Philips-EXP-323-Service-Manual(1) 电路图 维修手册.pdf

《Philips-EXP-323-Service-Manual(1) 电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《Philips-EXP-323-Service-Manual(1) 电路图 维修手册.pdf（27页珍藏版）》请在收音机爱好者资料库上搜索。

1、Technical specification .1-1 Accessories .1-1 Instruction For Use.1-2.1-6 Safety 7VOL ! 2 2. 1. QUICKSTARTMISE EN SERVICE RAPIDE TROUBLESHOOTING Troubleshooting WARNING: Under no circumstances should you try to repair the set yourself as this will invalidate the warranty. If a fault occurs, fi rst c

2、heck the points listed, before taking the unit for repair. If you are unable to solve a problem by following these hints, consult your dealer or service center. ProblemSolution No power, playback Insert the batteries correctly. does not start Replace the batteries. Connect the mains adapter securely

3、. HoldHold indication Deactivate HOLD. and/or no reaction Disconnect the set from the power to controlssupply or take out the batteries for a few seconds. No sound or Press 2; to resume playback. bad sound quality Adjust the volume. Check and clean the connections. Keep this set away from active mob

4、ile phones or strong magnetic fi elds. Insert CDInsert CD Insert a disc, label upwards. or Clean or replace the disc. No audio fileNo audio file Wait until the steamed up lens has indicationcleared. Make sure you have inserted an audio disc or an MP3-CD. ProblemSolution Disc errorDisc error Make sur

5、e the inserted CDR or CDRW indicationis recorded correctly . Music fi le is not played Make sure that the fi le names of the MP3 fi les end with .mp3 Missing directories on Make sure the total number of MP3-CD fi les and albums on your MP3-CD does not exceed 400. Only albums with MP3 fi les are show

6、n. The disc skips tracks Clean or replace the disc. Make sure repeat, repeat album, shuffl e or prog are not selected. Music skips or Play the music fi le on your com popping sound whenputer. If the problem persists, playing an MP3 fi leencode the audio track again and make a new CD-ROM. OopsOops in

7、dication Switch ESP on. Damaged disc. In-car use: Clean the cigarette lighter jack No power, playback Switch on the ignition of your car. does not start In-car use: Insert the cassette adapter correctly. No sound or Change the autoreverse direction of bad sound qualityyour car cassette player. Let t

8、he set adjust to the temperature in the car. INSTRUCTION FOR UES RadioFans.CN 收音机爱 好者资料库 1-3 Maintenance Do not touch the lens A of the set. Do not expose the set, battery or discs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). The lens may cloud over whe

9、n the set is suddenly moved from cold to warm surroundings. Playing is not possible then. Leave the set in a warm environment until the moisture evaporates. Active mobile phones in the vicinity of this set may cause malfunctions. Avoid dropping the set as this may cause damage. Clean the set with a

10、soft, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect. To clean a disc, wipe it in a straight line from the centre towards the edge using a soft, lint-free cloth. Cleaning agents may damage the disc. MP3 music fi les How to organize music fi les In order to easily

11、 handle the large number of music fi les on a CD-ROM, you can organize them in folders (“albums”). The tracks of an album will be played in alphabetical order. If you want to arrange them in a certain order, let the fi le names start with numbers. For example: 001-ONEWORLD.MP3 002-FIRESTARTER.MP3 00

12、3-DEEP.MP3 The albums will be arranged in alphabetical order. If albums are located in an album, they will be played after this album. Albums without MP3 fi les will be skipped. If there are MP3 fi les which you did not put into an album, you will fi nd them in the album Various with album number 0.

13、 Various is the fi rst album that will be played. How to make a CD-ROM with MP3 Use your computers CD burner to record (“burn”) the music fi les from your hard disc on a CD-ROM. Use either ISO 9660 disc format or UDF. Some CD burner software like e. g. “DirectCD” support the UDF format. Make sure th

14、at the fi le names of the MP3 fi les end with .mp3. EnglishCONTROLS / GENERAL INFORMATION C ontrols ( see fi gure 1 ) 1 VOL E .adjusts the volume 2 OPEN 2.opens the CD lid 3 9.stops playback and switches the set off 4 MODE.selects playback options such as shuffl e and repeat 5 .MP3-CD only: select t

15、he previous album or fast track backward 6 +.MP3-CD only: select the next album or fast track forward 7 PROG.programs tracks and lets you review the program 8 DISPLAY.selects the track and album information for MP3-CDs 9 .display 0 2;.switches the set on, starts playback and interrupts playback ! DB

