Philips-HTS-3365-Mk1-Service-Manual(1) 电路图 维修手册.pdf
《Philips-HTS-3365-Mk1-Service-Manual(1) 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Philips-HTS-3365-Mk1-Service-Manual(1) 电路图 维修手册.pdf(35页珍藏版)》请在收音机爱好者资料库上搜索。
1、1 - 1 HTS3365/55 Copyright 2008 Philips Consumer Electronics B.V. Eindhoven, The Netherlands All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the pr
2、ior permission of Philips. Published by LM0811 Service Audio Printed in The Netherlands Subject to modification DVD Home Theater System Version 1.0 TABLE OF CONTENTS Service Manual Service ? ? 3139 785 33640 GB Chapter Location of PCB Boards.1-2 Versions Variation .1-2 Specifications .1-3 Measuremen
3、t setups.1-4 Service Aids.1-5 ESD .50-60 Hz Power Consumption .100 W Dimensions . 435 x 58 x 360 (mm) .(w x h x d) Weight . 3.75 kg FRONT AND REAR SPEAKERS System .Full range satellite Impedance .3 Speaker drivers . 3” full range speaker Frequency response .150 Hz 20 kHz Dimensions . 103 x 203 x 71
4、(mm) .(w x h x d) Weight .0.54 kg/each CENTRE SPEAKER System .Full range satellite Impedance . 6 Speaker drivers: .2 x 2.5” full range speaker+ . 1 x 2” tweeter Frequency response .150 Hz 20 kHz Dimensions . 440 x 105 x 75 (mm) .(w x h x d) Weight . 1.39 kg SUBWOOFER Impedance .6 Speaker drivers .16
5、5mm (6.5”) woofer Frequency response . 40 Hz 150 Hz Dimensions . 163 x 363 x 369 (mm) .(w x h x d) Weight . 5.08 kg Specif cations subject to change without prior notice. RadioFans.CN 收音机爱 好者资料库 1 - 4 MEASUREMENT SETUP CD Tuner FM Bandpass Tuner AM (MW,LW) Bandpass 1 - 5 1 - 6 1 - 7 2 - 12 - 1 Syste
6、m , Region Code , etc. Setting Produre 1)System Reset a) press “OPTIONS“ button on R/C,TV will show setup menu b) select the menu using the and on R/C c) go preference page to do sysytem reset 2)Region Code Change a) In open model,press”9” “9“ “9“ “9“ on R/C,then input desired number to change regio
7、n code : 1 USA 2 EU 3 AP 4 Australia ,NZ , Latam 5 Russia , INDIA 6 CHINA 3)Version Control Change a) In open model, press “1“ “5“ “9“ on R/C b) press “ok” button to conf rm c) TV will show message as below: 8) Upgrading new sofeware a) copy “sofeware f les” into a CD-R disc b) open the CD Door,then
8、 insert CD-R program disc c) close the CD Door d) VFD will show: “Loading“ “Erase” - erase the f ash memory “Writing” about 1 minute “done “ * the system will switch off and on again automatically. e) OSD will show: Current model HTS3365/55 Version: 00.12.01_1 Release: 2007.12.19 region : 4 Servo: 5
9、B.61.00.00 8032: 05.00.04.06 RISC:00.00.02.00 MCU: V04.08 IF current model does not match you set use down arrow key on the remote to change OK CAUTION! This information is confi dential and may not be distributed.Only a qualifi ed service person should reprogram the Region Code. 4)Password Change a
10、) press “OPTIONS “ button on R/C,TV will show setup menu b) select the menu using the and on R/C c) go preference page select “password“ to change * 000000 is default password supplied. 5)Check on the Sofeware Version a) open the CD Door b) press “INFO“ button on R/C c) TV will show the version on s
11、creen upgrade f le detected Do you wish to continue with the sofeware upgrade? OKCancel f) select “OK”, OSD will show: upgrade in process. V336X please do not unplug or switch off the device. 6)Trade model a) press “Open/Close “ button on R/C b) Press “2” “5” “9” on R/C,VFD will display “TRA ON “ or
12、 “TRA OFF“ 8) Produce to Change Tuner Grid (only applicable for certain regions) In some countries, the frequency step between adjacent channels in the (AM/MW)/FM band is 9kHz/50kHz(10kHz/100kHz in some areas). a) press “source” to select “FM” or “AM” b) In “FM” or “AM” playback mode, press & hold “
13、play/pause” button until “Grid 9” or “Grid 10” appears Note: repeating the same action will toggle back to it previous tuning grid setting. * “Grid 10” is default for/55 version. 2 - 22 - 2 REPAIR INSTRUCTIONS (part one) 2 - 32 - 3 REPAIR INSTRUCTIONS (part two) 2 - 42 - 4 REPAIR INSTRUCTIONS (part
14、three) 3 - 13 - 1 Figure 8 Figure 9 DISASSEMBLY INSTRUCTIONS 3) Loosen 7 screws and remove the Top Cover by lifting the rear portion upwards before sliding it out towards the rear. - 1 screw “A” each on the left & right side as shown in f gure 4 - 5 screws “B” at the back panel as shown in f gure 5
15、4) Loosen 1 screw “C“ each left & right side on the front panel after move the top panel as shown in f gure 6. 5)Loosen 6 screws “D” at bracket of front panel as shown in f gure 7 A Figure 4 B Figure 5 Dismantling of the AMP Board 1) Loosen 4 screws to remove the AMP Board. - 2 screws “ E “ on the t
16、op of AMP board as shown in f gure 8 - 2 screws “ F “ at the back panel as shown in f gure 9 Push 24mm mm2 Figure 1 Figure 3 Figure 2 Dismantling of the Front Panel Assemble 1) Open the DVD Tray by using the Open/Close Button while the Set is ON and disconnect the mains supply after removing the Tra
17、y Cover. Note: If this is not possible, the DVD Tray has to be open manually. Take a mini screw driver about 2mm diameter and make a marking 24mm from the tip as shown in f gure 2 . Place the set on its side, insert the mini screw driver till the marking and slide it towards the right as shown in f
18、gure 1 until the Tray moves out of the Front Panel. 2) Return the set to its upright position and remove the Tray Cover as shown in Figure 3 and close the tray manually by pushing it back in. C Figure 6 D Figure 7 E F 3 - 23 - 2 Dismantling of the VFD+JACK+VOL+STANDBY Board 1) Loosen 9 screws “J” on
19、 the top of control board as shown in 13 Figure 13 Dismantling of the Main Board 1) Loosen 2 screws “ G “ on the top of main board as shown in f gure10 2) Loosen 7 screws “H” at the back panel as shown in f gure 11 Figure 10 Figure 11 Figure 12 Dismantling of the Power Board 1) Loosen 4 screws “ I“
20、on the top of power board as shown in f gure 12 G H I J SERVICE POSITIONS service position A (main unit) Note:In some service positions the components or copper patterns of one board may risk touching its neighbouring pc boards or metallic parts. To prevent such short-circuit use a piece of hard pap
21、er or other insulating material between them. Figure 14 Dismantling of the DVD Module 1) Loosen 4 screws “K” as shown in f gure 14. K 4 - 14 - 1 BLOCK DIAGRAM 4 - 24 - 2 WIRING DIAGRAM ? ? ? 5 - 15 - 1 CONTROL BOARD TABLE OF CONTENTS FTD Display Pin Assignment .5-1 Circuit Diagram .5-2 PCB Layout To
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Philips-HTS-3365-Mk1-Service-Manual1 电路图 维修手册 Philips HTS 3365 Mk1 Service Manual 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


