Onkyo-TXSR800-avr-sm 电路图 维修手册.pdf
《Onkyo-TXSR800-avr-sm 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Onkyo-TXSR800-avr-sm 电路图 维修手册.pdf(88页珍藏版)》请在收音机爱好者资料库上搜索。
1、TX-SR800 SERVICE MANUALSERVICE MANUAL Black and Golden models Ref. No. 3754 112002 STANDBY/ON STANDBY PHONES MASTER VOLUME TAPETUNERPHONOC DVIDEO 4VIDEO 5VIDEO 3VIDEO 2VIDEO 1DVD OFFZONE 2REC OUTDISPLAYDIMMER AUDIO SELECTOR ZONE 2()GRN REC()RED VCR 2VCR 1 S VIDEOAUDIOVIDEOLRDIGITAL VIDEO 5 INPUT OFF
2、ON POWER TX -SR800 PURE AUDIOUPSAMPLING CLEAR DSPA-FO RM LISTENING MODE MEMORYTHXSURROUNDDIRECT / PURE AUDIOSTEREOFM MODEMEMORY ENTER RE TURN SETUP TUNING PRESET AV RECEIVER MODEL TX-SR800 BMDD,BMDC120V AC, 60Hz BMPA,GMPA230240V AC, 50Hz BMWT,GMWT,GMWR120/220230V AC, 50/60Hz GMGT220V AC, 50Hz SAFETY
3、-RELATED COMPONENT WARNING! COMPONENTS IDENTIFIED BY MARK ON THE SCHEMATIC DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR RISK OF FIRE AND ELECTRIC SHOCK. REPLACE THESE COMPONENTS WITH ONKYO PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL. MAKE LEAKAGE-CURRENT OR RESISTANCE MEASUREMENTS TO D
4、ETERMINE THAT EXPOSED PARTS ARE ACCEPTABLY INSULATED FROM THE SUPPLY CIRCUIT BEFORE RETURNING THE APPLIANCE TO THE CUSTOMER. RadioFans.CN 收音机爱 好者资料库 TX-SR800 SPECIFICATIONS AMPLIFIER SECTION Continuous average power output (FTC) All channels:100 W per channel min. RMS at 8 Ohm , 2 channels driven fr
5、om 20 Hz to 20 kHz with no more than 0.08% total harmonic distortion. 130 W min. RMS at 6 Ohm , 2 channels driven from 1 kHz with no more than 0.1% total harmonic distortion. Continuous power output (DIN)135 W at 6 Ohm Maximum power output (EIAJ)160 W at 6 Ohm Dynamic power output (stereo)2 x 250 W
6、at 3 Ohm 2 x 210 W at 4 Ohm 2 x 130 W at 8 Ohm Total harmonic distortion:0.08% at rated power 0.08% at 1 W output IM distortion:0.08% at rated power 0.08% at 1 W output Damping factor:60 at 8 Ohm Input sensitivity and impedance PHONO:2.5 mV, 50 k ohm LINE (CD, TAPE, DVD, VIDEO 1-5):200 mV, 50 k ohm
7、MULTICHANNEL INPUT (FRONT L/C/R, SURROUND L/R, SURROUND BACK L/R): 200 mV, 50 k ohm (SUBWOOFER):36 mV, 50 k ohm COAXIAL 1, 2, 3 (DIGITAL):0.5 Vp-p, 75 Ohm DVD, VIDEO 1, 2, 3, 4, 5:1 Vp-p, 75 Ohm 1 Vp-p, 75 Ohm (Y) 0.28 Vp-p, 75 Ohm (C) COMPONENT VIDEO 1, 2:1 Vp-p, 75 Ohm (Y) 0.7 Vp-p, 75 Ohm (PB, PR
8、) Output level and impedance Rec out (TAPE, VIDEO 1, 2): 200 mV, 470 Ohm Pre out:1 V, 470 Ohm VIDEO (VIDEO 1, 2, MONITOR OUT, ZONE 2 OUT):1 Vp-p, 75 Ohm 1 Vp-p, 75 Ohm (Y) 0.28 p-p, 75 Ohm (C) COMPONENT VIDEO OUT:1 Vp-p, 75 Ohm (Y) 0.7 Vp-p, 75 Ohm (PB, PR) Phono overload:120 mV RMS at 1 kHz, 0.5% T
9、.H.D. Frequency response:10 Hz to 100 kHz : +1/3 dB (CD in Direct mode) RIAA deviation:20 Hz to 20 kHz : 0.8 dB Tone Control Bass:10 dB at 50 Hz Treble:10 dB at 20,000 Hz Signal-to-noise ratio (Direct) Phono:80 dB (IHF A, 5 mV input) Line:110 dB (IHF A, 0.5 V input) Muting:Due to setup menu TUNER SE
10、CTION FM Tuning range USA & Canadian models:87.5108.0 MHz (100-kHz steps) Other models:87.50 108.00 MHz (50-kHz steps) Usable sensitivity Mono:11.2 dBf, 1.0 V (75 Ohm IHF) 0.9 V (75 Ohm DIN) Stereo:17.2 dBf, 2.0 V (75 Ohm IHF) 23 V (75 Ohm DIN) 50 dB quieting sensitivity Mono:17.2 dBf, 2.0 V (75 Ohm
11、) Stereo:37.2 dBf, 20 V (75 Ohm) Capture ratio:2.0 dB Image rejection ratio USA & Canadian models:40 dB Other models:85 dB IF rejection ratio:90 dB Signal-to-noise ratio Mono:76 dB Stereo:70 dB Alternate channel attenuation:55 dB Selectivity:50 dB (DIN) AM suppression ratio:50 dB Total harmonic dist
12、ortion Mono:0.2% Stereo:0.3% Frequency response:30 Hz 15 kHz, 1.0 dB Stereo separation:45 dB at 1 kHz 30 dB at 100 Hz 10 kHz AM Tuning range USA & Canadian models:530 to 1,710 kHz (10-kHz steps) Some Asian and Australian models:522 to 1,611 kHz (9-kHz steps) Worldwide models:522 to 1,611 kHz (9-kHz
