Sony-TAF448EB-int-sm 电路图 维修手册.pdf
《Sony-TAF448EB-int-sm 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Sony-TAF448EB-int-sm 电路图 维修手册.pdf(19页珍藏版)》请在收音机爱好者资料库上搜索。
1、MICROFILM TA-F448EB INTEGRATED STEREO AMPLIFIER +11 3 SERVICE MANUALAEP Model UK Model SPECIFICATIONS Amplifier section DIN power output 85 W + 85 W (4 ohms at 1 kHz) 55 W + 55 W (8 ohms at 1 kHz) Total harmonic distortion Less than 0.008% (at 10 W output) Frequency response PHONO (20 Hz 20 kHz): RI
2、AA equalization curve 0.5 dB TUNER, CD, AUX, TAPE1/DAT, TAPE2/MD: 7 Hz 100 kHz dB S/N (network A) PHONO: 94 dB TUNER, CD, AUX, TAPE1/DAT, TAPE2/MD: 105 dB Output voltage/impedance RECOUT: 150 mV, 1 kilohm PHONES: 10 mW (at 8 ohms) Speakers impedance 4 16 ohms, 8 16 ohms (SPEAKERS A + B) Damping fact
3、or 100 (8 ohms, 1 kHz) General System Power amplifier: Pure-complementary SEPP OCL power amplifier with all stages directly coupled Preamplifier: Low-noise, equalizer amplifier Power requirements 230 V AC, 50/60 Hz Power consumption 180 W Dimensions (approx.) (w/h/d) 430 135 365 mm incl. projecting
4、parts and controls Mass (approx.) 6.8 kg Design and specifications are subject to change without notice. RadioFans.CN 收音机爱 好者资料库 2 SAFETY-RELATED COMPONENT WARNING! COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATI
5、ON. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB- LISHED BY SONY. TABLE OF CONTENTS 1.GENERAL.3 2.DISASSEMBLY. 5 3.ELECTRICAL ADJUSTMENTS. 7 4.DIAGRAMS. 8 4-1.Printed Wiring Boards . 10 4-2.Schematic Diagram . 15 5.EXPLODED VIEWS. 1
6、9 6.ELECTRICAL PARTS LIST. 22 RadioFans.CN 收音机爱 好者资料库 3 SECTION 1 GENERAL This section is extracted from instruction manual. RadioFans.CN 收音机爱 好者资料库 4 5 Note: Follow the disassembly procedure in the numerical order given. CASE ASSY SECTION 2 DISASSEMBLY FRONT PANEL SECTION 1 two screws (case 3 TP2)
7、2three screws (case 3 TP2) 3two screws (case 3 TP2) 3two screws (case 3 TP2) 4case assy 1connector (CN201) 2connector (CN701) 3connector (CN405) 4connector (CN809) 5connector (CN104) 6 five screws (3 8) 7 two screws (3 8) 8 screw (BVTP2.6 8) 8 screw (BVTP3 8) 9 front panel section 6 INPUT BAORD, MAI
8、N (B) BAORD 1two connectors (CN301, 302) 2connector (CN104) 3three screws (3 8) 4Remove the INPUT board to direction of the arrow A. 5two connectors (CN16, 103) !four screws (H) 6two connectors (CN401, 402) !screw (3 8) 8connector (CN405) 7two connectors (CN403A, 404A) 9Break the soldering of three
9、power transformer leads. !three screws (3 8) !heat sink !two screws (transistor) !MAIN (B) board A !heat sink !two screws (transistor) !four screws (H) MAIN (A) BOARD 1connector (CN201) 2five screws 3MAIN (A) board 7 + BIAS ADJUSTMENT Adjustment Procedure: 1.Rotate fully the bias adjusting semi-fixe
10、d resistors (RV301 (L- CH), RV351 (R-CH) to the minimum position (counterclock- wise). 2.Connect a digital voltmeter to the CN406 (L-CH) and CN407 (R-CH). 3.Set the slidack to 0 V AC, and press the POWER button (ON) on the set. 4.Raise gradually the slidack voltage up to the rated voltage (230 V AC)
11、. 5.At this time, confirm that the speaker relay is turned on (it will click). 6.Adjust the RV301 (L-CH) and RV351 (R-CH) so that a reading of digital voltmeter is from 10 mV to 20 mV. 7.Return the slidack to 0 V AC, and press the POWER button (OFF) on the set. pin 1pin 3 CN406 (L-CH)+ CN407 (R-CH)+
12、 Connection and Adjustment Location: MAIN (A) BOARD Component side MAIN (B) BOARD Component side digital voltmeter C372 C322 RV351 (R-CH) RV301 (L-CH) BIAS Adjustment C459C409 CN407 31 SECTION 3 ELECTRICAL ADJUSTMENT CN406 13 8 IC Block Diagram IC401PC1237HA SECTION 4 DIAGRAMS 12345678 OVER LOAD DET
