Sony-STEX770-tun-sm 电路图 维修手册.pdf
《Sony-STEX770-tun-sm 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Sony-STEX770-tun-sm 电路图 维修手册.pdf(20页珍藏版)》请在收音机爱好者资料库上搜索。
1、ST-EX770 AEP Model UK Model SERVICE MANUAL MICROFILM Ref. No.Part No. Description 9-922-857-11 Sony Corporation Home A&V Products Company FM STEREO/FM-AM TIMER TUNER 98D001648-1D Printed in Japan 1998.4 Published by Quality Assurance Dept. (Shibaura) ST-EX770 is the tuner section in MHC-EX660 and DH
2、C-EX770MD. The mechanical and electorical specifications of ST-EX770 is almost same as ST-EX77 AEP/UK model. So this manual contains only the points which differ from ST-EX77. For the informations not contained in this manual, please refer to the ST-EX77 service manuals (9-960-933- ) previously issu
3、ed. PARTS LIST(The difference between ST-EX77 and ST-EX770) Page * 64-985-904-11PANEL(ST), BACK 51X-4948-355-1PANEL ASSY, FRONT 53X-4947-762-1BUTTON(TIMER) ASSY 544-985-890-01BUTTON(MODE) 56X-4948-356-1BUTTON(MEMO) ASSY (MEMORY, ST/MONO) 574-985-892-21BUTTON(PLAY) (TUNER/BAND, TUNING MODE) 614-985-9
4、25-01KNOB(JOG) Ref. No.Part No.Description 22 ST-EX77 ST-EX770 Items marked “*” are not stocked since they are seldom required for routine service. Some delay should be anticipated when ordering these items. * 64-985-904-31 PANEL(ST), BACK 51X-4949-865-1 PANEL ASSY, FRONT 53X-4949-932-1 BUTTON(TIMER
5、) ASSY 544-985-890-11 BUTTON(MODE) 56X-4949-933-1 BUTTON(MEMO) ASSY (MEMORY, ST/MONO) 574-985-892-41 BUTTON(PLAY) (TUNER/BAND, TUNING MODE) 614-985-925-11 KNOB(JOG) 23 RadioFans.CN 收音机爱 好者资料库 MICROFILM ST-EX77 AEP Model UK Model E Model SERVICE MANUAL This set is the tuner section in MHC-EX66,DHC-EX
6、77MD/MD77. FM STEREO/FM-AM TIMER TUNER SPECIFICATIONS AEP, UK models: Hong Kong, Singapore models: 90 RadioFans.CN 收音机爱 好者资料库 2 TABLE OF CONTENTS Servicing Notes . 2 1.GENERAL Listening to the Radio .3 Labeling the Preset Stations .4 Using the Radio Data System (RDS) .5 2.DISASSEMBLY.7 3.ELECTRICAL
7、ADJUSTMENTS.8 4.DIAGRAMS 4-1.IC Pin Function Description.9 4-2.Printed Wiring Boards . 11 4-3.Schematic Diagram . 15 5.EXPLODED VIEWS. 22 6.ELECTRICAL PARTS LIST. 24 SAFETY-RELATED COMPONENT WARNING! COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PART
8、S LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY. MODEL IDENTIFICATION Back Panel How to operate with a single unit. Normally, this set is not operated with its own. The exclusive jig
9、 (J-2501-078-A) and service box (PFJ-1) are nec- essary to operate the set with a single unit. Turn the power set of the service box ON. Then press the ENTER/NEXT button and SLEEP button at the same time to turn the power on. Connection: SERVICING NOTES KEY/FL tube/LED check mode. To enter KEY/FL tu
10、be/LED check mode, press the ENTER/NEXT and REC buttons at the same time. Under mode, every time when press any key or turn MULTI CONTROLLER knob, change to next situation. 1 All LED indicators light on 2 All FL tube indicators light on 3 A part of FL tube light on mode 1. (Indicated ST-SEG) 4 A par
11、t of FL tube light on mode 2. (Indicated RDS-SEG) 5 KEY check mode Note: 1) All LED light on mode is kept, when buttons which is pressed to enter all LED light on mode, release same time. When release them separate timing, it is moved to next All LED light on mode. 2) After all LED light on mode, li
12、ght on point remove one by one, when any button pressed or MULTI CONTROLLER knob turned. 3) Under KEY check mode, every time buttons pressed numeri- cal value of “KEY” in FL tube increase. And that time, numerical value of “ECDR” increase when MULTI CONTROLLER button turn to + direction, and it decr
