Philips-PET-1002-Service-Manual(1) 电路图 维修手册.pdf
《Philips-PET-1002-Service-Manual(1) 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Philips-PET-1002-Service-Manual(1) 电路图 维修手册.pdf(26页珍藏版)》请在收音机爱好者资料库上搜索。
1、DVD Portable Player PET1002/PET1008 All version 3141 785 30824 TABLE OF CONTENTS Chapter Safety Instructions 2 Instruction for Use3 Mechanical Instructions 4 Troubleshooting & Service Tips 5 Overall Block Diagram 6 Overall Wiring Diagram 7 Electrical Diagram 8 Component Layout. 9 Exploded View Diagr
2、am & Service Part List.10 Revision List. 11 Service Manual Technical Specification 1 OSD TEST CONFIGURATION SETUP Copyright 2005 Philips Consumer Electronics B.V. Eindhoven, The Netherlands All rights reserved. No part of this publication may by reproduced, stored in a retrieval system or transmitte
3、d, in any form or by any means, electronics, mechanical, photocopying, or otherwise without the prior permission of Philips Version 1.4 RadioFans.CN 收音机爱 好者资料库 1.0 TECHNICAL SPECIFICATION General Dimensions (WxLxH):26 x 18 x 3.0 cm 10.2 x 7 x 1.2 inches Weight:1.13 kg / 2.48 lb Power supply:DC 9V 2.
4、2A Power consumption:30W Operating temp. range:0 - 50C (32 122F) Laser wavelength:650nm Video system:NTSC / PAL / AUTO Frequency response:20Hz 20KHz 1dB Signal/noise ratio:85dB Audio distortion + noise:-80(1KHz) Channel separation:85dB Dynamic range:80dB Output Audio out (analog audio):Output level:
5、 2V 10% Load impedance:10K Video out Output level:1Vp - p 20% Load impedance:75 Current consumption DC-IN SUPPLY (9.0V) Battery Charging Current1.2A typ. BATT. SUPPLY (7.2V) Power Off0A Playback with TFT on1.2A typ. Playback without TFT on2.5hrs Headphone out (headphone output load 2x16ohm) Maximum
6、output power:10mW Frequency response:20Hz - 20kHz SNR (A-wght):80dB typ. THD (1kHz):1% Left-Right Channel Separation: 32dB typ. Left-Right Channel Balance: 1dB Supported disc type DVD video discs: Audio CD: DivX video discs: In addition, this unit can play DVD+R & DVD+RW and CD-R & CD-RW that contai
7、ns audio titles or MP3 or JPEG files. You cannot play disc other than the above listed. (CVD, CD-ROM, CD-Extra, CD-G and CD-I discs cannot be played on this DVD player) Software upgrades For the best performance of your DVD Portable. Check for latest software upgrades available. To check the softwar
8、e version of your DVD Portable. 1.Press the SETUP key to enter the setup menu. 2.Press RETURN and then press 1. 2 and 3 on the remote control. 3.The display will show the software version as the date of which the software was built on the bottom of the screen. E.g. 050303 Procedure on how to upgrade
9、 the software of the DVD Portable 1.Download the latest software from the Philips support site. 2.Unzipped the files and then burn it onto a CD ROM then playback the CD ROM on the DVD Portable. Pixel specification B To repeat or loop a sequence in a title PLAY-MODE Selects play order options 7 0 - 9
10、 Numeric keypad 8 MUTE Muting play volume REPEAT Repeats chapter / title / disc 9 RETURN For VCD menu page ANGLE Selects DVD camera angle SUBTITLE Subtitle language selector LANGUAGE Language selector MENU Displays MENU page SETUP Enters SETUP menu Remote Control ? Up / down / left / right cursor Co
11、nfirms selection On Screen Display on / off INFRA RED PORT BATTERY COMPARTMENT 10 11 12 13 14 Pause playback Press twice to stop playback ? ? / For previous ( ) or next ( ) chapters, tracks or titles ? ? ? / Search backward ( ) or search forward ( ) ? ? ? ? Starts / resumes playback ? VOLUME Volume
12、control ? 4.0 MECHNICAL INSTRUCTIONS Fig.1 12 screws soldered 1. Back View as Fig.1 Remove 12 screws to remove base 2. Soldered short pattern for laser diode as Fig.2 3. Fig.2 Remove DVD driver and main board as Fig.3,4 Broken connection of DVD driver and main board Fig.3 4. Remove key board and oth
