Philips-PET-825-Service-Manual(1) 电路图 维修手册.pdf
《Philips-PET-825-Service-Manual(1) 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Philips-PET-825-Service-Manual(1) 电路图 维修手册.pdf(28页珍藏版)》请在收音机爱好者资料库上搜索。
1、DVD Portable Player PET821/824/825 All version 3141 785 30966 TABLE OF CONTENTS Chapter Technical Specification 1 Safety Instructions 2 Instruction for Use3 Mechanical Instructions 4 Troubleshooting & Service Tips 5 Overall Block Diagram 6 Overall Wiring Diagram 7 Electrical Diagram 8 Component Layo
2、ut. 9 Service Part List.10 Revision List. 11 Service Manual OSD TEST CONFIGURATION SETUP Copyright 2005 Philips Consumer Electronics B.V. Eindhoven, The Netherlands All rights reserved. No part of this publication may by reproduced, stored in a retrieval system or transmitted, in any form or by any
3、means, electronics, mechanical, photocopying, or otherwise without the prior permission of Philips Version 1.6 RadioFans.CN 收音机爱 好者资料库 1.0 TECHNICAL SPECIFICATION General Dimensions (WxLxH) : 22 x 17.7 x 3.2 cm 8.7 x 6.9 x 1.3 inches Weight : 0.94 kg / 2 lb Power supply : DC 9V 2.2A Power consumptio
4、n : 30W Operating temp. range : 0 - 50C (32 122F) Laser wavelength: 650nm Video system : NTSC / PAL / AUTO Frequency response : 20Hz 20KHz 1dB Signal/noise ratio 85dB Audio distortion + noise 80(1KHz) Channel separation: 85dB Dynamic range 80dB Output Audio out (analog audio) Output level: 2V 10% Lo
5、ad impedance: 10K Video out Output level: 1Vp - p 20% Load impedance: 75 Current consumption DC-IN SUPPLY (9.0V) Battery Charging Current 1.2A typ. BATT. SUPPLY (7.2V) Power Off 0A Playback with TFT on 1.2A typ. Playback without TFT on 2.5hrs Headphone out (headphone output load 2x16 ohm) Maximum ou
6、tput power : 10Mw Frequency response : 20Hz - 20kHz SNR (A-wght) : 80dB typ. THD (1kHz) : 1% Left-Right Channel Separation : 32dB typ. Left-Right Channel Balance : 1dB Supported disc type DVD video discs: Video CD: Audio CD : DivX video discs: In addition, this unit can play DVD+R & DVD+RW and CD-R
7、& CD-RW that contains audio titles or MP3 or JPEG files. You cannot play disc other than the above listed. (CVD, CD-ROM, CD-Extra, CD-G and CD-I discs cannot be played on this DVD player) Software upgrades For the best performance of your DVD Portable. Check for latest software upgrades available. T
8、o check the software version of your DVD Portable. 1. Press the SETUP key to enter the setup menu. 2. Press RETURN and then press 1, 2 and 3 on the remote control. 3. The display will show the software version as the date of which the software was built on the bottom of the screen. E.g. 050303 Proce
9、dure on how to upgrade the software of the DVD Portable 1. Download the latest software from the Philips support site. 2. Unzipped the files and then burn it onto a CD ROM then playback the CD ROM on the DVD Portable. Pixel specification B To repeat or loop a sequence in a title PLAY-MODE Selects pl
10、ay order options 7 0 - 9 Numeric keypad 8 MUTE Muting play volume REPEAT Repeats chapter / title / disc 9 RETURN For VCD menu page ANGLE Selects DVD camera angle SUBTITLE Subtitle language selector LANGUAGE Language selector MENU Displays MENU page SETUP Enters SETUP menu Remote Control ? Up / down
11、/ left / right cursor Confirms selection On Screen Display on / off INFRA RED PORT BATTERY COMPARTMENT 10 11 12 13 14 Pause playback Press twice to stop playback ? ? / For previous ( ) or next ( ) chapters, tracks or titles ? ? ? / Search backward ( ) or search forward ( ) ? ? ? ? Starts / resumes p
12、layback ? VOLUME Volume control ? 4.0 MECHNICAL INSTRUCTIONS Fig.1 soldered 1. Back View as Fig.1 Remove screws to remove base 2. Soldered short pattern for laser diode as Fig.2 3. Fig.2 Remove DVD driver and main board as Fig.3,4 Disconnect DVD driver and main board Fig.3 4. Remove key board and ot