13、ease turn to direction. When you want to finish this mode, unplug the power of amplifier or turn off PFJ-1 of POWER switch. 4-985-904-1 : AEP, UK model 4-985-904-2 : Hong Kong, Singapore model POWER SW FH-E939, 838,937 CDP/TCCN904 17P CN902 7P CN101 7P JIG (J-2501-078-A) SERVICE BOX (PFJ-1) SET SYST
14、EM CONTROL CORD WITH CONNECTOR 7P (attached to set) CORD WITH CONNECTOR 17P (attached to PFJ-1) RadioFans.CN 收音机爱 好者资料库 3 This section is extracted from instruction manual. SECTION 1 GENERAL AEP, UK models AEP, UK models: Hong Kong, Singapore models Hong Kong, Singapore models: Hong Kong, Singapore
15、models: AEP, UK models: For AEP, UK models: For Hong Kong, Singapore models: 4 For Hong Kong, Singapore models: Hong Kong, Singapore models: AEP, UK models: For AEP, UK models: http:/getMANUAL.com 5 (AEP, UK models only) 6 Precautions in Repairing If the front unit fails, it is difficult to repair t
16、he inner circuits, so replace the entire front end unit. The FM TUNED level must be adjusted after the AM TUNED level adjustment has completed. AM SECTION AM Tuning Level Adjustment Setting : BAND switch : MW(AM) SECTION 3 ELECTRICAL ADJUSTMENTS AM RF signal generator 30 % amplitude modulation by 40
17、0 Hz signal Carrier frequency : 999 kHz (at 9 k step) 1,000 kHz (at 10 k step) Output level : 25 dB loop antenna set loop antenna supplied accessories 60 cm AM antenna terminal field strength dB(V/m)= RF SSG output level dB (V/m)26 dB Procedure: 1.Set loop antenna A so that the loop antenna B input
18、level be- comes 55 dB/m. 2.Tune the set to 999 kHz or 1,000 kHz. 3.Adjust RV1 so that the TUNED indicator goes on. Adjustment Location : MAIN board. FM SECTION FM Tuning Level Adjustment Setting : BAND switch : FM Adjustment Location : MAIN BOARD Component Side CN101TM1 RV2 FM Tuning Level Adjustmen
19、t RV1 AM Tuning Level Adjustment FE2 IC1 CN102 SECTION 2 DISASSEMBLY Procedure: 1.Tune the set to 98 MHz. 3.Adjust RV2 so that the TUNED indicator goes on. Adjustment Location : MAIN board. 7 8 FM RF Stereo signal generator Carrier frequency : 98 MHz Moduration : AUDIO 1kHz,75 kHz deviation (100%) O
20、utput level : 26 dB (17.8 V) set FM antenna terminal (75 coaxial) Note: Follow the disassembly procedure in the numerical order given. 1 two screws (case 3 TP2) 1 two screws (case 3 TP2) 4 three screws (BVTP3 10) 8 main board 3 flat wire (19 core) (CN102) 7 two claws 2 case 6 claw 5 two screws (BVTP
21、3 8) SECTION 4 DIAGRAMS 4-1. IC PIN FUNCTION DESCRIPTION MAIN BOARD IC201 PD78013FGC-544-AB8 (SYSTEM CONTROL) 41X2O System main clock. (10 MHz) 42X1I 43GNDGround 44XT2O System sub clock. (32.768 kHz) 45XT1I 46GNDGround 47KEY IN K1I 48KEY IN K2IKey input. (analog) 49KEY INI 50GND 51GND 52GNDGround 53
22、GND 54GND 55AVDDAnalog power supply +5V. 56AVREFIAnalog system reference voltage input. 57GNDGround 58SDATAOFlourescent indicator tube data output. (IC601) 59SCKOFlourescent indicator tube clock output. (IC601) 60CSOFlourescent indicator tube chip select signal output. (IC601) 61RESETOFlourescent in
23、dicator tube reset signal output. (IC601) 62ERRORSI 63CORRECTIONONot used. (open) 64RECEIVEDO Pin No.Pin NameI/OFunction 1DESTINATIONI 2DESTINATIONI Destination selection input. 3DESTINATIONI 4DESTINATIONI 5IF +50I Not used. (Ground) 6IF 50O 7BACK UPIBack up mode input. 8NCNot used. (open) 9VssGroun
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Sony-STEX770-tun-sm 电路图 维修手册 Sony STEX770 tun sm 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


