Onkyo-DTR8_3-avr-sm 电路图 维修手册.pdf
《Onkyo-DTR8_3-avr-sm 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Onkyo-DTR8_3-avr-sm 电路图 维修手册.pdf(86页珍藏版)》请在收音机爱好者资料库上搜索。
1、DTR-8.3 SERVICE MANUALSERVICE MANUAL AV RECEIVER Black model MODEL DTR-8.3 120V AC, 60Hz 230240V AC, 50Hz BUDD BUPA Ref. No. 3759 Dec., 2002 + CH VOL MUTE CONT + LIGHT SAFETY-RELATED COMPONENT WARNING! COMPONENTS IDENTIFIED BY MARK ON THE SCHEMATIC DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR RISK
2、 OF FIRE AND ELECTRIC SHOCK. REPLACE THESE COMPONENTS WITH ONKYO PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL. MAKE LEAKAGE-CURRENT OR RESISTANCE MEASUREMENTS TO DETERMINE THAT EXPOSED PARTS ARE ACCEPTABLY INSULATED FROM THE SUPPLY CIRCUIT BEFORE RETURNING THE APPLIANCE TO THE CUSTOMER. R
3、adioFans.CN 收音机爱 好者资料库 DTR-8.3 SPECIFICATIONS AMPLIFIER SECTION Continuous average power output (FTC) All channels:110 W per channel min. RMS at 8 , 2 channels driven from 20 Hz to 20 kHz with no more than 0.08% total harmonic distortion. 145 W min. RMS at 6 , 2 channels driven from 1 kHz with no mo
4、re than 0.1% total harmonic distortion. Continuous power output (DIN)150 W at 6 Maximum power output (EIAJ)180 W at 6 Dynamic power output (stereo)2 280 W at 3 2 220 W at 4 2 140 W at 8 Total Harmonic Distortion:0.08% at rated power 0.08% at 1 W output IM Distortion:0.08% at rated power 0.08% at 1 W
5、 output Damping factor:60 at 8 Input sensitivity and impedance PHONO:2.5 mV, 50 k LINE (CD, TAPE, DVD, VIDEO 1-5):200 mV, 50 k MULTICHANNEL INPUT (FRONT L/C/R, SURROUND L/R, SURROUND BACK L/R): 200 mV, 50 k (SUBWOOFER):36 mV, 50 k COAXIAL 1, 2, 3 (DIGITAL):0.5 Vp-p, 75 DVD, VIDEO 1, 2, 3, 4, 5:1 Vp-
6、p, 75 1 Vp-p, 75 (Y) 0.28 Vp-p, 75 (C) COMPONENT VIDEO 1, 2:1 Vp-p, 75 (Y) 0.7 Vp-p, 75 (PB, PR) Output level and impedance Rec out (TAPE, VIDEO 1, 2): 200 mV, 470 Pre out:1 V, 470 ZONE 2 OUT:100 mV, 470 VIDEO (VIDEO 1, 2, MONITOR OUT, ZONE 2 OUT):1 Vp-p, 75 S-VIDEO (VIDEO 1, 2, MONITOR OUT):1 Vp-p,
7、 75 (Y) 0.28 p-p, 75 (C) COMPONENT VIDEO OUT:1 Vp-p, 75 (Y) 0.7 Vp-p, 75 (PB, PR) Phono overload:120 mV RMS at 1 kHz, 0.5% T.H.D. Frequency response:10 Hz to 100 kHz : +1/3 dB (CD in Direct mode) RIAA deviation:20 Hz to 20 kHz : 0.8 dB Tone Control Bass:10 dB at 50 Hz Treble:10 dB at 20,000 Hz Signa
8、l-to-noise ratio (direct) Phono:80 dB (IHF A, 5 mV input) CD/Tape:110 dB (IHF A, 0.5 V input) TUNER SECTION FM Tuning range USA & Canadian models:87.50108.00 MHz (100-kHz steps) Other models:87.50108.00 MHz (50-kHz steps) Usable sensitivity Mono:11.2 dBf, 1.0 V (75 IHF) 0.9 V (75 DIN) Stereo:17.2 dB
9、f, 2.0 V (75 IHF) 23 V (75 DIN) 50 dB quieting sensitivity Mono:17.2 dBf, 2.0 V (75 ) Stereo:37.2 dBf, 20 V (75 ) Capture ratio:2.0 dB IF rejection ratio:90 dB Signal-to-noise ratio Mono:76 dB Stereo:70 dB Alternate channel attenuation:55 dB Selectivity:50 dB (DIN) AM suppression ratio:50 dB Total h
10、armonic distortion Mono:0.2% Stereo:0.3% Frequency response:30 Hz15 kHz, 1.0 dB Stereo separation:45 dB at 1 kHz 30 dB at 100 Hz 10 kHz AM Tuning range USA & Canadian models:530 to 1,710kHz (10kHz steps) 522 to 1,611 kHz (9-kHz steps)Australian models: Usable sensitivity:30 V Image rejection ratio:4
11、0 dB IF rejection ratio:40 dB Signal-to-noise ratio:40 dB Total harmonic distortion:0.7% GENERAL Power supply USA & Canadian models:AC 120 V, 60 Hz Australian models:AC 230 240 V, 50 Hz Power consumption USA & Canadian models:8.4 A Australian models:670 W Dimensions (W H D):435 175 460 mm 17-1/8 6-7
12、/8 18-1/8 Weight 18.2 kg (40.1 lbs) Specifications and features are subject to change without notice. REMOTE CONTROLLER Model: USA & Canadian models:USR-5 Australian models: USR-5RF Hardware:High-resolution (320 240) liquid crystal display (LCD) with contrast control Large touchscreen Seven programm
