Sony-STEX77-tun-sm 电路图 维修手册.pdf
《Sony-STEX77-tun-sm 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Sony-STEX77-tun-sm 电路图 维修手册.pdf(26页珍藏版)》请在收音机爱好者资料库上搜索。
1、MICROFILM ST-EX77 AEP Model UK Model E Model SERVICE MANUAL This set is the tuner section in MHC-EX66,DHC-EX77MD/MD77. FM STEREO/FM-AM TIMER TUNER SPECIFICATIONS AEP, UK models: Hong Kong, Singapore models: 90 RadioFans.CN 收音机爱 好者资料库 2 TABLE OF CONTENTS Servicing Notes . 2 1.GENERAL Listening to the
2、 Radio .3 Labeling the Preset Stations .4 Using the Radio Data System (RDS) .5 2.DISASSEMBLY.7 3.ELECTRICAL ADJUSTMENTS.8 4.DIAGRAMS 4-1.IC Pin Function Description.9 4-2.Printed Wiring Boards . 11 4-3.Schematic Diagram . 15 5.EXPLODED VIEWS. 22 6.ELECTRICAL PARTS LIST. 24 SAFETY-RELATED COMPONENT W
3、ARNING! COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY. MODEL IDENTIFICATION Back
4、 Panel How to operate with a single unit. Normally, this set is not operated with its own. The exclusive jig (J-2501-078-A) and service box (PFJ-1) are nec- essary to operate the set with a single unit. Turn the power set of the service box ON. Then press the ENTER/NEXT button and SLEEP button at th
5、e same time to turn the power on. Connection: SERVICING NOTES KEY/FL tube/LED check mode. To enter KEY/FL tube/LED check mode, press the ENTER/NEXT and REC buttons at the same time. Under mode, every time when press any key or turn MULTI CONTROLLER knob, change to next situation. 1 All LED indicator
6、s light on 2 All FL tube indicators light on 3 A part of FL tube light on mode 1. (Indicated ST-SEG) 4 A part of FL tube light on mode 2. (Indicated RDS-SEG) 5 KEY check mode Note: 1) All LED light on mode is kept, when buttons which is pressed to enter all LED light on mode, release same time. When
7、 release them separate timing, it is moved to next All LED light on mode. 2) After all LED light on mode, light on point remove one by one, when any button pressed or MULTI CONTROLLER knob turned. 3) Under KEY check mode, every time buttons pressed numeri- cal value of “KEY” in FL tube increase. And
8、 that time, numerical value of “ECDR” increase when MULTI CONTROLLER button turn to + direction, and it decrease turn to direction. When you want to finish this mode, unplug the power of amplifier or turn off PFJ-1 of POWER switch. 4-985-904-1 : AEP, UK model 4-985-904-2 : Hong Kong, Singapore model
9、 POWER SW FH-E939, 838,937 CDP/TCCN904 17P CN902 7P CN101 7P JIG (J-2501-078-A) SERVICE BOX (PFJ-1) SET SYSTEM CONTROL CORD WITH CONNECTOR 7P (attached to set) CORD WITH CONNECTOR 17P (attached to PFJ-1) RadioFans.CN 收音机爱 好者资料库 3 This section is extracted from instruction manual. SECTION 1 GENERAL A
10、EP, UK models AEP, UK models: Hong Kong, Singapore models Hong Kong, Singapore models: Hong Kong, Singapore models: AEP, UK models: For AEP, UK models: For Hong Kong, Singapore models: RadioFans.CN 收音机爱 好者资料库 4 For Hong Kong, Singapore models: Hong Kong, Singapore models: AEP, UK models: For AEP, UK
11、 models: 5 (AEP, UK models only) 6 Precautions in Repairing If the front unit fails, it is difficult to repair the inner circuits, so replace the entire front end unit. The FM TUNED level must be adjusted after the AM TUNED level adjustment has completed. AM SECTION AM Tuning Level Adjustment Settin
12、g : BAND switch : MW(AM) SECTION 3 ELECTRICAL ADJUSTMENTS AM RF signal generator 30 % amplitude modulation by 400 Hz signal Carrier frequency : 999 kHz (at 9 k step) 1,000 kHz (at 10 k step) Output level : 25 dB loop antenna set loop antenna supplied accessories 60 cm AM antenna terminal field stren