16、B.selects the bass adjustment: press and hold for 2 seconds or more for acoutic feedback on / off adjustment .skips forward and searches forward # .skips backward and searches backward $ ESP.ELECTRONIC SKIP PROTECTION prevents music interruptions caused by shocks % OFF.switches RESUME and HOLD off R

17、ESUME.stores the last position played HOLD.locks all buttons LINE OUT/p.3.5 mm line out to connect - the headphones - this set to the audio input of your stereo equipment to start playback. .yEXpaniumEXpanium and Reading CDReading CD are displayed briefl y. Playback starts.The current track number a

18、nd the elapsed playing time are displayed. For a MP3 track, the album number is also displayed and the fi le- name is scrolled once. 4Press 9 to stop playback. yThe total number of tracks the number of albums on an MP3-CD and the total playing time (of an audio disc only) are displayed. 5 To remove

19、the disc, hold it by its edge and press the hub gently while lifting the disc. 6 Press 9 again to switch off the player. Notes: - After pressing 2; it may take some time until the fi rst MP3 track is played. - The display clears automatically after 20 seconds if no controls are operated in the stop

20、mode. GENERAL INFORMATION / POWER SUPPLY Supported formats This set supports: Disc format: ISO 9660, Joliet, Multisession, UDF, Enhanced Music CD, Mixed Mode CD MP3 bit rate: 32320 kbps and variable bit rate Total number of music fi les and albums : around 400 All trademarks used are owned by their

21、respective owners. POWER SUPPLY / BASIC FUNCTIONS Mains adapter (supplied or optionally available) Only use the AY 3170 mains adapter (4.5 V/300 mA direct current, positive pole to the center pin). Any other product may damage the set. 1 Make sure the local voltage corresponds to the adapters voltag

22、e. If your mains adapter is equipped with a voltage selector, set this selector to the local mains voltage if necessary. 2 Connect the mains adapter to 4.5V DC on the set and to the wall outlet. Note: Always disconnect the adapter if you are not using it. Headphones (SBC HE205 or HL351) Connect the

23、supplied headphones to LINE OUT/p. Note: LINE OUT/p can also be used for connecting this set to your HiFi system. Adjust the volume and sound on both the CD player and your HiFi system. IMPORTANT! Hearing safety : Do not play your headphones at a high volume. Hearing experts advise that continuous u

24、se at high volume can permanently damage your hearing. Traffi c safety : Do not use headphones while driving a vehicle. It may create a hazard and it is illegal in many countries. Even if your headphones are an open-air type designed to let you hear outside sounds, do not turn up the volume so high

25、that you cannot hear what is going on around you. Batteries (supplied or optionally available) Inserting batteries Open the battery compartment and insert either 2 normal or alkaline batteries type AA (LR6, UM3). Old and new or different types of batteries should not be combined. Indication of empty

26、 batteries Replace the battery or connect the mains adapter as soon asblinks and Replace batteries is scrolled. Remove batteries if they are empty or if the unit will not be used for a long time. Batteries contain chemical substances, so they should be disposed of properly. A 2. 1. batReplace MP3 ST

27、OP456 RESUME HOLD L INE O O L. INSTRUCTION FOR USE 1-5 BASIC FUNCTIONS / FEATURES Pause 1 Press 2; to interrupt playback. yElapsed playback time freezes and fl ashes. 2 To resume playback press 2; again. Display information (for MP3 tracks only) 1 Press DISPLAY repeatedly during playback to select t

28、he information to be displayed : - Filename Filename: the tracks fi le name, - AlbumAlbum: the albums folder name, - ArtistArtist: the artists name (if this ID3 tag information is available), - TitleTitle: the tracks title (if this ID3 tag information is available), - the elapsed playing time. 2 The

29、 selected information is scrolled once. The album number and track number are displayed. Notes: The ID3 tag is part of an MP3 fi le and contains various track information such as the tracks title or the artists name. Complete the ID3 tag information with your MP3 encoder software before burning the

30、MP3-CD. BASIC FUNCTIONS / FEATURES Selecting and searching CD only Selecting a track during playback Briefl y press or once or several times to skip to the beginning of the current, previous or subsequent track. yPlayback continues with the selected track . Searching for a passage during playback 1

31、Keep or pressed to fi nd a particular passage in a backward or forward direction. ySearching is started and playback continues at a low volume. For CD audio tracks the search speeds up . 2 Release the button at the desired passage. yNormal playback continues. Selecting album and tracks on MP3-CDs Se