13、 F/F OFFSET DET LATCH/ AUTORESET VCC ON MUTE AC OFF DET VCC 9 Circuit Boards Location MAIN (B) board SP-TM board INPUT board MAIN (A) board VOL boardLED-F board SW-F board SP-SW board HP board LED-P board 19 SECTION 5 EXPLODED VIEWS Items marked “*” are not stocked since they are seldom required for
14、 routine service. Some delay should be anticipated when ordering these items. The mechanical parts with no reference num- ber in the exploded views are not supplied. Accessories and packing materials are given in the last of the electrical parts list. NOTE: -XX and -X mean standardized parts, so the
15、y may have some difference from the original one. Color Indication of Appearance Parts Example: KNOB, BALANCE (WHITE) . . . (RED) Parts ColorCabinets Color Ref. No.Part No.DescriptionRemarkRef. No.Part No.DescriptionRemark 14-967-961-01 SCREW (3X8) 2X-4947-025-1 FOOT ASSY 37-685-872-09 SCREW +BVTT 3
16、X8 (S) 44-951-620-01 SCREW (2.6X8), +BVTP 53-363-099-61 SCREW (CASE 3 TP2) 6X-4948-403-1 CASE ASSY 1 1 1 1 2 2 1 5 5 5 5 6 3 1 1 4 not supplied not supplied (1) CASE SECTION The components identified by mark ! or dotted line with mark ! are critical for safety. Replace only with part number specifie
17、d. 20 60 62 61 59 60 57 56 69 55 54 58 56 53 52 51 6368 67 63 66 65 64 63 63 supplied with J701 supplied with S602 supplied with RV201 not supplied not supplied supplied with S601 not supplied S1 Ref. No.Part No.DescriptionRemarkRef. No.Part No.DescriptionRemark 614-980-199-01 BUTTON (POWER) * 621-6
18、62-195-11 LED-P BOARD 634-951-620-01 SCREW (2.6X8), +BVTP * 641-662-197-11 HP BOARD * 651-662-196-11 SP-SW BOARD * 661-662-193-11 SW-F BOARD * 671-662-194-11 LED-F BOARD * 681-662-192-11 VOL BOARD 693-703-466-00 SPRING (6600) !S11-554-920-11 SWITCH, PUSH (AC POWER)(1 KEY)(POWER) 514-980-767-12 PANEL
19、, FRONT 524-965-651-01 EMBLEM (MOS) 534-979-587-01 EMBLEM (NO.5), SONY 54X-4946-920-1 KNOB (VOL) ASSY 554-980-771-01 KNOB (DIA. 47) 564-980-775-01 LENS, LED 574-980-774-11 KNOB (F11) 584-980-774-01 KNOB (F11) 59X-4946-944-1 PANEL ASSY, BASE 607-685-872-09 SCREW +BVTT 3X8 (S) The components identifie
20、d by mark ! or dotted line with mark ! are criti- cal for safety. Replace only with part number speci- fied. (2) FRONT PANEL SECTION 21 Ref. No.Part No.DescriptionRemarkRef. No.Part No.DescriptionRemark 1014-967-961-01 SCREW (3X8) 1024-967-960-01 SCREW (4X8) * 1031-665-580-11 SP-TM BOARD 1044-981-01
21、6-11 SCREW (H) 1053-905-609-11 SCREW (TRANSISTOR) * 106A-4398-160-A MAIN (B) BOARD, COMPLETE * 1073-703-244-00 BUSHING (2104), CORD !1081-770-019-11 ADAPTOR, CONVERSION PLUG 3P (UK) 1093-704-515-41 SCREW (BV/RING) 1101-506-113-00 SHORT PLUG 1114-947-010-01 SCREW, FEEDER FIXED * 1124-982-978-21 PANEL
22、, BACK (AEP) * 1124-982-978-31 PANEL, BACK (UK) * 1131-662-191-11 INPUT BOARD * 114A-4398-159-A MAIN (A) BOARD, COMPLETE !CNP801 1-777-185-11 CORD, POWER !T11-431-295-11 TRANSFORMER, POWER 103 104 101 105 104 101 106 101 101 107 108 101 110 111 101 112 101 114 101 101 113 102 102 101 not supplied no
23、t supplied not supplied not supplied not supplied not supplied not supplied T1 CNP801 UK 109 The components identified by mark ! or dotted line with mark ! are criti- cal for safety. Replace only with part number speci- fied. (3) CHASSIS SECTION 22 NOTE: Due to standardization, replacements in the p
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Sony-TAF448EB-int-sm 电路图 维修手册 Sony TAF448EB int sm 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