13、gth dB(V/m)= RF SSG output level dB (V/m)26 dB Procedure: 1.Set loop antenna A so that the loop antenna B input level be- comes 55 dB/m. 2.Tune the set to 999 kHz or 1,000 kHz. 3.Adjust RV1 so that the TUNED indicator goes on. Adjustment Location : MAIN board. FM SECTION FM Tuning Level Adjustment S
14、etting : BAND switch : FM Adjustment Location : MAIN BOARD Component Side CN101TM1 RV2 FM Tuning Level Adjustment RV1 AM Tuning Level Adjustment FE2 IC1 CN102 SECTION 2 DISASSEMBLY Procedure: 1.Tune the set to 98 MHz. 3.Adjust RV2 so that the TUNED indicator goes on. Adjustment Location : MAIN board
15、. 7 8 FM RF Stereo signal generator Carrier frequency : 98 MHz Moduration : AUDIO 1kHz,75 kHz deviation (100%) Output level : 26 dB (17.8 V) set FM antenna terminal (75 coaxial) Note: Follow the disassembly procedure in the numerical order given. 1 two screws (case 3 TP2) 1 two screws (case 3 TP2) 4
16、 three screws (BVTP3 10) 8 main board 3 flat wire (19 core) (CN102) 7 two claws 2 case 6 claw 5 two screws (BVTP3 8) SECTION 4 DIAGRAMS 4-1. IC PIN FUNCTION DESCRIPTION MAIN BOARD IC201 PD78013FGC-544-AB8 (SYSTEM CONTROL) 41X2O System main clock. (10 MHz) 42X1I 43GNDGround 44XT2O System sub clock. (
17、32.768 kHz) 45XT1I 46GNDGround 47KEY IN K1I 48KEY IN K2IKey input. (analog) 49KEY INI 50GND 51GND 52GNDGround 53GND 54GND 55AVDDAnalog power supply +5V. 56AVREFIAnalog system reference voltage input. 57GNDGround 58SDATAOFlourescent indicator tube data output. (IC601) 59SCKOFlourescent indicator tube
18、 clock output. (IC601) 60CSOFlourescent indicator tube chip select signal output. (IC601) 61RESETOFlourescent indicator tube reset signal output. (IC601) 62ERRORSI 63CORRECTIONONot used. (open) 64RECEIVEDO Pin No.Pin NameI/OFunction 1DESTINATIONI 2DESTINATIONI Destination selection input. 3DESTINATI
19、ONI 4DESTINATIONI 5IF +50I Not used. (Ground) 6IF 50O 7BACK UPIBack up mode input. 8NCNot used. (open) 9VssGround 10POWEROPower ON/OFF switch control. 11MUTEOMute output. 12ANALOG-BUS 13NC 14NC Not used. (open) 15AM MONO 16AM/FM 17IFNG 18STEREOIStereo signal input. 19SIGNALITuned signal input. 20DAT
20、A INIData input. (IC51) 21DATA OUTOData output. (IC51) 22CLOCKOClock output. (IC51) 23CEOChip enable output. (IC51) 24VssGround 25NC Not used. (open) 26NC 27ONCEOLED drive output (Not used) 28DAILYO 29RECO 30SLEEPOLED drive output. 31ENCODERO 32NEXTO 33ENCODER IN BIEncoder input. (B) 34AU BUS OUTOAu
21、dio bus output. 35RESETISystem reset input. 36AU BUS INIAudio bus input. 37ENCODER IN AIEncoder input. (A) 38RDS-CLOCKIRDS clock input. 39RDS-DATAIRDS data input. 40VDDPower supply 5V. Pin No.Pin NameI/OFunction 9 10 11 12 13 14 15 16 17 18 19 20 Waveforms 1 IC51 1 2 IC201 $ 3.1Vp-p 10 MHz 2.4 Vp-p
22、4.5 MHz 3 IC201 $ 1.8 Vp-p 32.768 kHz 4 IC302 ! 2.8 Vp-p 4.332 MHz IC Block Diagrams IC1LA1835 ALC BUFF AM OSC AM MIX AM RF. AMP AGC S METER LEVEL DET FM IF AM DET S-CURVE AM/FM IF BUFF REG TUNING DRIVE COMP GND AM/FM SW VCC PHASE DET PILOT DET VCO FF STEREO DRIVE TRIG STEREO SW MUTE FFFF FM IF FM D
23、ET DECODER ANTI BIRDIE 12345678910 2019181716 1514131211 21222324252627282930 FM-SD AM-OSC FM-AFC AM-RF-IN AGC AM. CUT AM/FM VCO MPX-IN OUT R OUT L AMP-IN R AMP-IN L R LVCO-STOP ST-LED AM/FM AM. SD AM. SD IF-BUFF VCC DET FM-IN AM-MIX IF REG AM-IF GND TU-LED FM AM 21 PHASE DETECTOR CHARGE PUMP SWALLO
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Sony-STEX77-tun-sm 电路图 维修手册 Sony STEX77 tun sm 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