13、steps) 530 to 1,710 kHz (10-kHz steps) Usable sensitivity:30 V Image rejection ratio:40 dB IF rejection ratio:40 dB Signal-to-noise ratio:40 dB Total harmonic distortion:0.7% GENERAL Power supply USA & Canadian models:AC 120 V, 60 Hz Australian models:AC 230240 V, 50 Hz Some Asian models:AC 220230 V
14、, 50/60 Hz Worldwide models:AC 220230 and 120 V switchable, 50/60 Hz Power consumption USA & Canadian models:8.1 A Other models:655 W Dimensions (Wx H x D):435 x 175 x 459 mm 17-1/8 x 6-7/8 x 18-1/14 Weight USA & Canadian models:35.9 lbs. Other models:17.3 kg REMOTE CONTROLLER Transmitter:Infrared S
15、ignal range:Approx. 16 ft., 5 meters Power supply:Two “AA” batteries (1.5 V x 2) Specifications and features are subject to change without notice. RadioFans.CN 收音机爱 好者资料库 TX-SR800 SERVICE PROCEDURES 1. Replacing the fuses This symbol located near the fuses indicates that the fuse used is fast operat
16、ing type. For continued protection against fire hazard, replace with same type fuse. For fuse rating refer to the marking adjacent to the symbol. Ce symbole indique que le fusible utlise est a rapide. Pour une protection permanente, nuntiliser que fusibles de meme type. Ce darnier est la qu le prese
17、nt symbol est appse. CIRCUIT NO. PART NO. DESCRIPTION 2. To initialize the unit This device employs a microprocessor to perform various functions and operations. If interference generated by an external power supply, radio wave, or other electrical source results in accident which causes the specifi
18、ed operations and functions to operate abnormally. To perform a result, please follow the procedure below. 1.Press the STANDBY ON button to turn on the unit. 2.Press and hold down the VIDEO 1 button, then press the STANDBY/ON button. 3.After CLEAR is displayed, the preset memory and each mode stored
19、 in the memory, such as surround, are initialized and will return to the factory setting. 4.Unplug the power supply cord. 3. Safety-check out (Only U.S.A. model) After correcting the original service problem, perform the following safety check before releasing the set to the customer. Connect the in
20、sulating-resistance tester between the plug of power supply cord and screw on the back panel. Specifications: 3.3Mohm+/-10% at 500V. 4. Memory Preservation This unit does not require memory preservation batteries. A built-in memory power back-up system preserves the contents of the memory during pow
21、er failures and even when the unit is unplugged. The unit must be plugged in order to charge the back-up system. The memory preservation period after the unit has been unplugged varies depending on climate and placement of the unit. On the average, memory contents are protected over a period of a fe
22、w weeks after the last time the unit has been unplugged. This period is shorter when the unit is exposed to a highly humid climate. Advanced Menu 0.Hardware Setup 0-4.AM Frequency Step a.Frequency Step :9 kHz 6. AM Frequency Step Sub-menu (Worldwide model Only) a. Frequency Step This sub-menu only a
23、ppears on the worldwide model. The setting in this sub-menu determines the increment amount or decrement amount when adjusting the AM tuner frequency. The initial setting is9 kHz, and this needs only to be changed if you are using the TX-SR800 in a 10-kHz region. 5.Setting the voltage selector (Worl
24、dwide models only) Worldwide models are equipped with a voltage selector so that you supplies. Be can set your TX-SR800 to conform with local power sure to set this switch to match the voltage of your area before plugging in the unit. Determine the proper voltage for your area: 220-230 V or the pres
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Onkyo-TXSR800-avr-sm 电路图 维修手册 Onkyo TXSR800 avr sm 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


