Onkyo-TXNR900-avr-sm 电路图 维修手册.pdf
《Onkyo-TXNR900-avr-sm 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Onkyo-TXNR900-avr-sm 电路图 维修手册.pdf(82页珍藏版)》请在收音机爱好者资料库上搜索。
1、TX-NR900/E SERVICE MANUALSERVICE MANUAL Black, Silver and Golden models Ref. No. 3755 112002 AV RECEIVER MODEL TX-NR900/E BUDD,BUDC120V AC, 60Hz BUPP,BUPA,SUPP,GUPA230240V AC, 50Hz BUWT,GUWT,GUWR120/220230V AC, 50/60Hz GUGT220V AC, 50Hz PUSH TO OPEN TX -NR900E STANDBY/ON STANDBY DVD ZONE 2()GRN REC(
2、)RED AUDIO SELECTOR PURE AUDIOUPSAMPLING OFFON POWER MASTER VOLUME TUNERPHONONET AUDIOC DTAPEVIDEO 3VIDEO 5VIDEO 4VIDEO 2VIDEO 1 VCR 2VCR 1 DISPL AY SAFETY-RELATED COMPONENT WARNING! COMPONENTS IDENTIFIED BY MARK ON THE SCHEMATIC DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR RISK OF FIRE AND ELECTR
3、IC SHOCK. REPLACE THESE COMPONENTS WITH ONKYO PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL. MAKE LEAKAGE-CURRENT OR RESISTANCE MEASUREMENTS TO DETERMINE THAT EXPOSED PARTS ARE ACCEPTABLY INSULATED FROM THE SUPPLY CIRCUIT BEFORE RETURNING THE APPLIANCE TO THE CUSTOMER. RadioFans.CN 收音机爱 好者
4、资料库 TX-NR900/E SPECIFICATIONS AMPLIFIER SECTION Continuous average power output (FTC) All channels:110 W per channel min. RMS at 8 , 2 channels driven from 20 Hz to 20 kHz with no more than 0.08% total harmonic distortion. 145 W min. RMS at 6 , 2 channels driven from 1 kHz with no more than 0.1% tot
5、al harmonic distortion. Continuous power output (DIN)150 W at 6 Maximum power output (EIAJ)180 W at 6 Dynamic power output (stereo)2 280 W at 3 2 220 W at 4 2 140 W at 8 Total Harmonic Distortion:0.08% at rated power 0.08% at 1 W output IM Distortion:0.08% at rated power 0.08% at 1 W output Damping
6、factor:60 at 8 Input sensitivity and impedance PHONO:2.5 mV, 50 k LINE (CD, TAPE, DVD, VIDEO 1-5):200 mV, 50 k MULTICHANNEL INPUT (FRONT L/C/R, SURROUND L/R, SURROUND BACK L/R): 200 mV, 50 k (SUBWOOFER):36 mV, 50 k COAXIAL 1, 2, 3 (DIGITAL):0.5 Vp-p, 75 DVD, VIDEO 1, 2, 3, 4, 5:1 Vp-p, 75 1 Vp-p, 75
7、 (Y) 0.28 Vp-p, 75 (C) COMPONENT VIDEO 1, 2:1 Vp-p, 75 (Y) 0.7 Vp-p, 75 (PB, PR) Output level and impedance Rec out (TAPE, VIDEO 1, 2): 200 mV, 470 Pre out:1 V, 470 ZONE 2 OUT:100 mV, 470 VIDEO (VIDEO 1, 2, MONITOR OUT, ZONE 2 OUT):1 Vp-p, 75 S-VIDEO (VIDEO 1, 2, MONITOR OUT):1 Vp-p, 75 (Y) 0.28 p-p
8、, 75 (C) COMPONENT VIDEO OUT:1 Vp-p, 75 (Y) 0.7 Vp-p, 75 (PB, PR) Phono overload:120 mV RMS at 1 kHz, 0.5% T.H.D. Frequency response:10 Hz to 100 kHz : +1/3 dB (CD in Direct mode) RIAA deviation:20 Hz to 20 kHz : 0.8 dB Tone Control Bass:10 dB at 50 Hz Treble:10 dB at 20,000 Hz Signal-to-noise ratio
9、 (direct) Phono:80 dB (IHF A, 5 mV input) CD/Tape:110 dB (IHF A, 0.5 V input) TUNER SECTION FM Tuning range USA & Canadian models:87.50108.00 MHz (100-kHz steps) Other models:87.50108.00 MHz (50-kHz steps) Usable sensitivity Mono:11.2 dBf, 1.0 V (75 IHF) 0.9 V (75 DIN) Stereo:17.2 dBf, 2.0 V (75 IHF
10、) 23 V (75 DIN) 50 dB quieting sensitivity Mono:17.2 dBf, 2.0 V (75 ) Stereo:37.2 dBf, 20 V (75 ) Capture ratio:2.0 dB Image rejection ratio:85 dB IF rejection ratio:90 dB Signal-to-noise ratio Mono:76 dB Stereo:70 dB Alternate channel attenuation:55 dB Selectivity:50 dB (DIN) AM suppression ratio:5
11、0 dB Total harmonic distortion Mono:0.2% Stereo:0.3% Frequency response:30 Hz15 kHz, 1.0 dB Stereo separation:45 dB at 1 kHz 30 dB at 100 Hz 10 kHz AM Tuning range USA & Canadian models:530 to 1,710kHz (10kHz steps) Other than world wide models:522 to 1,611 kHz (9-kHz steps) Worldwide models:522 to
12、1,611 kHz (9-kHz steps) or 530 to 1,710 kHz (10-kHz steps) Usable sensitivity:30 V Image rejection ratio:40 dB IF rejection ratio:40 dB Signal-to-noise ratio:40 dB Total harmonic distortion:0.7% GENERAL Power supply USA & Canadian models:AC 120 V, 60 Hz European & Australian models:AC 230 240 V, 50