13、er parts as Fig.5 Fig.5 5. Remove top cover as Fig.6 Fig.4 Remove DVD driver and main board Fig.6 6 screws 6. Remove IF board and HV board as Fig.7 7. Fig.7 Remove LCD TFT as Fig.8 Remove serew to remove LCD TFT as Fig.8 Fig.8 remove screws remove screws remove screws 5.0 TROUBLESHOOTING & SERVICE T
14、IPS Procedure to change regioncode 1.Power on player and open DVD Door. 2.Press at Remote Control. In select then press . 3.For PET1002 - Press successively 2 1 2 2 2 5. . . 4.Display will show for Europe: 5.Press key to input preference region code (see below table). 6.Switch off and re-switch on t
15、he product. Verify Region code change done.7. Region CodeRegion 1USA 2EUROPE 3ASIA PACIFIC 4 AUSTRALIA, NEW ZEALAND, LATAM 5 RUSSIA, INDIA 6 CHINA REMARKS: 1. Password is CONFIDENTIAL. 2. Region code is printed on product type plate. Due to DVD legislation region codes different to assigned region m
16、ay not be released. 5.0 TROUBLESHOOTING & SERVICE TIPS no replace cable/ adapter SYMPTOM: NO POWER, NO GREEN LED Check if the power cable and AC adapter OK? No defect, return set to customer yes start set OK? Check if the power and play button OK? replace connector and switch unit replace MAIN BOARD
17、 go to other SYMPTOM no yes yes no replace DVD drive SYMPTOM: NO IMAGE OR SOUND COMES OUT FROM THE EXTERNAL OUTPUT start Check operation of the DVD drive. Does the DVD drive work? yes no Replace the main board or the connector 5.0 TROUBLESHOOTING & SERVICE TIPS no SYMPTOM: THE INITIAL SCREEN IS NOT
18、DISPLAYED ON THE LCD Check if the LED on the front lights up? start Check if the backlight is OK? Check if the lighting of the LCD is OK? Open the top and bottom assembly to check the connector harness Open the top and bottom assembly to check the connector to the main board yes yes no no yes Refer
19、to the symptom NO POWER, NO GREEN LED Is the connector harness broken? Replace broken harness yes Remove the LCD cover and plate of the LCD unit to check the connector of the FL harness Is the connector OK? no Repair connector Replace FL inverter or LCD no yes Is the connector broken? Replace LCD ha
20、rness or main board yes Remove the LCD cover and plate of the LCD unit to check the connection of the harness to the LCD unit no Is the connection OK? Connect the LCD harness to the LCD unit no Replace LCD unit or main board yes Replace LCD unit or main board SYMPTOM: NO IMAGE OR SOUND COMES OUT FRO
21、M THE EXTERNAL INPUT start Replace the main board or the connector 5.0 TROUBLESHOOTING & SERVICE TIPS SYMPTOM: THE DVD DRIVE DOES NOT WORK start Check the optical pick up lens? yes Pick up lens does not light up at all Press the DISC cover switch at the center of the DVD player and turn on the power
22、. Then check whether or not the optical pick- up lens of the DVD drive lights. CAUTION: Visible laser radiation when open and interlock defeated. Do not stare into Laser beam. Replace DVD drive Pick up lens light up dim Check the connectors of the DVD drive and main board? OK Secure the connection o
23、f the DVD drive and main board Not OK Pick up lens light up OK Insert a DVD disc and turn on the power What is the reaction of the DVD drive? The DVD drive works but the initializing operation of the optical pick-up lens does not start (the optical pick-up lens operates twice), or abnormal noise sou
24、nd Replace DVD drive or main board DVD drive does not work The operation of the DVD player stops at initializing display. Is there any message shown on display oading?displayed Nothing on display Check the DVD disc for fingerprints, dirt, HECK DISK?displayed Is the DVD disc OK? DVD disc OKDVD disc d
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Philips-PET-1002-Service-Manual1 电路图 维修手册 Philips PET 1002 Service Manual 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