13、her parts as Fig.5 Fig.5 5. Remove top cover as Fig.6 Fig.4 Remove DVD driver and main board Fig.6 6. Remove PTH board as Fig.7. 7. Fig.7 Remove LCD TFT as Fig.8. Fig.8 5.0 TROUBLESHOOTING & SERVICE TIPS Procedure to change regioncode 1.Power on player and open DVD Door. 2.Press at Remote Control. I
14、n select . 3.For PET824 - Press successively 2 1 2 2 2 5. . .OK 4.Display will show for Europe: 5.Press key to input preference region code (see below table). 6.Switch off and re-switch on the product. Verify Region code change done.7. Region CodeRegion 1USA 2EUROPE 3ASIA PACIFIC 4 AUSTRALIA, NEW ZE
15、ALAND, LATAM 5 RUSSIA, INDIA 6 CHINA REMARKS: 1. Password is CONFIDENTIAL. 2. Region code is printed on product type plate. Due to DVD legislation region codes different to assigned region may not be released. 5.0 TROUBLESHOOTING & SERVICE TIPS no replace cable/ adapter SYMPTOM: NO POWER, NO GREEN L
16、ED Check if the power cable and AC adapter OK? No defect, return set to customer yes start set OK? Check if the power and play button OK? replace connector and switch unit replace MAIN BOARD go to other SYMPTOM no yes yes no replace DVD drive SYMPTOM: NO IMAGE OR SOUND COMES OUT FROM THE EXTERNAL OU
17、TPUT start Check operation of the DVD drive. Does the DVD drive work? yes no Replace the main board or the connector 5.0 TROUBLESHOOTING & SERVICE TIPS no SYMPTOM: THE INITIAL SCREEN IS NOT DISPLAYED ON THE LCD Check if the LED on the front lights up? start Check if the backlight is OK? Check if the
18、 lighting of the LCD is OK? Open the top and bottom assembly to check the connector harness Open the top and bottom assembly to check the connector to the main board yes yes no no yes Refer to the symptom NO POWER, NO GREEN LED Is the connector harness broken? Replace broken harness yes Remove the L
19、CD cover and plate of the LCD unit to check the connector of the FL harness Is the connector OK? no Repair connector Replace FL inverter or LCD no yes Is the connector broken? Replace LCD harness or main board yes Remove the LCD cover and plate of the LCD unit to check the connection of the harness
20、to the LCD unit no Is the connection OK? Connect the LCD harness to the LCD unit no Replace LCD unit or main board yes Replace LCD unit or main board SYMPTOM: NO IMAGE OR SOUND COMES OUT FROM THE EXTERNAL INPUT start Replace the main board or the connector 5.0 TROUBLESHOOTING & SERVICE TIPS SYMPTOM:
21、 THE DVD DRIVE DOES NOT WORK start Check the optical pick up lens? yes Pick up lens does not light up at all Press the DISC cover switch at the center of the DVD player and turn on the power. Then check whether or not the optical pick- up lens of the DVD drive lights. CAUTION: Visible laser radiatio
22、n when open and interlock defeated. Do not stare into Laser beam. Replace DVD drive Pick up lens light up dim Check the connectors of the DVD drive and main board? OK Secure the connection of the DVD drive and main board Not OK Pick up lens light up OK Insert a DVD disc and turn on the power What is
23、 the reaction of the DVD drive? The DVD drive works but the initializing operation of the optical pick-up lens does not start (the optical pick-up lens operates twice), or abnormal noise sound Replace DVD drive or main board DVD drive does not work The operation of the DVD player stops at initializi
24、ng display. Is there any message shown on display oading?displayed Nothing on display Check the DVD disc for fingerprints, dirt, HECK DISK?displayed Is the DVD disc OK? DVD disc OKDVD disc dirty No defect, return set to customer Does the image output stop during the operation? yes no 5.0 TROUBLESHOO
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Philips-PET-825-Service-Manual1 电路图 维修手册 Philips PET 825 Service Manual 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