13、Hz Some Asian models:AC 220230 V, 50/60 Hz Worldwide models:AC 220230 and 120 V switchable, 50/60 Hz Power consumption USA & Canadian models:8.4 A Other models:670 W Dimensions (W H D):435 175 459 mm 17-1/8 6-7/8 18-1/16 Weight USA & Canadian models:17.5 kg (38.6 lbs) Other models:18.2 kg (40.1 lbs)
14、 Specifications and features are subject to change without notice. RadioFans.CN 收音机爱 好者资料库 TX-NR900/E SERVICE PROCEDURES 1. Replacing the fuses This symbol located near the fuses indicates that the fuse used is fast operating type. For continued protection against fire hazard, replace with same type
15、 fuse. For fuse rating refer to the marking adjacent to the symbol. Ce symbole indique que le fusible utlise est a rapide. Pour une protection permanente, nuntiliser que fusibles de meme type. Ce darnier est la qu le present symbol est appse. CIRCUIT NO. PART NO. DESCRIPTION 2. To initialize the uni
16、t This device employs a microprocessor to perform various functions and operations. If interference generated by an external power supply, radio wave, or other electrical source results in accident which causes the specified operations and functions to operate abnormally. To perform a result, please
17、 follow the procedure below. 1.Press the STANDBY ON button to turn on the unit. 2.Press and hold down the VIDEO 1 button, then press the STANDBY/ON button. 3.After CLEAR is displayed, the preset memory and each mode stored in the memory, such as surround, are initialized and will return to the facto
18、ry setting. 4.Unplug the power supply cord. 3. Safety-check out (Only U.S.A. model) After correcting the original service problem, perform the following safety check before releasing the set to the customer. Connect the insulating-resistance tester between the plug of power supply cord and screw on
19、the back panel. Specifications: 3.3Mohm+/-10% at 500V. 4. Memory Preservation This unit does not require memory preservation batteries. A built-in memory power back-up system preserves the contents of the memory during power failures and even when the unit is unplugged. The unit must be plugged in o
20、rder to charge the back-up system. The memory preservation period after the unit has been unplugged varies depending on climate and placement of the unit. On the average, memory contents are protected over a period of a few weeks after the last time the unit has been unplugged. This period is shorte
21、r when the unit is exposed to a highly humid climate. Advanced Menu 0.Hardware Setup 0-4.AM Frequency Step a.Frequency Step :9 kHz 6. AM Frequency Step Sub-menu (Worldwide model only) This sub-menu only appears on the worldwide model. The setting in this sub-menu determines the increment amount or d
22、ecrement amount when adjusting the AM tuner frequency. The initial setting is 9 kHz, and this needs only to be changed if you are using the TX-NR900 in a 10-kHz region. 5.Setting the voltage selector (Worldwide models only) Worldwide models are equipped with a voltage selector so that you supplies.
23、Be can set your TX-NR900 to conform with local power sure to set this switch to match the voltage of your area before plugging in the unit. Determine the proper voltage for your area: 220-230 V or the preset voltage is not correct for your area, into the groove in the switch and slide (220-230 V), w
24、hichever is appropriate. Note: : 120V model only : Except 120V model : Worldwide model only : Chinese model only the power supply in 120 V. If insert a screwdriver the switch all the way to the top (120 V) or bottom 7. To confirm the version of microprocessor 1.Press the STANDBY ON button to turn on
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Onkyo-TXNR900-avr-sm 电路图 维修手册 Onkyo TXNR900 avr sm 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


