Onkyo-CDC3_4-cd-sb012 电路图 维修手册.pdf

《Onkyo-CDC3_4-cd-sb012 电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《Onkyo-CDC3_4-cd-sb012 电路图 维修手册.pdf（2页珍藏版）》请在收音机爱好者资料库上搜索。

1、_ CONFIDENTIALITY NOTICE: This document and the information it contains is intended for the exclusive use of Authorized ONKYO Service Centers and their employees. This document may contain information that is privileged, confidential and exempt from disclosure under applicable law and terms of the O

2、NKYO Service Agreement. Any dissemination, distribution or copying of this document and the information it contains is strictly prohibited. CONFIDENTIAL Service Bulletin 18 Park Way, Upper Saddle River, NJ 07458 No. 012 Date: January 5, 2006 _ Model: CDC-3/3.1/3.4, DX-C34/C370/C380/C390 Subject: Ali

3、gnment Tips before Replacing the KSS-213C Optical Pickup. Symptom: Models using an Analog Servo do not automatically adjust IP (Laser Current) and sometimes will leave the RF Level very low. Solution: Measure IP of Pickup at both ends of TR Emitter Resistor (20-30 ohm) connected to LD terminal of Pi

4、ckup, and then compare the measured value with the standard value (printed on label). 1.) IP (laser current) Check If the obtained IP value is lower than the standard value perform the following: Adjust the RF Level to 1Vp-p using the trimmer potentiometer and make sure that the IP is in the specifi

5、ed range. RadioFans.CN 收音机爱 好者资料库 Apply 1-hour aging to the unit and make sure again that the IP is still in the specified range. Note: IP increases as the temperature goes up because the resistance goes down. After aging, the increase in value should be within 5% of the Standard Value. Example: bef

6、ore aging value ?37-38mA., suitable value after aging ? 40mA. If the IP rapidly increases, the Photo Diode has a problem. In this case, the Optical Pickup needs replacing. 2.) Visual Check Check to see the Lens has not dropped. If so, Focus Zero Cross is not correctly positioned and, in most cases,

7、the outermost track (TR 15) of the Test Disc cannot be played. Replace the Pickup with a new one. 3.) Test Disc Check: ABEX TCD-731RA Check to see if the outermost track (TR 15) can be played. Check whether there is only a small difference in Jitter values between the innermost (TR 1) and the outerm

8、ost track (TR 15). Reference Jitter Value: Standard jitter value varies depending on the measuring instrument. It is preferable to set the value in advance by checking a known good unit. Note: If the ABEX Test Disc has a lot of scratches, fingerprints, dirt, etc., the Jitter value tends to be slight

9、ly higher. If either of the above two checks (Visual and Test Disc) is not good, replace the Pickup with a new one. Serial Number Range: All _ CONFIDENTIALITY NOTICE: This document and the information it contains is intended for the exclusive use of Authorized ONKYO Service Centers and their employe

10、es. This document may contain information that is privileged, confidential and exempt from disclosure under applicable law and terms of the ONKYO Service Agreement. Any dissemination, distribution or copying of this document and the information it contains is strictly prohibited. RadioFans.CN 收音机爱 好者资料库