32、lecting an album during playback Briefl y press + or - once or several times to skip to the fi rst track of the previous or subsequent album. yThe fi rst track of the selected album is played. Selecting a track during playback 1 Keep + or - pressed to skip quickly to previous or subsequent MP3 track

33、s. ySkipping starts and speeds up . 2 Release the button at the desired track. yPlayback continues with the selected track. Note: To skip from track to track at low speed, use or . Programming track numbers You can select up to 50 tracks to play in a program. A single track may be stored more than o

34、nce in the program. 1 While playback is stopped, select a track with or . 2 Press PROG to store the track. yThe number of stored tracks are displayed. 3 Select and store all desired tracks in this way. 4 Press 2; to start playback of your selected tracks. y appears above prog You can review the prog

35、ramme by pressing PROG for more than 3 seconds. yThe display shows all the stored tracks in sequence. Notes: - If you press PROG and there is no track selected, Select trackor Select fileis displayed. - If you try to review without fi rst programming, No program is displayed - If you try to store mo

36、re than 50 tracks, Program fullis displayed. Clearing the programme While playback is stopped, press 9 to clear program. yProgram clearedProgram cleared is displayed once, program goes off, and the program is cleared. Notes: The programme will also be cleared if the power supply is interrupted, or i

37、f the CD-player lid is opened, or if the set switched off automatically. Volume and bass Volume adjustment Adjust the volume by using VOL E. Bass adjustment 1 Press DBB once or more to select the bass enhancement options: ymoderate bass enhancement is activated. ystrong bass enhancement is activated

38、. 2 Press DBB again to switch off the bass enhancement options. yor disappears Beep A beep confi rms that you have pressed a button or that the batteries are empty. During music mode only keep DBB pressed for 4 seconds to switch beep either on or off: yBeepBeep is display. Beep is switched on. yNo b

39、eepNo beep is display. Beep is switched off. Audio-Track 3:14 beepNo P:22 Added to prog 151 INSTRUCTION FOR USE 1-6 FEATURES Playing tracks repeatedly or in random order-MODE 1 Press MODE repeatedly during playback to select either: shuffl e all : All tracks of the disc are played in random order on

40、ce. shuffl e repeat all : All tracks of the disc are played repeatedly in random order. repeat : The current track is played repeatedly. repeat all : The entire disc is played repeatedly. shuffl e album (with MP3-CDs only): All tracks of the current album are played in random order once. shuffl e re

41、peat album (with MP3-CDs only): All tracks of the current album are played repeatedly in random order. repeat album (with MP3-CDs only): All tracks of the current album are played repeatedly. Your selected mode is marked by , , above the playmodes, album, shuffl e, repeat all. 2 Playback starts in t

42、he selected mode after 2 seconds. 3 To return to normal playback, press MODE repeatedly until repeat and shuffl e disappear. Storing the last position played-RESUME You can store the last position played. When restarting, playback wil continues from where you have stopped. 1 Switch the slider to RES

43、UME during playback to activate resume. y appears above resume. 2 Press 9 whenever you want to stop playback. 3 Press 2; to resume playback. yPlayback continues from where you have stopped. To deactivate RESUME, switch the slider to OFF. y disappears from resume. Locking all buttons-HOLD You can loc

44、k all buttons of the set. When you press any key, no action will be executed then. Switch the slider to HOLD to activate hold. y appears above resume and hold is displayed. All buttons are locked. When pressing any key, Hold is displayed. To deactivate HOLD, switch the slider to OFF. y disappears fr

45、om resume or hold. FEATURES / ACCESSORIES ESP and powersaving With a conventional portable disc player the music may stop while you are jogging for example. The ELECTRONIC SKIP PROTECTION protects this set against loss of sound caused by light vibrations or shocks. Continuous playback is ensured. ES

46、P does not protect the set against damage caused by dropping ! Press ESP repeatedly during playback to select either: yis shown and ESP is switched on. ydisappears. Powersaving is switched on. Belt Clip 1 Align the belt clip as indicated in the illustration and press on the clip to insert its shaped

47、 pin into the hole in the set. 2 Turn the clip clockwise as indicated to lock the belt clip to the set. To detach, gently lift the belt clip at the indicated end and turn it counter-clockwise. In-car connections (supplied or optionally available) Only use the AY 3545or AY 3548 car voltage converter

48、(4.5 V DC, positive pole to the centre pin) and the AY 3501 car cassette adapter. Any other product may damage the set. 1Put the set on a horizontal, vibration-free and stable surface. Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. 2Plug the voltage converte