to be automatically switched off during CD / radio playback, aft
8、er a set period of time. There are three timer options: 60 , 30 and 15 minutes. Setting SLEEP TIMER 1.Press the SLEEP TIMER button rapidly once or more to select your timer options: 60 , 30 and 15 minutes. =The display will show S SL:L: and the timer options briefly. =appears when the timer is activ
9、e. 2.To cancel the timer, you can either press: TIME/ALARM REPEAT ALARM/ BRIGHTNESS CONTROL CD/RADIOOFF 1 CD/RADIOOFF CD / RADIOSLEEP TIMERALARMCD SELECTING CD WAKE-UP ALARM MODE You can program and select a CD track number between 1-99, when the set is in the standby or radio playback mode. However
10、, if the track number programmed does not exist on your CD, the CD will start playback from the first track during the alarm call. 1.Set the alarm time for AL1 TIME. 2.Insert a CD into the CD compartment. 3.Press ALARM 1 to select CD alarm mode. 4.Press WAKE-UP TRACK to activate favorite track progr
11、amming. 5.Press or until the desired track number is shown. 6.Press WAKE-UP TRACK to confirm the selected track number. = The display returns to standby clock time. 7.If you want to review your programmed track number, press WAKE-UP TRACK. IMPORTANT! Thebuzzer alarm option will automatically replace
12、 the CD alarm if you have: inserted a CD incorrectly; inserted a damaged CD; forgotten to insert any CD; not closed the CD door properly. SWITCHING OFF THE ALARM (see figure 4) There are three ways of switching off the alarm. Unless you cancel the alarm completely, the DAILY ALARM RESET option will
13、be automatically select- ed after 59 minutes, from the time your alarm time first sounds. DAILY ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: Press and hold DAILY ALARM RESET =You will hear a beep tone to confir
14、m that the alarm reset has been activated. REPEAT ALARM This will repeat your alarm call at 9 minute intervals. During the alarm call, press REPEAT ALARM/ BRIGHTNESS CONTROL. Repeat as often as desired. = Your alarm mode indication , will flash throughout the time the repeat alarm is active. CANCELL
15、ING THE ALARM COMPLETELY When an alarm is cancelled this is shown by the selected alarm indication and symbol disappearing from the display. To cancel the set alarm time before it goes off: Press ALARM 1 or ALARM 2 until the alarm icons /disappears from the display. CD PLAYBACK (see figure 5) 1.Inse
16、rt a CD with the printed side facing up, and close the door. 2.Press the CD button to start playback. =Display shows: Cd: - and the total number of tracks, then your current track number, before returning to clock time =CD touch screen controls appears throughout CD operation. Other possible CD indi
17、cations before return- ing to clock time: =door is shown if the CD door is not closed. =noCd is shown if no CD has been inserted / inserted incorrectly. =nFCd is shown if the CD-R(W) is non-finalized =Err indicates a general error in operation of the set. 3.Adjust the sound with+/-VOLUME. 4To interr
18、upt, press =flashes. 5.Press again to resume playback. 6.Press to stop playback. Or press TIME / ALARMto return to standby mode. CD/RADIOOFF CD Helpful Tip : If you want the alarm to wake you up, FIRST CHECK: -you have disconnected the headphones. -radio alarm : make sure you have tuned properly to
19、a station. Helpful Tip During an alarm call/ repeat alarm, only the DAILY ALARM RESET, REPEAT ALARM/ BRIGHT- NESS CONTROL and ALARM 1 or ALARM 2 and+ / - VOLUME controls on the set will operate. Helpful Tip : In the CD stop position, the CD touch screen display remains active for 5 minutes. Press to
20、 start playback again if you have stopped briefly e.g. to change a CD. INSTRUCTIONS FOR USE 3 - 5 Continuous crackling/ hiss disturbance during AM broadcast Electrical interference from TVs, computers, fluorescent lamps, etc. Move set away from other electrical equipment The alarm does not function
21、Alarm mode not selected See chapter on SETTING THE ALARM Alarm time not set See chapter on SETTING THE ALARM. MAINTENANCETROUBLESHOOTING General (see figure 8) If you do not intend to use the set for a long time, withdraw the plug from the wall outlet. Do not expose the set, to humidity, rain, sand
22、or excessive heat caused by heating equipment or direct sunlight. To clean the set, use a soft, dry cloth. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the products surface. CD player and CD handling (see figure 9) The lens of the CD player shoul
23、d never be touched! Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. Always shut the CD
24、 door to keep the CD compartment dust-free. To clean, dust the compartment with a soft dry cloth. To clean the CD, wipe in a straight line from the center towards the edge using a soft, lint-free cloth. Do not use cleaning agents as they may damage the disc. Never write on a CD or attach any sticker
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Philips-AJ-3980-Service-Manual1 电路图 维修手册 Philips AJ 3980 Service Manual 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