13、able direct-access buttons Backlighting for LCD and direct-access buttons Infrared sending and learning eyes 3-wire (RS232) serial port connector Software:Dynamic, animated interface Editable macros (up to 255 commands per macro) Total number of devices and macros limited only by memory Database wit
14、h RC codes to operate different brands Infrared (IR):Operating distance of 33 feet(10 meters) Learning frequency up to 56 kHz Learning distance 2 inch (5 cm) up to 1 foot (30 cm) Memory:2 MB non-volatile flash memory (retains commands when batteries are not present) 512 K SRAM Batteries:4 AA 1.5 V b
15、atteries, or one 4.8V rechargeable battery pack (USA and Canadian model) Battery life:Approximately 6 months with typical use Power management:Power on by tapping the touchscreen, power off automatically management Dimensions:6.0 inch 3.7 inch 1.7 inch (153.6 94.1 43.7 mm) Operating temperature:32 F
16、 to 122 F (0 C to 50 C) (USA & Canadian models only) Radio frequency (RF):Operating distance of approximately 66 feet (20 meters) depending on the surrounding conditions Band: 418 MHz Bandwidth: +/100 kHz 16 Extender IDs and 4 Channels Accessories (Not included):Remote controller recharge package BC
17、C-5 RF Receiver RFR-5 Database information: Designed by UEI Technology Licensed under U.S. Patent 5,689,353 Portions UEI 1999 RadioFans.CN 收音机爱 好者资料库 DTR-8.3 SERVICE PROCEDURES 1. Replacing the fuses This symbol located near the fuses indicates that the fuse used is fast operating type. For continue
18、d protection against fire hazard, replace with same type fuse. For fuse rating refer to the marking adjacent to the symbol. Ce symbole indique que le fusible utlise est a rapide. Pour une protection permanente, nuntiliser que fusibles de meme type. Ce darnier est la qu le present symbol est appse. C
19、IRCUIT NO. PART NO. DESCRIPTION 2. To initialize the unit This device employs a microprocessor to perform various functions and operations. If interference generated by an external power supply, radio wave, or other electrical source results in accident which causes the specified operations and func
20、tions to operate abnormally. To perform a result, please follow the procedure below. 1.Press the STANDBY ON button to turn on the unit. 2.Press and hold down the VIDEO 1 button, then press the STANDBY/ON button. 3.After CLEAR is displayed, the preset memory and each mode stored in the memory, such a
21、s surround, are initialized and will return to the factory setting. 4.Unplug the power supply cord. 3. Safety-check out (Only U.S.A. model) After correcting the original service problem, perform the following safety check before releasing the set to the customer. Connect the insulating-resistance te
22、ster between the plug of power supply cord and screw on the back panel. Specifications: 3.3Mohm+/-10% at 500V. 4. Memory Preservation This unit does not require memory preservation batteries. A built-in memory power back-up system preserves the contents of the memory during power failures and even w
23、hen the unit is unplugged. The unit must be plugged in order to charge the back-up system. The memory preservation period after the unit has been unplugged varies depending on climate and placement of the unit. On the average, memory contents are protected over a period of a few weeks after the last
24、 time the unit has been unplugged. This period is shorter when the unit is exposed to a highly humid climate. Note: : 120V model only : Australian model model 5. To confirm the version of microprocessor 1.Press the STANDBY ON button to turn on the unit. 2.Press and hold down the DISPLAY button after
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Onkyo-DTR8_3-avr-sm 电路图 维修手册 Onkyo DTR8_3 avr sm 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf
Kaprys维修电路原理图.gif
Jotha-Liliput维修电路原理图.jpg


